1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
|
/* SPDX-License-Identifier: GPL-2.0-only */
#include <amdblocks/acpi.h>
#include <string.h>
#include <console/console.h>
#include <device/device.h>
#include <device/mmio.h>
#include <acpi/acpi.h>
#include <amdblocks/agesawrapper.h>
#include <amdblocks/amd_pci_util.h>
#include <amdblocks/i2c.h>
#include <baseboard/variants.h>
#include <boardid.h>
#include <gpio.h>
#include <smbios.h>
#include <soc/acpi.h>
#include <soc/pci_devs.h>
#include <soc/southbridge.h>
#include <amdblocks/acpimmio.h>
#include <variant/ec.h>
#include <variant/thermal.h>
/* The IRQ mapping in fch_irq_map ends up getting written to the indirect address space that is
accessed via I/O ports 0xc00/0xc01. */
static const struct fch_irq_routing fch_irq_map[] = {
{ PIRQ_A, 3, 16 },
{ PIRQ_B, 4, 17 },
{ PIRQ_C, 5, 18 },
{ PIRQ_D, 7, 19 },
{ PIRQ_E, 11, 20 },
{ PIRQ_F, PIRQ_NC, PIRQ_NC },
{ PIRQ_G, PIRQ_NC, 22 },
{ PIRQ_H, PIRQ_NC, 23 },
{ PIRQ_SCI, ACPI_SCI_IRQ, ACPI_SCI_IRQ },
{ PIRQ_SMBUS, PIRQ_NC, PIRQ_NC },
{ PIRQ_HDA, 3, 16 },
{ PIRQ_SD, 3, 16 },
{ PIRQ_SDIO, PIRQ_NC, PIRQ_NC },
{ PIRQ_EHCI, 5, 18 },
{ PIRQ_XHCI, 4, 18 },
{ PIRQ_SATA, 4, 19 },
{ PIRQ_GPIO, 7, 7 },
{ PIRQ_I2C0, 3, 3 },
{ PIRQ_I2C1, 15, 15 },
{ PIRQ_I2C2, 6, 6 },
{ PIRQ_I2C3, 14, 14 },
{ PIRQ_UART0, 10, 10 },
{ PIRQ_UART1, 11, 11 },
/* The MISC registers are not interrupt numbers */
{ PIRQ_MISC, 0xfa, 0x00 },
{ PIRQ_MISC0, 0xf1, 0x00 },
{ PIRQ_MISC1, 0x00, 0x00 },
{ PIRQ_MISC2, 0x00, 0x00 },
};
const struct fch_irq_routing *mb_get_fch_irq_mapping(size_t *length)
{
*length = ARRAY_SIZE(fch_irq_map);
return fch_irq_map;
}
/*
* This table defines the index into the picr/intr_data tables for each
* device. Any enabled device and slot that uses hardware interrupts should
* have an entry in this table to define its index into the FCH PCI_INTR
* register 0xC00/0xC01. This index will define the interrupt that it should
* use. Putting PIRQ_A into the PIN A index for a device will tell that
* device to use PIC IRQ 10 if it uses PIN A for its hardware INT.
*/
static const struct pirq_struct mainboard_pirq_data[] = {
{ PCIE0_DEVFN, { PIRQ_A, PIRQ_B, PIRQ_C, PIRQ_D } },
{ PCIE1_DEVFN, { PIRQ_B, PIRQ_C, PIRQ_D, PIRQ_A } },
{ PCIE2_DEVFN, { PIRQ_C, PIRQ_D, PIRQ_A, PIRQ_B } },
{ PCIE3_DEVFN, { PIRQ_D, PIRQ_A, PIRQ_B, PIRQ_C } },
{ PCIE4_DEVFN, { PIRQ_A, PIRQ_B, PIRQ_C, PIRQ_D } },
{ HDA0_DEVFN, { PIRQ_NC, PIRQ_HDA, PIRQ_NC, PIRQ_NC } },
{ SD_DEVFN, { PIRQ_SD, PIRQ_NC, PIRQ_NC, PIRQ_NC } },
{ SMBUS_DEVFN, { PIRQ_SMBUS, PIRQ_NC, PIRQ_NC, PIRQ_NC } },
{ SATA_DEVFN, { PIRQ_SATA, PIRQ_NC, PIRQ_NC, PIRQ_NC } },
{ EHCI1_DEVFN, { PIRQ_EHCI, PIRQ_NC, PIRQ_NC, PIRQ_NC } },
{ XHCI_DEVFN, { PIRQ_XHCI, PIRQ_NC, PIRQ_NC, PIRQ_NC } },
};
/* PIRQ Setup */
static void pirq_setup(void)
{
pirq_data_ptr = mainboard_pirq_data;
pirq_data_size = ARRAY_SIZE(mainboard_pirq_data);
}
void __weak variant_devtree_update(void)
{
/* Override dev tree settings per board */
}
static void mainboard_init(void *chip_info)
{
int boardid = board_id();
size_t num_gpios;
const struct soc_amd_gpio *gpios;
printk(BIOS_INFO, "Board ID: %d\n", boardid);
mainboard_ec_init();
gpios = variant_gpio_table(&num_gpios);
gpio_configure_pads(gpios, num_gpios);
/* Initialize i2c buses that were not initialized in bootblock */
i2c_soc_init();
/* Set GenIntDisable so that GPIO 90 is configured as a GPIO. */
pm_write8(PM_PCIB_CFG, pm_read8(PM_PCIB_CFG) | PM_GENINT_DISABLE);
/* Set low-power mode for BayHub eMMC bridge's PCIe clock. */
clrsetbits32(acpimmio_misc + GPP_CLK_CNTRL,
GPP_CLK2_REQ_MAP_MASK,
GPP_CLK2_REQ_MAP_CLK_REQ2 <<
GPP_CLK2_REQ_MAP_SHIFT);
/* Same for the WiFi */
clrsetbits32(acpimmio_misc + GPP_CLK_CNTRL,
GPP_CLK0_REQ_MAP_MASK,
GPP_CLK0_REQ_MAP_CLK_REQ0 <<
GPP_CLK0_REQ_MAP_SHIFT);
variant_devtree_update();
}
/*************************************************
* Dedicated mainboard function
*************************************************/
static void mainboard_enable(struct device *dev)
{
/* Initialize the PIRQ data structures for consumption */
pirq_setup();
}
int mainboard_get_xhci_oc_map(uint16_t *map)
{
return variant_get_xhci_oc_map(map);
}
int mainboard_get_ehci_oc_map(uint16_t *map)
{
return variant_get_ehci_oc_map(map);
}
void mainboard_suspend_resume(void)
{
variant_mainboard_suspend_resume();
}
struct chip_operations mainboard_ops = {
.init = mainboard_init,
.enable_dev = mainboard_enable,
};
/* Variants may override these functions so see definitions in variants/ */
uint8_t __weak variant_board_sku(void)
{
return 0;
}
void __weak variant_mainboard_suspend_resume(void)
{
}
const char *smbios_system_sku(void)
{
static char sku_str[7]; /* sku{0..255} */
snprintf(sku_str, sizeof(sku_str), "sku%d", variant_board_sku());
return sku_str;
}
|
