blob: 3356e7e5917c6f47d7347541e47facd4309ae324 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
|
/* SPDX-License-Identifier: GPL-2.0-only */
#include <bootblock_common.h>
#include <soc/southbridge.h>
#include <amdblocks/lpc.h>
#include <device/pci_ops.h>
#include <gpio.h>
#include <soc/pci_devs.h>
#include <drivers/uart/uart8250reg.h>
#include <arch/io.h>
#include "../gpio.h"
/* Enable IO access to port, then enable UART HW control pins */
static void enable_serial(unsigned int base_port, unsigned int io_enable)
{
u8 reg;
pci_or_config32(SOC_LPC_DEV, LPC_IO_PORT_DECODE_ENABLE, io_enable);
/*
* Remove this section if HW handshake is not needed. This is needed
* only for those who don't have a modified serial cable (connecting
* DCD to DTR and DSR, plus connecting RTS to CTS). When you buy cables
* on any store, they don't have these modification.
*/
reg = inb(base_port + UART8250_MCR);
reg |= UART8250_MCR_DTR | UART8250_MCR_RTS;
outb(reg, base_port + UART8250_MCR);
}
void bootblock_mainboard_early_init(void)
{
fch_clk_output_48Mhz(2);
/*
* UARTs enabled by default at reset, just need RTS, CTS
* and access to the IO address.
*/
enable_serial(0x03f8, DECODE_ENABLE_SERIAL_PORT0);
enable_serial(0x02f8, DECODE_ENABLE_SERIAL_PORT1);
}
void bootblock_mainboard_init(void)
{
size_t num_gpios;
const struct soc_amd_gpio *gpios;
gpios = early_gpio_table(&num_gpios);
gpio_configure_pads(gpios, num_gpios);
}
|
