1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
|
/* SPDX-License-Identifier: GPL-2.0-only */
#include <assert.h>
#include <console/console.h>
#include <device/i2c_simple.h>
#include <gpio.h>
#include <lib.h>
#include <soc/clock.h>
#include <soc/qcom_qup_se.h>
#include <soc/qup_se_handlers_common.h>
#include <soc/qupv3_config_common.h>
#include <soc/qupv3_i2c_common.h>
#include <stdint.h>
static void i2c_clk_configure(unsigned int bus, enum i2c_speed speed)
{
int clk_div = 0, t_high = 0, t_low = 0, t_cycle = 0;
struct qup_regs *regs = qup[bus].regs;
switch (speed) {
case I2C_SPEED_STANDARD:
clk_div = 7;
t_high = 10;
t_low = 11;
t_cycle = 26;
break;
case I2C_SPEED_FAST:
clk_div = 2;
t_high = 5;
t_low = 12;
t_cycle = 24;
break;
case I2C_SPEED_FAST_PLUS:
clk_div = 1;
t_high = 3;
t_low = 9;
t_cycle = 18;
break;
default:
die("Unsupported I2C speed");
}
write32(®s->geni_ser_m_clk_cfg, (clk_div << 4) | 1);
/* Serial clock frequency is 19.2 MHz */
write32(®s->i2c_scl_counters, ((t_high << 20) | (t_low << 10)
| t_cycle));
}
void i2c_init(unsigned int bus, enum i2c_speed speed)
{
uint32_t proto;
struct qup_regs *regs = qup[bus].regs;
qupv3_se_fw_load_and_init(bus, SE_PROTOCOL_I2C, MIXED);
clock_enable_qup(bus);
i2c_clk_configure(bus, speed);
proto = ((read32(®s->geni_fw_revision_ro) &
GENI_FW_REVISION_RO_PROTOCOL_MASK) >>
GENI_FW_REVISION_RO_PROTOCOL_SHIFT);
assert(proto == 3);
/* Serial engine IO initialization */
write32(®s->geni_cgc_ctrl, DEFAULT_CGC_EN);
write32(®s->dma_general_cfg,
(AHB_SEC_SLV_CLK_CGC_ON | DMA_AHB_SLV_CFG_ON
| DMA_TX_CLK_CGC_ON | DMA_RX_CLK_CGC_ON));
write32(®s->geni_output_ctrl,
DEFAULT_IO_OUTPUT_CTRL_MSK);
write32(®s->geni_force_default_reg, FORCE_DEFAULT);
/* Serial engine IO set mode */
write32(®s->se_irq_en, (GENI_M_IRQ_EN |
GENI_S_IRQ_EN | DMA_TX_IRQ_EN | DMA_RX_IRQ_EN));
write32(®s->se_gsi_event_en, 0);
/* Set RX and RFR watermark */
write32(®s->geni_rx_watermark_reg, 0);
write32(®s->geni_rx_rfr_watermark_reg, FIFO_DEPTH - 2);
/* FIFO PACKING CONFIGURATION */
write32(®s->geni_tx_packing_cfg0, PACK_VECTOR0
| (PACK_VECTOR1 << 10));
write32(®s->geni_tx_packing_cfg1, PACK_VECTOR2
| (PACK_VECTOR3 << 10));
write32(®s->geni_rx_packing_cfg0, PACK_VECTOR0
| (PACK_VECTOR1 << 10));
write32(®s->geni_rx_packing_cfg1, PACK_VECTOR2
| (PACK_VECTOR3 << 10));
write32(®s->geni_byte_granularity, (log2(BITS_PER_WORD) - 3));
/* GPIO Configuration */
gpio_configure(qup[bus].pin[0], qup[bus].func[0], GPIO_PULL_UP,
GPIO_2MA, GPIO_OUTPUT);
gpio_configure(qup[bus].pin[1], qup[bus].func[1], GPIO_PULL_UP,
GPIO_2MA, GPIO_OUTPUT);
/* Select and setup FIFO mode */
write32(®s->geni_m_irq_clear, 0xFFFFFFFF);
write32(®s->geni_s_irq_clear, 0xFFFFFFFF);
write32(®s->dma_tx_irq_clr, 0xFFFFFFFF);
write32(®s->dma_rx_irq_clr, 0xFFFFFFFF);
write32(®s->geni_m_irq_enable, (M_COMMON_GENI_M_IRQ_EN |
M_CMD_DONE_EN | M_TX_FIFO_WATERMARK_EN |
M_RX_FIFO_WATERMARK_EN | M_RX_FIFO_LAST_EN));
write32(®s->geni_s_irq_enable, (S_COMMON_GENI_S_IRQ_EN
| S_CMD_DONE_EN));
clrbits32(®s->geni_dma_mode_en, GENI_DMA_MODE_EN);
}
static int i2c_do_xfer(unsigned int bus, struct i2c_msg segment,
unsigned int prams)
{
unsigned int cmd = (segment.flags & I2C_M_RD) ? 2 : 1;
unsigned int master_cmd_reg_val = (cmd << M_OPCODE_SHFT);
struct qup_regs *regs = qup[bus].regs;
void *dout = NULL, *din = NULL;
struct stopwatch timeout;
if (!(segment.flags & I2C_M_RD)) {
write32(®s->i2c_tx_trans_len, segment.len);
write32(®s->geni_tx_watermark_reg, TX_WATERMARK);
dout = segment.buf;
} else {
write32(®s->i2c_rx_trans_len, segment.len);
din = segment.buf;
}
master_cmd_reg_val |= (prams & M_PARAMS_MSK);
write32(®s->geni_m_cmd0, master_cmd_reg_val);
stopwatch_init_usecs_expire(&timeout, CONFIG_I2C_TRANSFER_TIMEOUT_US);
return qup_handle_transfer(bus, dout, din, segment.len, &timeout);
}
int platform_i2c_transfer(unsigned int bus, struct i2c_msg *segments,
int seg_count)
{
struct i2c_msg *seg = segments;
int ret = 0;
while (!ret && seg_count--) {
/* Stretch means end with repeated start, not stop */
u32 stretch = (seg_count ? 1 : 0);
u32 m_param = 0;
m_param |= (stretch << 2);
m_param |= ((seg->slave & 0x7F) << 9);
ret = i2c_do_xfer(bus, *seg, m_param);
seg++;
}
return ret;
}
|
