1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
|
/*
* This file is part of the coreboot project.
*
* Copyright (C) 2011 Samsung Electronics
* Copyright 2013 Google Inc.
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License as published by
* the Free Software Foundation; version 2 of the License.
*
* This program is distributed in the hope that it will be useful,
* but WITHOUT ANY WARRANTY; without even the implied warranty of
* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
* GNU General Public License for more details.
*/
#include <arch/io.h>
#include <assert.h>
#include <boot_device.h>
#include <console/console.h>
#include <soc/clk.h>
#include <soc/gpio.h>
#include <soc/spi.h>
#include <stdlib.h>
#include <symbols.h>
#if defined(CONFIG_DEBUG_SPI) && CONFIG_DEBUG_SPI
# define DEBUG_SPI(x,...) printk(BIOS_DEBUG, "EXYNOS_SPI: " x)
#else
# define DEBUG_SPI(x,...)
#endif
static void exynos_spi_rx_tx(struct exynos_spi *regs, int todo,
void *dinp, void const *doutp, int i)
{
int rx_lvl, tx_lvl;
unsigned int *rxp = (unsigned int *)(dinp + (i * (32 * 1024)));
unsigned int out_bytes, in_bytes;
// TODO In current implementation, every read/write must be aligned to
// 4 bytes, otherwise you may get timeout or other unexpected results.
ASSERT(todo % 4 == 0);
out_bytes = in_bytes = todo;
setbits_le32(®s->ch_cfg, SPI_CH_RST);
clrbits_le32(®s->ch_cfg, SPI_CH_RST);
write32(®s->pkt_cnt, ((todo * 8) / 32) | SPI_PACKET_CNT_EN);
while (in_bytes) {
uint32_t spi_sts;
int temp;
spi_sts = read32(®s->spi_sts);
rx_lvl = ((spi_sts >> 15) & 0x7f);
tx_lvl = ((spi_sts >> 6) & 0x7f);
while (tx_lvl < 32 && out_bytes) {
// TODO The "writing" (tx) is not supported now; that's
// why we write garbage to keep driving FIFO clock.
temp = 0xffffffff;
write32(®s->tx_data, temp);
out_bytes -= 4;
tx_lvl += 4;
}
while (rx_lvl >= 4 && in_bytes) {
temp = read32(®s->rx_data);
if (rxp)
*rxp++ = temp;
in_bytes -= 4;
rx_lvl -= 4;
}
}
}
/* set up SPI channel */
int exynos_spi_open(struct exynos_spi *regs)
{
/* set the spi1 GPIO */
/* set pktcnt and enable it */
write32(®s->pkt_cnt, 4 | SPI_PACKET_CNT_EN);
/* set FB_CLK_SEL */
write32(®s->fb_clk, SPI_FB_DELAY_180);
/* set CH_WIDTH and BUS_WIDTH as word */
setbits_le32(®s->mode_cfg,
SPI_MODE_CH_WIDTH_WORD | SPI_MODE_BUS_WIDTH_WORD);
clrbits_le32(®s->ch_cfg, SPI_CH_CPOL_L); /* CPOL: active high */
/* clear rx and tx channel if set previously */
clrbits_le32(®s->ch_cfg, SPI_RX_CH_ON | SPI_TX_CH_ON);
setbits_le32(®s->swap_cfg,
SPI_RX_SWAP_EN | SPI_RX_BYTE_SWAP | SPI_RX_HWORD_SWAP);
/* do a soft reset */
setbits_le32(®s->ch_cfg, SPI_CH_RST);
clrbits_le32(®s->ch_cfg, SPI_CH_RST);
/* now set rx and tx channel ON */
setbits_le32(®s->ch_cfg, SPI_RX_CH_ON | SPI_TX_CH_ON | SPI_CH_HS_EN);
return 0;
}
int exynos_spi_read(struct exynos_spi *regs, void *dest, u32 len, u32 off)
{
int upto, todo;
int i;
clrbits_le32(®s->cs_reg, SPI_SLAVE_SIG_INACT); /* CS low */
/* Send read instruction (0x3h) followed by a 24 bit addr */
write32(®s->tx_data, (SF_READ_DATA_CMD << 24) | off);
/* waiting for TX done */
while (!(read32(®s->spi_sts) & SPI_ST_TX_DONE));
for (upto = 0, i = 0; upto < len; upto += todo, i++) {
todo = MIN(len - upto, (1 << 15));
exynos_spi_rx_tx(regs, todo, dest, (void *)(off), i);
}
setbits_le32(®s->cs_reg, SPI_SLAVE_SIG_INACT);/* make the CS high */
return len;
}
int exynos_spi_close(struct exynos_spi *regs)
{
/*
* Let put controller mode to BYTE as
* SPI driver does not support WORD mode yet
*/
clrbits_le32(®s->mode_cfg,
SPI_MODE_CH_WIDTH_WORD | SPI_MODE_BUS_WIDTH_WORD);
write32(®s->swap_cfg, 0);
/*
* Flush spi tx, rx fifos and reset the SPI controller
* and clear rx/tx channel
*/
clrsetbits_le32(®s->ch_cfg, SPI_CH_HS_EN, SPI_CH_RST);
clrbits_le32(®s->ch_cfg, SPI_CH_RST);
clrbits_le32(®s->ch_cfg, SPI_TX_CH_ON | SPI_RX_CH_ON);
return 0;
}
static struct exynos_spi *boot_slave_regs;
static ssize_t exynos_spi_readat(const struct region_device *rdev, void *dest,
size_t offset, size_t count)
{
int bytes;
DEBUG_SPI("exynos_spi_cbfs_read(%u)\n", count);
exynos_spi_open(boot_slave_regs);
bytes = exynos_spi_read(boot_slave_regs, dest, count, offset);
exynos_spi_close(boot_slave_regs);
return bytes;
}
static void *exynos_spi_map(const struct region_device *rdev,
size_t offset, size_t count)
{
DEBUG_SPI("exynos_spi_cbfs_map\n");
// exynos: spi_rx_tx may work in 4 byte-width-transmission mode and
// requires buffer memory address to be aligned.
if (count % 4)
count += 4 - (count % 4);
return mmap_helper_rdev_mmap(rdev, offset, count);
}
static const struct region_device_ops exynos_spi_ops = {
.mmap = exynos_spi_map,
.munmap = mmap_helper_rdev_munmap,
.readat = exynos_spi_readat,
};
static struct mmap_helper_region_device mdev =
MMAP_HELPER_REGION_INIT(&exynos_spi_ops, 0, CONFIG_ROM_SIZE);
void exynos_init_spi_boot_device(void)
{
boot_slave_regs = (void *)EXYNOS5_SPI1_BASE;
mmap_helper_device_init(&mdev, _cbfs_cache, _cbfs_cache_size);
}
const struct region_device *exynos_spi_boot_device(void)
{
return &mdev.rdev;
}
|
