Age | Commit message (Expand) | Author |
2017-06-12 | soc/baytrail: fix scope for I2C ACPI devices | Matt DeVillier |
2017-06-09 | soc/braswell: fix scope for I2C ACPI devices | Matt DeVillier |
2017-06-09 | google/chell: add board-specific USB port info | Matt DeVillier |
2017-06-09 | mb/google/soraka: Update UF camera i2c address | Naresh G Solanki |
2017-06-08 | fsp/gop: Add running the GOP to the choice of gfx init | Nico Huber |
2017-06-08 | device/Kconfig: Put gfx init methods into a `choice` | Nico Huber |
2017-06-08 | device/Kconfig: Introduce MAINBOARD_FORCE_NATIVE_VGA_INIT | Nico Huber |
2017-06-07 | mainboard/google/poppy: Add support for ELAN device | Furquan Shaikh |
2017-06-05 | google/reef: Add coral | Patrick Georgi |
2017-06-04 | google/rambi: add board-specific USB port info | Matt DeVillier |
2017-06-04 | google/jecht: add board-specific USB port info | Matt DeVillier |
2017-06-04 | google/auron: add board-specific USB port info | Matt DeVillier |
2017-06-04 | google/slippy: populate PEI SPD data for all channels | Matt DeVillier |
2017-06-04 | google/parrot: make chromeos.c compilation conditional on CONFIG_CHROMEOS | Matt DeVillier |
2017-06-04 | google/lulu: enable SATA device to sleep in S0 | Matt DeVillier |
2017-06-04 | mb/google/poppy: Update camera sensor | Naresh G Solanki |
2017-06-03 | mb/google/fizz: set SD_CDZ to edge trigger. | Kane Chen |
2017-06-02 | Kconfig: Introduce HAVE_(VBE_)LINEAR_FRAMEBUFFER | Nico Huber |
2017-06-02 | google/rambi: disable PCI device for unused i2c buses | Matt DeVillier |
2017-06-02 | mainboard/*/*/Kconfig: Remove MONOTONIC_TIMER_MSR selection | Aamir Bohra |
2017-06-01 | mainboard/google/poppy: Enable H1 I2C TPM | Furquan Shaikh |
2017-05-31 | mainboard/google/poppy: Power down camera rails when suspending | Furquan Shaikh |
2017-05-31 | google/slippy: add board-specific USB port info | Matt DeVillier |
2017-05-31 | google/beltino: add board-specific USB port info | Matt DeVillier |
2017-05-31 | google/parrot: add board-specific USB port info | Matt DeVillier |
2017-05-31 | mb/google/eve: Update thermal tuning parameters | Duncan Laurie |
2017-05-31 | mb/google/eve: Add power controls to touchscreen device | Duncan Laurie |
2017-05-30 | tegra210: Remove fake cpu_reset() | Julius Werner |
2017-05-27 | lib/spd_bin: make SMBus SPD addresses an input | Aaron Durbin |
2017-05-27 | google/fizz: Set GPP_C2 to NC | Shelley Chen |
2017-05-26 | mainboard/google/poppy: Add PowerResource for touchscreen device | Furquan Shaikh |
2017-05-25 | mainboard/google/eve: Update VR config settings | V Sowmya |
2017-05-24 | mb/google/soraka: Update camera sensor for soraka | Naresh G Solanki |
2017-05-24 | mb/google/poppy: Update SPD data | Naresh G Solanki |
2017-05-24 | soc/marvell/bg4cd: remove cosmos mainboard and bg4cd soc | Aaron Durbin |
2017-05-19 | mainboard/google/poppy/variants/soraka: Add SPD for K3QFAFA0CM-AGCF | Furquan Shaikh |
2017-05-19 | mainboard/google/poppy: Fix SPD for micron MT52L256M64D2PP-107 | Furquan Shaikh |
2017-05-18 | google/scarlet: Enable innolux,p079zca MIPI panel | Nickey Yang |
2017-05-17 | mb/google/eve: Remove FPC device from SPI1 | Duncan Laurie |
2017-05-17 | mb/google/eve: Update touchpad I2C timing | Duncan Laurie |
2017-05-17 | mainboard/google/poppy/variants/soraka: Enable H1 I2C TPM | Furquan Shaikh |
2017-05-17 | mainboard/google/poppy: Correct I2C bus number for TPM | Furquan Shaikh |
2017-05-17 | google/fizz: Configure SATAXPCIe GPIOs to use native function | Shelley Chen |
2017-05-12 | mainboard/google/reef: Config needed GPIO for pull-up WA | Lijian Zhao |
2017-05-11 | google/gru: support 800M/928M frequency for bob | Caesar Wang |
2017-05-11 | rockchip/rk3399: enable DPLL SSC for DDR EMI test on bob | Caesar Wang |
2017-05-09 | google/sand: Add keyboard backlight support | Katherine Hsieh |
2017-05-08 | mb/google/reef: enable SAR and DSAR | Wei-Ning Huang |
2017-05-05 | mb/google/poppy: Add eMMC as thermal sensor | Sumeet Pawnikar |
2017-05-05 | Revert "google/scarlet: Enable innolux,p079zca MIPI panel" | Martin Roth |
2017-05-05 | google/scarlet: Enable innolux,p079zca MIPI panel | Nickey Yang |
2017-05-05 | mainboard/google/sand: Update DPTF parameters provided from thermal team | Katherine Hsieh |
2017-05-05 | google/fizz: Enable devices under pci 1c.0 | Shelley Chen |
2017-05-05 | mainboard/google/poppy: Enable MODE_CHANGE event in SCI_MASK | Furquan Shaikh |
2017-05-04 | mb/google/eve: Remove code to set keyboard backlight at boot | Duncan Laurie |
2017-05-04 | mb/google/eve: Set SUSWARN# pin to native function | Duncan Laurie |
2017-05-03 | google/gru: skip usbphy1 setup for Scarlet | philipchen |
2017-05-03 | mainboard/google/poppy: Add support for cr50 I2C TPM | Furquan Shaikh |
2017-05-03 | mainboard/google/poppy: Update GPIO table for next build | Furquan Shaikh |
2017-05-01 | acpi: fix FADT header version for ChromeOS devices | Matt DeVillier |
2017-04-29 | rowan: Fix default test HWID. | Patrick Berny |
2017-04-28 | mainboard/google/soraka: Add support for memory configs 1,2,7 and 8 | Furquan Shaikh |
2017-04-28 | mainboard/google/poppy: Add SPDs for memory config 1 and 2 | Furquan Shaikh |
2017-04-28 | mainboard/google/poppy: Enable separate MRC cache for recovery mode | Furquan Shaikh |
2017-04-28 | google/gru: tpm on bob: cr50: add irq clear/irq status for tpm irq | Jeffy Chen |
2017-04-28 | google/oak: Configure SD card detect pin with a pull-up | Julius Werner |
2017-04-27 | mb/google/eve: switch touchpad devicetree to i2c-hid and cros_ec i2c device | Wei-Ning Huang |
2017-04-27 | google/poppy: Enable PD MCU device | Shamile Khan |
2017-04-27 | google/fizz: Configure HDMI HPD to use native function | Shelley Chen |
2017-04-27 | google/fizz: Enable SATA on port 1 | Shelley Chen |
2017-04-25 | google/gru: change the sd power sequence | Caesar Wang |
2017-04-25 | google/oak: Enable dual DSI for rowan and the BOE 8-lane MIPI/DSI panel | Daniel Kurtz |
2017-04-25 | mediatek/mt8173: Add support for Dual DSI output | Jitao Shi |
2017-04-25 | google/oak: Use edid_set_framebuffer_bits_per_pixel | Daniel Kurtz |
2017-04-24 | google/oak: Support cr50 over I2C on rowan | Vadim Bendebury |
2017-04-24 | mainboard/google/reef: Remove DRIVER_TPM_I2C_IRQ | Daniel Kurtz |
2017-04-24 | mainboard/google/eve: Remove DRIVER_TPM_I2C_IRQ | Daniel Kurtz |
2017-04-24 | mainboard/google/reef: Add TPM_TIS_ACPI_INTERRUPT | Daniel Kurtz |
2017-04-24 | mainboard/google/eve: Add TPM_TIS_ACPI_INTERRUPT | Daniel Kurtz |
2017-04-24 | mainboard/google/poppy: use intel common tis_plat_irq_status() | Aaron Durbin |
2017-04-24 | Kconfig: provide MAINBOARD_HAS_TPM_CR50 option | Aaron Durbin |
2017-04-24 | mb/google/fizz: Set lid status as open | Naresh G Solanki |
2017-04-24 | mb/google/fizz: Configure PCI root port | Naresh G Solanki |
2017-04-24 | google/fizz: Configure memory | Shelley Chen |
2017-04-24 | *.asl: Remove obsolete reference to TPM ASL file | Patrick Rudolph |
2017-04-20 | mainboard/google/eve: Set touchpad IRQ to level triggered | Duncan Laurie |
2017-04-19 | google/gru: change kevin boot-time center logic voltage to 925mV | Douglas Anderson |
2017-04-19 | google/gru: change center logic voltage to 900mV | Derek Basehore |
2017-04-19 | mainboard/google/poppy/variants/soraka: add soraka board | YH Lin |
2017-04-19 | mainboard/google/poppy: Provide nhlt variant API | Furquan Shaikh |
2017-04-19 | mainboard/google/poppy: Provide memory configuration variant API | Furquan Shaikh |
2017-04-19 | mainboard/google/poppy: Provide cros_gpio variant API | Furquan Shaikh |
2017-04-19 | mainboard/google/poppy: Add variant API for board_id and gpio | Furquan Shaikh |
2017-04-19 | mainboard/google/poppy: Provide baseboard and variant concepts | Furquan Shaikh |
2017-04-19 | mainboard/google/poppy: Prepare sharing directory for variants | Furquan Shaikh |
2017-04-19 | mb/google/poppy: Add camera support | V Sowmya |
2017-04-19 | mb/google/poppy: Add Image Processing Unit ASL | Sowmya |
2017-04-18 | mainboard/google/poppy: Clean up gpio.h file | Furquan Shaikh |
2017-04-18 | mainboard/google/poppy: Enable deep S3 in DC mode | Furquan Shaikh |
2017-04-15 | google/slippy: fix internal mic for falco/wolf variants | Matt DeVillier |