blob: 4701056bfafb9e5265e2b91a0dd4d42e301e7ec2 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
|
# SPDX-License-Identifier: GPL-2.0-only
# Generic ITE romstage driver - Just enough UART initialisation code for
# romstage.
config SUPERIO_ITE_COMMON_PRE_RAM
bool
# Generic ITE environment controller driver
config SUPERIO_ITE_ENV_CTRL
bool
if SUPERIO_ITE_ENV_CTRL
config SUPERIO_ITE_ENV_CTRL_FAN16_CONFIG
bool
help
Enable extended, 16-bit wide tacho counters.
config SUPERIO_ITE_ENV_CTRL_8BIT_PWM
bool
help
PWM duty cycles are set in 8-bit registers (instead of 7 bit).
config SUPERIO_ITE_ENV_CTRL_PWM_FREQ2
bool
help
The second FAN controller has a separate frequency setting.
config SUPERIO_ITE_ENV_CTRL_NO_ONOFF
bool
help
FAN controller always works in SmartGuardian mode.
config SUPERIO_ITE_ENV_CTRL_5FANS
bool
help
ITE FAN controller has 5 independent outputs.
config SUPERIO_ITE_ENV_CTRL_7BIT_SLOPE_REG
bool
help
Slope PWM registers have no separate BIT6 and are set directly by
7-bit values instead.
config SUPERIO_ITE_ENV_CTRL_EXT_ANY_TMPIN
bool
help
Temperature can be read to any TMPIN from an external sensor via SST/PECI
(instead of TMPIN3 only).
config SUPERIO_ITE_ENV_CTRL_NO_FULLSPEED_SETTING
bool
help
Fan controller does not support running at full speed when limit
temperature is reached.
config SUPERIO_ITE_ENV_CTRL_FAN_VECTOR
bool
help
Special fan control that will assist the smart control
config SUPERIO_ITE_ENV_CTRL_FAN_VECTOR_RANGED
bool
depends on SUPERIO_ITE_ENV_CTRL_FAN_VECTOR
help
Range and negative slope support
endif
|
