1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
|
# Flashing firmware standalone
If none of the other methods work, there are three possibilities:
## Desolder
You must remove or desolder the flash IC before you can flash it.
It's recommended to solder a socket in place of the flash IC.
When flashing the IC, always connect all input pins.
If in doubt, pull /WP, /HOLD, /RESET and alike up towards Vcc.
## SPI flash emulator
If you are a developer, you might want to use an [EM100Pro] instead, which sets
the onboard flash on hold, and allows to run custom firmware.
It provides a very fast development cycle without actually writing to flash.
## SPI flash overwrite
It is possible to set the onboard flash on hold and use another flash chip.
Connect all lines one-to-one, except /HOLD. Pull /HOLD of the soldered flash IC
low, and /HOLD of your replacement flash IC high.
### SPI header
Some boards feature a pin header which is connected to the SPI bus. This can
also be used to connect a secondary flash chip.
#### HP boards
Many HP desktop mainboards have a 2x8 or 2x10 block of header pins which
can be used to connect a second flash chip. One pin is connected to the
onboard flash's /CS pin, and another is connected to the chipset's /CS
pin. Normally a jumper cap is placed between these pins, allowing the
chipset to access the onboard flash. To use this header, remove this
jumper and connect all lines except /CS one-to-one with the
corresponding pin on the header. The secondary flash chip's /CS line
should be connected to the chipset /CS pin on the header. By doing this
the secondary SPI flash, rather than the onboard flash, will respond to
accesses from the chipset.
![][hp_spi_header_pinout]
![][hp_spi_header_mainboard]
Note that on boards where this header is unpopulated, a jumper resistor
will be populated nearby which serves the purpose of the jumper cap. One
end should have continuity with the /CS pin on the flash, and the other
end should have continuity with the chipset /CS pin on the unpopulated
header. It may also be possible to find this resistor through visual
inspection of the traces on the /CS pins. This resistor should be
desoldered if you wish to solder a pin header to the board and connect a
secondary flash, otherwise the onboard flash will always respond to
accesses.
#### Other boards
Other boards may have similar headers, but will likely use a different
pinout than the ones explicitly mentioned here. Usually such a header
will be located near the onboard SPI flash. If schematics are available,
the pinout for the header will likely be found in it, but it could also
be determined using a multimeter in continuity mode to map out the
connections between the SPI flash and the header.
[EM100Pro]: https://www.dediprog.com/product/EM100Pro
[hp_spi_header_pinout]: hp_spi_header.svg
[hp_spi_header_mainboard]: hp_spi_header_mb.jpg
|
