summaryrefslogtreecommitdiff
path: root/src/soc/nvidia
AgeCommit message (Expand)Author
2015-03-04t132: kick off core complex after loading MTS microcodeAaron Durbin
2015-03-04t132: load MTS microcodeAaron Durbin
2015-03-04t132: Replace fallback with CONFIG_CBFS_PREFIXMarc Jones
2015-03-04t132: Add shared romstageAaron Durbin
2015-03-04coreboot rush: Add dram init codeFurquan Shaikh
2015-03-04coreboot rush: Add support for basic romstageFurquan Shaikh
2015-03-04coreboot t132: Enable loading of romstage from CBFS mediaFurquan Shaikh
2015-03-04coreboot t132: Remove init pllx for nowFurquan Shaikh
2015-03-04coreboot t132,rush: Add mainboard specific bootblock_initFurquan Shaikh
2015-03-03coreboot t132: Add clock.c to all three stages of corebootFurquan Shaikh
2015-03-02coreboot arm: Define function for setting cntfrq registerFurquan Shaikh
2015-03-02tegra132: Enable bootblock support in tegra132 including UART supportFurquan Shaikh
2015-02-25tegra124: Clean up ARM UART driver buildMarc Jones
2015-02-17tegra132: Postprocess bootblock properlyPatrick Georgi
2015-02-17tegra132: Add BCT support in tegra132 socFurquan Shaikh
2015-02-17T124: perform ram_repair when CPU rail is powered on in warmbootYen Lin
2015-02-17T124: perform ram_repair when CPU rail is powered on in coldbootYen Lin
2015-02-17tegra124: Correct cpu power on sequence and CPUPWRGOOD_TIMEJimmy Zhang
2015-02-13tegra132: Fix build for verstageMarc Jones
2015-02-06include/types.h: Provide BIT() macroAlexandru Gagniuc
2015-01-27CBMEM: Always use DYNAMIC_CBMEMKyösti Mälkki
2015-01-27vboot2: implement select_firmware for pre-romstage verificationDaisuke Nojiri
2015-01-27vboot2: add verstageStefan Reinauer
2015-01-26tegra132: Add support for tegra132 socFurquan Shaikh
2015-01-14Revert "vboot2: add verstage"Paul Menzel
2015-01-13vboot2: add verstageDaisuke Nojiri
2015-01-09nyan*: I2C: Fix bus clear BC_TERMINATE naming.Tom Warren
2015-01-09tegra124: fix and fine tune the warm boot codeJoseph Lo
2015-01-09tegra: i2c: re-init i2c controller after resetJimmy Zhang
2015-01-04tegra124: configure DP with correct pixel clockVince Hsu
2014-12-30tegra: i2c: Add a timeout to I2C bit clear recovery mechanismJulius Werner
2014-12-30i2c: Add software_i2c driver for I2C debugging and emulationJulius Werner
2014-12-30tegra124: Active dc/sor register change immediatelyVince Hsu
2014-12-30tegra124: display clock should be initialized before any accessVince Hsu
2014-12-26tegra124: Add a utility function to read the cause of the most recent reset.Gabe Black
2014-12-26nyan*: I2C: Implement bus clear when 'ARB_LOST' error occursTom Warren
2014-12-19nyan*: Add fast link training functionsJimmy Zhang
2014-12-17tegra124: modify panel init sequenceKen Chang
2014-12-17nyan*: enable CLAMP_INPUTSKen Chang
2014-12-17ARM: Use LPAE for Virtual Address TranslationDaisuke Nojiri
2014-12-17tegra124: change PLLD VCO calculation algorithmKen Chang
2014-12-16tegra124: Allow "best" PLLD parameters for unmatched pixel clock.Hung-Te Lin
2014-12-16tegra124: Always enable DC when attaching SOR.Hung-Te Lin
2014-12-16nyan*: debug: Add sor registers dump functionJimmy Zhang
2014-12-16tegra124: clock: Enforce PLL constraints for VCO and CFJulius Werner
2014-12-16nyan*: Set SOR_NV_PDISP_SOR_DP_SPARE0 registerJimmy Zhang
2014-12-16nyan*: merge a couple of sor setting difference from kernel driverJimmy Zhang
2014-12-16nyan*: Apply sor fix from kernel dc driverJimmy Zhang
2014-12-16tegra124: Initialize display panel by EDID.Hung-Te Lin
2014-12-16i2c: Replace the i2c API.Gabe Black
2014-12-15tegra124: set MOT bit for I2C-over-AUXKen Chang
2014-12-15tegra124: Setup clock PLLD by approximating display panel pixel clock.Hung-Te Lin
2014-12-15tegra124: Release DMA channel at end of transactionDavid Hendricks
2014-12-15tegra124: Use correct mask for APB bus widthDavid Hendricks
2014-12-15nyan: Enable the cbmem console on nyan and allocate space for it in SRAM.Gabe Black
2014-12-15tegra124: More improvements to the clock initialization macros.Gabe Black
2014-12-15tegra: spi: Read the command1 register to ensure the write to it completes.Gabe Black
2014-12-15tegra124: A couple clock fixes.Gabe Black
2014-12-15tegra124: Add tegra_dc_i2c_aux_read to allow reading EDID.Hung-Te Lin
2014-12-15tegra124: Skip display init when vboot says we don't need it.Gabe Black
2014-12-09spi: Eliminate the spi_cs_activate and spi_cs_deactivate functions.Gabe Black
2014-12-09spi: Factor EC protocol details out of the SPI drivers.Gabe Black
2014-12-02Replace hlt with halt()Patrick Georgi
2014-11-18tegra124: remove spurious error messagePatrick Georgi
2014-11-18tegra124: actually parse is_lvdsPatrick Georgi
2014-11-14tegra124: allow tegra124 devices to run vboot rmoduleAaron Durbin
2014-11-14tegra124: i2c: Reset the controller when there's an error.Gabe Black
2014-11-14tegra124: fix the dangerous VPR write orderJoseph Lo
2014-11-14tegra124: Add some functions for resetting peripherals.Gabe Black
2014-11-14t124: Clean up display init functionsJimmy Zhang
2014-11-13arm: Put assembly functions into separate sectionsJulius Werner
2014-11-13tegra124: Add a macro specifically for configuring the I2C controller clocks.Gabe Black
2014-11-13tegra124: Fix some bugs in the clock configuration macros.Gabe Black
2014-11-13t124: Skip PLLP init to 408MHzJimmy Zhang
2014-11-13t124: nyan: Enable lock bit on pllJimmy Zhang
2014-11-13tegra124: fix OSC initialization on LP0 resumeAndrew Bresticker
2014-11-13tegra124: fix PLLU parametersAndrew Bresticker
2014-11-13tegra124: Make the PLLX frequency selectable by model.Gabe Black
2014-11-12tegra124: enable JTAG in Security ModeJimmy Zhang
2014-11-12tegra124: Program PWM1 to drive panel backlightAndrew Chew
2014-11-12tegra124: Add pwm_controller registersAndrew Chew
2014-11-12tegra124: Fix PWM pinmux functionsAndrew Chew
2014-11-12tegra124: Add PWM base addressAndrew Chew
2014-11-12tegra124: nyan: Keep in memory structures below 4GB.Gabe Black
2014-11-09arm: Thumb ALL the things!Julius Werner
2014-11-01{cpu,soc}: Use DEVICE_NOOP macro over dummy symbolEdward O'Callaghan
2014-10-22tegra/nyan*: sdram updatesTom Warren
2014-10-16uarts: 32/64 cleanupRonald G. Minnich
2014-09-22tegra124/nyan: memory and display updatesAndrew Bresticker
2014-09-22arm: Move libgcc assembly macros to arch/asm.hJulius Werner
2014-09-22Add check_member macro to allow clean and easy struct offset checkingJulius Werner
2014-09-17spi: add Kconfig variable for dual-output read enableDavid Hendricks
2014-09-13arm: Move exception_init() close to console_init()Julius Werner
2014-09-13tegra124/nyan: display, clock, and other updatesJulius Werner
2014-09-12tegra124/nyan: various fixes and additionsHung-Te Lin
2014-09-11tegra124/nyan: rougly stable code baseGabe Black
2014-09-10tegra124: Make tegra124 compilable with serial turned off.Gabe Black
2014-09-10nyan: Use the new pinmux functions as part of UART setup.Gabe Black
2014-09-10nvidia-cbootimage: integrate into coreboot makeIsaac Christensen
2014-09-09arm: Update a stale comment in bootblock .S filesDavid Hendricks