blob: c5f7040058f4a38d7b2a7ee99e627866e53f7aa9 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
213
214
215
216
217
218
219
220
221
222
223
224
225
226
227
228
229
230
231
232
233
234
|
chip soc/intel/tigerlake
# CPU
# Enable Enhanced Intel SpeedStep
register "eist_enable" = "1"
# Graphics
# Not used but timings left for reference
# register "panel_cfg" = "{
# .up_delay_ms = 2000, // T3
# .backlight_on_delay_ms = 0, // T7
# .backlight_off_delay_ms = 2000, // T9
# .down_delay_ms = 500, // T10
# .cycle_delay_ms = 500, // T12
# .backlight_pwm_hz = 200, // PWM
# }"
# FSP Memory
register "CnviBtCore" = "true"
register "CnviBtAudioOffload" = "1"
register "enable_c6dram" = "1"
register "SaGv" = "SaGv_Enabled"
register "TcssD3ColdDisable" = "1"
# FSP Silicon
# Serial I/O
register "SerialIoI2cMode" = "{
[PchSerialIoIndexI2C0] = PchSerialIoPci,
[PchSerialIoIndexI2C4] = PchSerialIoSkipInit,
}"
register "SerialIoUartMode" = "{
[PchSerialIoIndexUART2] = PchSerialIoSkipInit,
}"
# Power
register "PchPmSlpS3MinAssert" = "2" # 50ms
register "PchPmSlpS4MinAssert" = "3" # 1s
register "PchPmSlpSusMinAssert" = "3" # 500ms
register "PchPmSlpAMinAssert" = "3" # 2s
# PM Util
# GPE configuration
# Note that GPE events called out in ASL code rely on this
# route. i.e. If this route changes then the affected GPE
# offset bits also need to be changed.
# sudo devmem2 0xfe001920 (pmc_bar + GPIO_GPE_CFG)
register "pmc_gpe0_dw0" = "GPP_B"
register "pmc_gpe0_dw1" = "GPP_C"
register "pmc_gpe0_dw2" = "GPP_E"
# Enable the correct decode ranges on the LPC bus.
register "lpc_ioe" = "LPC_IOE_EC_4E_4F |
LPC_IOE_SUPERIO_2E_2F |
LPC_IOE_KBC_60_64 |
LPC_IOE_EC_62_66 |
LPC_IOE_LGE_200"
# PCIe Clock
register "PcieClkSrcClkReq[0]" = "PCIE_CLK_NOTUSED"
register "PcieClkSrcClkReq[1]" = "PCIE_CLK_NOTUSED"
register "PcieClkSrcClkReq[2]" = "PCIE_CLK_NOTUSED"
register "PcieClkSrcClkReq[4]" = "PCIE_CLK_NOTUSED"
register "PcieClkSrcClkReq[5]" = "PCIE_CLK_NOTUSED"
register "PcieClkSrcClkReq[6]" = "PCIE_CLK_NOTUSED"
# Actual device tree.
device cpu_cluster 0 on
device lapic 0 on end
end
device domain 0 on
device pci 00.0 on end # Host Bridge
device pci 02.0 on end # Integrated Graphics Device
device pci 04.0 on end # SA Thermal Device
device pci 05.0 off end # IPU
device pci 06.0 off end # PEG60
device pci 07.0 on end # TBT_PCIe0
device pci 07.1 off end # TBT_PCIe1
device pci 07.2 off end # TBT_PCIe2
device pci 07.3 off end # TBT_PCIe3
device pci 08.0 on end # Gaussian Mixture Model
device pci 09.0 off end # NPK
device pci 0a.0 off end # Crash-log SRAM
device pci 0d.0 on # USB xHCI
register "UsbTcPortEn" = "1"
register "TcssXhciEn" = "1"
register "TcssAuxOri" = "0"
end
device pci 0d.1 off end # USB xDCI (OTG)
device pci 0d.2 on # TBT DMA0
chip drivers/intel/usb4/retimer
register "dfp[0].power_gpio" = "ACPI_GPIO_OUTPUT_ACTIVE_HIGH(GPP_A23)"
use tcss_usb3_port1 as dfp[0].typec_port
device generic 0 on end
end
end
device pci 0d.3 off end # TBT
device pci 0e.0 off end # VMD
device pci 10.6 off end
device pci 10.7 off end
device pci 12.0 off end # Thermal Subsystem
device pci 12.6 off end # GSPI #2
device pci 14.0 on # USB xHCI
# Motherboard USB Type C
register "usb2_ports[0]" = "USB2_PORT_TYPE_C(OC_SKIP)"
register "tcss_ports[0]" = "TCSS_PORT_DEFAULT(OC_SKIP)"
# Motherboard USB 3.0
register "usb2_ports[1]" = "USB2_PORT_MID(OC_SKIP)"
register "usb3_ports[0]" = "USB3_PORT_DEFAULT(OC_SKIP)"
# Daughterboard USB 3.0
register "usb2_ports[2]" = "USB2_PORT_MID(OC_SKIP)"
register "usb3_ports[1]" = "USB3_PORT_DEFAULT(OC_SKIP)"
# Daughterboard SD Card
register "usb2_ports[5]" = "USB2_PORT_MID(OC_SKIP)"
# Webcam
register "usb2_ports[CONFIG_CCD_PORT]" = "USB2_PORT_MID(OC_SKIP)"
# Internal Bluetooth
register "usb2_ports[9]" = "USB2_PORT_MID(OC_SKIP)"
end
device pci 14.1 off end # USB xDCI (OTG)
device pci 14.2 on end # USB xDCI (OTG)
device pci 14.3 on # CNVi
chip drivers/wifi/generic
register "wake" = "GPE0_PME_B0"
device generic 0 on end
end
end
device pci 15.0 on # I2C0
chip drivers/i2c/hid
register "generic.hid" = ""STAR0001""
register "generic.desc" = ""Touchpad""
register "generic.irq" = "ACPI_IRQ_LEVEL_LOW(GPP_C8_IRQ)"
register "generic.probed" = "1"
register "hid_desc_reg_offset" = "0x20"
device i2c 2c on end
end
end
device pci 15.1 off end # I2C1
device pci 15.2 off end # I2C2
device pci 15.3 off end # I2C3
device pci 16.0 on end # Management Engine Interface 1
device pci 16.1 off end # Management Engine Interface 2
device pci 16.2 off end # Management Engine IDE-R
device pci 16.3 off end # Management Engine KT Redirection
device pci 16.4 off end # Management Engine Interface 3
device pci 16.5 off end # Management Engine Interface 4
device pci 17.0 on # SATA
register "SataSalpSupport" = "1"
# Port 1
register "SataPortsEnable[1]" = "1"
register "SataPortsDevSlp[1]" = "1"
end
device pci 19.0 on end # I2C4
device pci 19.1 off end # I2C5
device pci 19.2 on end # UART #2
device pci 1c.0 off end # PCI Express Port 1
device pci 1c.1 off end # PCI Express Port 2
device pci 1c.2 off end # PCI Express Port 3
device pci 1c.3 off end # PCI Express Port 4
device pci 1c.4 off end # PCI Express Port 5
device pci 1c.5 off end # PCI Express Port 6
device pci 1c.6 off end # PCI Express Port 7
device pci 1c.7 off end # PCI Express Port 8
device pci 1d.0 on # PCI Express Port 9 (SSD x4)
register "HybridStorageMode" = "0"
register "PcieRpEnable[8]" = "1"
register "PcieRpLtrEnable[8]" = "1"
register "PcieClkSrcUsage[3]" = "0x08"
register "PcieClkSrcClkReq[3]" = "3"
register "PcieRpSlotImplemented[8]" = "1"
smbios_slot_desc "SlotTypeM2Socket3" "SlotLengthOther" "M.2/M 2280" "SlotDataBusWidth4X"
chip soc/intel/common/block/pcie/rtd3
register "enable_gpio" = "ACPI_GPIO_OUTPUT_ACTIVE_HIGH(GPP_D16)"
register "reset_gpio" = "ACPI_GPIO_OUTPUT_ACTIVE_LOW(GPP_A11)"
register "srcclk_pin" = "3"
device generic 0 on end
end
end
device pci 1d.1 off end # PCI Express Port 10
device pci 1d.2 off end # PCI Express Port 11
device pci 1d.3 off end # PCI Express Port 12
device pci 1e.0 off end # UART #0
device pci 1e.1 off end # UART #1
device pci 1e.2 off end # GSPI #0
device pci 1e.3 on end # GSPI #1
device pci 1f.0 on # LPC Interface
register "gen1_dec" = "0x000c1641"
register "gen2_dec" = "0x000c0681"
register "gen3_dec" = "0x000c0081"
chip drivers/pc80/tpm
device pnp 0c31.0 on end
end
chip ec/starlabs/merlin
# Port pair 4Eh/4Fh
device pnp 4e.00 on end # IO Interface
device pnp 4e.01 off end # Com 1
device pnp 4e.02 off end # Com 2
device pnp 4e.04 off end # System Wake-Up
device pnp 4e.05 off end # PS/2 Mouse
device pnp 4e.06 on # PS/2 Keyboard
io 0x60 = 0x0060
io 0x62 = 0x0064
irq 0x70 = 1
end
device pnp 4e.0a off end # Consumer IR
device pnp 4e.0f off end # Shared Memory/Flash Interface
device pnp 4e.10 off end # RTC-like Timer
device pnp 4e.11 off end # Power Management Channel 1
device pnp 4e.12 off end # Power Management Channel 2
device pnp 4e.13 off end # Serial Peripheral Interface
device pnp 4e.14 off end # Platform EC Interface
device pnp 4e.17 off end # Power Management Channel 3
device pnp 4e.18 off end # Power Management Channel 4
device pnp 4e.19 off end # Power Management Channel 5
end
end
device pci 1f.1 off end # P2SB
device pci 1f.2 hidden end # Power Management Controller
device pci 1f.3 on # Intel HDA
register "PchHdaAudioLinkHdaEnable" = "1"
end
device pci 1f.4 on end # SMBus
device pci 1f.5 on end # PCH SPI
device pci 1f.6 off end # GbE
device pci 1f.7 off end # TH
end
end
|
