1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
|
#include <console/console.h>
/*
* Enable the serial evices on the VIA
*/
/* The base address is 0x15c, 0x2e, depending on config bytes */
#define SIO_BASE 0x3f0
#define SIO_DATA SIO_BASE+1
static void vt8231_writesuper(uint8_t reg, uint8_t val)
{
outb(reg, SIO_BASE);
outb(val, SIO_DATA);
}
static void vt8231_writesiobyte(uint16_t reg, uint8_t val)
{
outb(val, reg);
}
static void vt8231_writesioword(uint16_t reg, uint16_t val)
{
outw(val, reg);
}
/* regs we use: 85, and the southbridge devfn is defined by the
mainboard
*/
static void enable_vt8231_serial(void)
{
uint8_t c;
device_t dev;
post_code(0x06);
dev = pci_locate_device(PCI_ID(0x1106,0x8231), 0);
if (dev == PCI_DEV_INVALID) {
post_code(0x07);
die("Serial controller not found\n");
}
/* first, you have to enable the superio and superio config.
put a 6 reg 80
*/
c = pci_read_config8(dev, 0x50);
c |= 6;
pci_write_config8(dev, 0x50, c);
post_code(0x02);
// now go ahead and set up com1.
// set address
vt8231_writesuper(0xf4, 0xfe);
// enable serial out
vt8231_writesuper(0xf2, 7);
// That's it for the sio stuff.
// movl $SUPERIOCONFIG, %eax
// movb $9, %dl
// PCI_WRITE_CONFIG_BYTE
// set up reg to set baud rate.
vt8231_writesiobyte(0x3fb, 0x80);
// Set 115 kb
vt8231_writesioword(0x3f8, 1);
// Set 9.6 kb
// WRITESIOWORD(0x3f8, 12)
// now set no parity, one stop, 8 bits
vt8231_writesiobyte(0x3fb, 3);
// now turn on RTS, DRT
vt8231_writesiobyte(0x3fc, 3);
// Enable interrupts
vt8231_writesiobyte(0x3f9, 0xf);
// should be done. Dump a char for fun.
vt8231_writesiobyte(0x3f8, 48);
}
|
