summaryrefslogtreecommitdiff
path: root/src/mainboard/siemens/mc_apl1/variants
AgeCommit message (Expand)Author
2022-03-07src: Make PCI ID define names shorterFelix Singer
2022-02-22mb/siemens/mc_apl2: Enable PCI device for I2C bus 0Werner Zeh
2022-02-12mb/siemens/mc_apl{2,4,5,6}: Enable recovery MRC cacheWerner Zeh
2022-02-01mb/siemens/{mc_apl1,...,mc_apl6}: Disable SATA ALPM supportMario Scheithauer
2021-07-26mb/*: Specify type of `FMDFILE` onceAngel Pons
2021-07-23mb/siemens/mc_apl{1,2,3,5,6}: Use PCI_ALLOW_BUS_MASTER_ANY_DEVICEWerner Zeh
2021-07-21mb/siemens/mc_apl{1,2,3,5,6}: Set PCI bus master bit only if allowedWerner Zeh
2021-06-04mb/siemens/mc_apl2: Disable unused I2C controllersWerner Zeh
2021-06-04mb/siemens/mc_apl{1,2,3,5,6}: Provide I2C timings for 400 kHzWerner Zeh
2021-05-30mb/siemens/mc_apl{1,2,3,5,6}: Disable ACPI-support for RX6110Werner Zeh
2021-05-30mb/siemens/mc_apl1: Move gpio.c from baseboard to mc_apl1Mario Scheithauer
2021-05-30mb/siemens/{mc_apl2,...,mc_apl6}: Do early UART pad configurationMario Scheithauer
2021-05-02mb/siemens/mc_apl{1,2,3,5,6}: Tune I2C frequencyWerner Zeh
2021-02-16mb/siemens/mc_apl1/variants/mc_apl2/mainboard.c: Clean includesElyes HAOUAS
2021-02-15src/mb: Remove unused <console/console.h>Elyes HAOUAS
2021-02-10mb/siemens/mc_apl2: Switch I2C bus for RX6110SAMario Scheithauer
2021-02-02mb/siemens/mc_apl1: do UART pad configuration at board-levelMichael Niewöhner
2021-01-20mb/siemens/{mc_apl1,...,mc_apl6}: Configure FSP-S UPDsMario Scheithauer
2021-01-15mb/siemens/mc_apl1: do LPC/eSPI pad configuration at board-levelMichael Niewöhner
2020-11-30mb/siemens/mc_apl1: Deduplicate wait_for_legacy_dev()Angel Pons
2020-11-23mb/siemens/mc_apl1: Use `pci_or_config16` functionAngel Pons
2020-10-05mb/siemens/mc_apl6: Enable eMMCMario Scheithauer
2020-09-19apollolake boards: Enable CSE in devicetreeSubrata Banik
2020-09-10mb/siemens/mc_apl2/gpio: Fix code styleMaxim Polyakov
2020-09-10mb/siemens/mc_apl2/gpio: Undo set DRIVER for GPOMaxim Polyakov
2020-06-30src: Remove whitespaces before tabsElyes HAOUAS
2020-06-19Kconfig: Escape variable to accommodate new Kconfig versionsPatrick Georgi
2020-05-11treewide: Remove "this file is part of" linesPatrick Georgi
2020-04-04mainboard/siemens: Use SPDX for GPL-2.0-only filesAngel Pons
2020-03-31security/vboot: Decouple measured boot from verified bootBill XIE
2020-03-18mainboard/[^a-p]*: Remove copyright noticesPatrick Georgi
2019-11-12src/mainboard/siemens: Use PTN3460 chip driverUwe Poeche
2019-11-12mb/siemens/mc_apl6: Enable VT-d featureWerner Zeh
2019-11-11mb/siemens/mc_apl6: Add TPM to devicetreeWerner Zeh
2019-11-11mb/siemens/mc_apl6: Enable SDHCI and disable eMMC controllerWerner Zeh
2019-11-11mb/siemens/mc_apl6: Adjust clock lines used on PCIe-2-PCI bridgeWerner Zeh
2019-11-11mb/siemens/mc_apl6: Enable VBOOT per defaultWerner Zeh
2019-11-11mb/siemens/mc_apl6: Add new mainboard based on mc_apl3Werner Zeh
2019-10-18mb/siemens/mc_apl{3,5}: Remove __weak symbol from GPIO functionsWerner Zeh
2019-09-25mb/siemens/mc_apl{2,4,5}: Enable VBOOTWerner Zeh
2019-09-05mb/siemens/mc_apl5: Disable IGD if no EDID data availableMario Scheithauer
2019-07-18mb/siemens/{mc_apl1,...,mc_apl5}: Fix GPIO settingsMario Scheithauer
2019-07-18mb/siemens/mc_apl1: Disable all UHS-I SD-Card speed modesMario Scheithauer
2019-07-12mb/siemens/mc_apl3: Enable LPSS UART 1Mario Scheithauer
2019-07-11mb/siemens/{baseboard,mc_apl3,mc_apl4,mc_apl5}: Fix GPIO_168Mario Scheithauer
2019-07-11mb/siemens/{mc_apl1,...,mc_apl5}: Reduce eMMC bus speed modeMario Scheithauer
2019-06-21siemens/mc_apl5: Change PTN interface settingsMario Scheithauer
2019-06-21siemens/mc_apl5: Enable TPM supportMario Scheithauer
2019-06-06siemens/mc_apl5: Add own GPIO tableMario Scheithauer
2019-05-29src/mainboard: Add missing 'include <types.h>'Elyes HAOUAS
2019-05-06mb/siemens/mc_apl2: Limit SD-Card speed to DDR50Werner Zeh
2019-04-15mb/siemens/mc_apl4: Remove usage of external RTCWerner Zeh
2019-04-15mb/siemens/mc_apl1: Enable HDA in devicetree for all mainboard variantsWerner Zeh
2019-04-08siemens/mc_apl5: Remove reduced clock rate for I2C0Mario Scheithauer
2019-04-04siemens/mc_apl4: Provide CLK on APL Pin PMU_SUSCLKUwe Poeche
2019-03-15mb/mc_apl1/variants/mc_apl5: Drop unused '#include <lib.h>'Elyes HAOUAS
2019-03-06mb/siemens/{mc_apl1,mc_tcu3}: Fix typo on "Display"Elyes HAOUAS
2019-03-04arch/io.h: Add missing includesKyösti Mälkki
2019-02-13siemens/mc_apl4: Enable HW SPI TPM on mainboard mc_apl4Uwe Poeche
2019-02-13siemens/mc_apl2: Remove double entry from devicetreeMario Scheithauer
2019-02-05mb/siemens/mc_apl1: Enable VTD for mc_apl2 and mc_apl5Werner Zeh
2019-01-30siemens/mc_apl2: Change SERIRQ modeMario Scheithauer
2019-01-30siemens/mc_apl2: Correct whitespace of devicetreeMario Scheithauer
2019-01-30siemens/mc_apl2: Activate TPM supportMario Scheithauer
2019-01-16siemens/mc_apl4: Change UART_FOR_CONSOLE indexMario Scheithauer
2018-12-17siemens/mc_apl4: Enable RTC RX6110SA on this mainboardUwe Poeche
2018-12-17siemens/mc_apl4: Enable LVDS Display on mc_apl4Uwe Poeche
2018-12-17siemens/mc_apl4: Add GPIO configurationUwe Poeche
2018-11-29siemens/mc_apl5: Disable PCI clock outputs on XIO bridgesMario Scheithauer
2018-11-29siemens/mc_apl5: Set bus master bit for on-board PCI deviceMario Scheithauer
2018-11-29siemens/mc_apl5: Enable SDCARDMario Scheithauer
2018-11-27siemens/mc_apl5: Adjust the settings for the PCIe root portsMario Scheithauer
2018-11-26siemens/mc_apl1/variants/mc_apl*: Remove unneeded PTN readMario Scheithauer
2018-11-23siemens/mc_apl4: Set CPU clock to minimum ratioWerner Zeh
2018-11-18siemens/mc_apl5: Add new mainboard variant mc_apl5Mario Scheithauer
2018-11-16mb/siemens/mc_apl1/variants/mc_apl*: Remove unused BOARD_SIEMENS_MC_APL*_VARElyes HAOUAS
2018-11-16src: Remove unneeded include <lib.h>Elyes HAOUAS
2018-11-16mb/*/*/Kconfig: Use CONFIG_VARIANT_DIR for devicetreePeter Lemenkov
2018-11-16siemens/mc_apl4: Clean up ramstageMario Scheithauer
2018-11-16siemens/mc_apl4: Overwrite swizzle data for LPDDR4Mario Scheithauer
2018-11-12siemens/mc_apl4: Enable SDCARDMario Scheithauer
2018-11-12siemens/mc_apl4: Remove external RTC from I2C0Mario Scheithauer
2018-11-12siemens/mc_apl4: Enable all PCIe root portsMario Scheithauer
2018-11-12siemens/mc_apl4: Remove reduced clock rate for I2C0Mario Scheithauer
2018-11-12siemens/mc_apl4: Disable CLKREQ of PCIe root portsMario Scheithauer
2018-11-12siemens/mc_apl3: Disable PCI clock outputs on XIO bridgesMario Scheithauer
2018-11-12siemens/mc_apl3: Set Full Reset Bit into Reset Control RegisterMario Scheithauer
2018-11-12siemens/mc_apl3: Set bus master bit for on-board PCI deviceMario Scheithauer
2018-11-12siemens/mc_apl3: Remove the correction of the Tx signal for SATAMario Scheithauer
2018-11-12siemens/mc_apl3: Adjust Legacy IRQ routing for PCI devicesMario Scheithauer
2018-11-07siemens/mc_apl4: Add new mainboard variant mc_apl4Mario Scheithauer
2018-11-07siemens/mc_apl2: Adjust GPIO settings for mc_apl2Mario Scheithauer
2018-11-07siemens/mc_apl3: Disable I2C7 over devicetreeMario Scheithauer
2018-11-07siemens/mc_apl3: Enable all PCIe root portsMario Scheithauer
2018-11-07siemens/mc_apl3: Remove reduced clock rate for I2C0Mario Scheithauer
2018-11-07siemens/mc_apl3: Disable CLKREQ of PCIe root portsMario Scheithauer
2018-11-07siemens/mc_apl3: Adjust GPIO settings for mc_apl3Mario Scheithauer
2018-10-30siemens/mc_apl3: Add new mainboard variant mc_apl3Mario Scheithauer
2018-10-08Move compiler.h to commonlibNico Huber
2018-10-06soc/intel/common, mb/google, mb/siemens: Use lower case x for RXDFurquan Shaikh
generated by cgit v1.2.3 (git 2.25.1) at 2024-12-26 07:07:16 +0000