1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
|
/*
* This file is part of the coreboot project.
*
* Copyright 2014 Rockchip Inc.
* Copyright 2014 Google Inc.
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License as published by
* the Free Software Foundation; version 2 of the License.
*
* This program is distributed in the hope that it will be useful,
* but WITHOUT ANY WARRANTY; without even the implied warranty of
* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
* GNU General Public License for more details.
*
* You should have received a copy of the GNU General Public License
* along with this program; if not, write to the Free Software
* Foundation, Inc., 51 Franklin St, Fifth Floor, Boston, MA 02110-1301 USA
*/
#include <arch/io.h>
#include <assert.h>
#include <bootblock_common.h>
#include <console/console.h>
#include <delay.h>
#include <reset.h>
#include <soc/clock.h>
#include <soc/i2c.h>
#include <soc/grf.h>
#include <soc/pmu.h>
#include <soc/rk808.h>
#include <soc/spi.h>
#include <vendorcode/google/chromeos/chromeos.h>
#include "board.h"
void bootblock_mainboard_early_init()
{
if (IS_ENABLED(CONFIG_CONSOLE_SERIAL_UART)) {
assert(CONFIG_CONSOLE_SERIAL_UART_ADDRESS == UART2_BASE);
writel(IOMUX_UART2, &rk3288_grf->iomux_uart2);
}
}
void bootblock_mainboard_init(void)
{
/* Up VDD_CPU (BUCK1) to 1.4V to support max CPU frequency (1.8GHz). */
setbits_le32(&rk3288_pmu->iomux_i2c0scl, IOMUX_I2C0SCL);
setbits_le32(&rk3288_pmu->iomux_i2c0sda, IOMUX_I2C0SDA);
assert(CONFIG_PMIC_BUS == 0); /* must correspond with IOMUX */
i2c_init(CONFIG_PMIC_BUS, 400*KHz);
/* Slowly raise to max CPU voltage to prevent overshoot */
rk808_configure_buck(1, 1200);
udelay(175);/* Must wait for voltage to stabilize,2mV/us */
rk808_configure_buck(1, 1400);
udelay(100);/* Must wait for voltage to stabilize,2mV/us */
rkclk_configure_cpu();
if (rkclk_was_watchdog_reset()) {
printk(BIOS_INFO, "Last reset was watchdog... rebooting via GPIO!\n");
hard_reset();
}
/* i2c1 for tpm */
writel(IOMUX_I2C1, &rk3288_grf->iomux_i2c1);
i2c_init(1, 400*KHz);
/* spi2 for firmware ROM */
writel(IOMUX_SPI2_CSCLK, &rk3288_grf->iomux_spi2csclk);
writel(IOMUX_SPI2_TXRX, &rk3288_grf->iomux_spi2txrx);
rockchip_spi_init(CONFIG_BOOT_MEDIA_SPI_BUS, 11*MHz);
setup_chromeos_gpios();
}
|
