1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
|
/* SPDX-License-Identifier: GPL-2.0-only */
#include <device/mmio.h>
#include <assert.h>
#include <bootblock_common.h>
#include <delay.h>
#include <soc/clock.h>
#include <soc/i2c.h>
#include <soc/grf.h>
#include <soc/pmu.h>
#include <soc/rk808.h>
#include <soc/spi.h>
#include <vendorcode/google/chromeos/chromeos.h>
#include "board.h"
void bootblock_mainboard_early_init()
{
if (CONFIG(CONSOLE_SERIAL)) {
assert(CONFIG_CONSOLE_SERIAL_UART_ADDRESS == UART2_BASE);
write32(&rk3288_grf->iomux_uart2, IOMUX_UART2);
}
}
void bootblock_mainboard_init(void)
{
if (rkclk_was_watchdog_reset())
reboot_from_watchdog();
gpio_output(GPIO(7, A, 0), 1); /* Power LED */
/* Up VDD_CPU (BUCK1) to 1.4V to support max CPU frequency (1.8GHz). */
setbits32(&rk3288_pmu->iomux_i2c0scl, IOMUX_I2C0SCL);
setbits32(&rk3288_pmu->iomux_i2c0sda, IOMUX_I2C0SDA);
assert(CONFIG_PMIC_BUS == 0); /* must correspond with IOMUX */
i2c_init(CONFIG_PMIC_BUS, 400*KHz);
/* Slowly raise to max CPU voltage to prevent overshoot */
rk808_configure_buck(1, 1200);
udelay(175);/* Must wait for voltage to stabilize,2mV/us */
rk808_configure_buck(1, 1400);
udelay(100);/* Must wait for voltage to stabilize,2mV/us */
rkclk_configure_cpu(APLL_1800_MHZ);
/* i2c1 for tpm */
write32(&rk3288_grf->iomux_i2c1, IOMUX_I2C1);
i2c_init(1, 400*KHz);
/* spi2 for firmware ROM */
write32(&rk3288_grf->iomux_spi2csclk, IOMUX_SPI2_CSCLK);
write32(&rk3288_grf->iomux_spi2txrx, IOMUX_SPI2_TXRX);
rockchip_spi_init(CONFIG_BOOT_DEVICE_SPI_FLASH_BUS, 24750*KHz);
setup_chromeos_gpios();
}
|
