summaryrefslogtreecommitdiff
path: root/src/mainboard/google/gru
AgeCommit message (Expand)Author
2017-04-25google/gru: change the sd power sequenceCaesar Wang
2017-04-24Kconfig: provide MAINBOARD_HAS_TPM_CR50 optionAaron Durbin
2017-04-19google/gru: change kevin boot-time center logic voltage to 925mVDouglas Anderson
2017-04-19google/gru: change center logic voltage to 900mVDerek Basehore
2017-04-11scarlet/gru: skip display because mipi driver not readyShunqian Zheng
2017-04-06gru: Initialize I2C bus for ARC2C0608Philip Chen
2017-03-28vboot: Move remaining features out of vendorcode/google/chromeosJulius Werner
2017-03-28vboot: Assume EC_SOFTWARE_SYNC and VIRTUAL_DEV_SWITCH by defaultJulius Werner
2017-03-09drivers/spi/tpm: provide Kconfig to indicate CR50 usageAaron Durbin
2017-03-07google/gru: add MAX_SDRAM_FREQ config to choose max ddr freqShunqian Zheng
2017-02-23google/gru: whitespace fixPatrick Georgi
2017-02-23google/gru: Tuning USB 2.0 PHY0 and PHY1 squelch detection thresholdWilliam wu
2017-02-23google/gru: update the pwm regulatorCaesar Wang
2017-02-23google/gru: improve eye diagram for passing the testCaesar Wang
2017-02-22google/gru: Fix whitespacePatrick Georgi
2017-02-11google/gru: add scarlet variantphilipchen
2017-01-22gru: kevin: define GPIOs used on both platformsVadim Bendebury
2017-01-13gru: Tuning USB 2.0 PHY0 and PHY1 host-portWilliam wu
2016-12-06Bob: Update the memory ramid of bobShasha Zhao
2016-12-06Bob: add bob in corebootShasha Zhao
2016-12-06rockchip/rk3399: sdram: use register to calculate sdram sizesLin Huang
2016-12-06google/gru: Power-cycle USB ports in developer/recovery modesJulius Werner
2016-12-01lib: put romstage_handoff implementation in own compilation unitAaron Durbin
2016-11-29google/gru: Tune USB 2.0 PHY to increase compatibilityWilliam wu
2016-11-18google/chromeec: Add common infrastructure for boot-mode switchesFurquan Shaikh
2016-11-17google/gru: Move to one CA training patternDerek Basehore
2016-11-17google/gru: Add new CA training patternDerek Basehore
2016-11-02rockchip/rk3399: display: Do not allocate framebuffer in corebootLin Huang
2016-11-02rockchip/rk3399: sdram: also prepare the index1 configurationLin Huang
2016-10-25rockchip/rk3399: gru/kevin: drop unused sdram configsLin Huang
2016-10-25rockchip/rk3399: reset system if DDR init failsLin Huang
2016-10-08google/gru: Add USB 2.0 PHY tuning for Kevin PHY0 and PHY1William wu
2016-10-07google/gru: drive WLAN_MODULE_RST# low as early as possibleBrian Norris
2016-10-07google/gru: set W2W_DIFFCS_DLY to 5Lin Huang
2016-10-07google/gru: pass apio number to arm-trust-firmwareLin Huang
2016-10-07google/gru: pass the gpio power supply enable pin to bl31Lin Huang
2016-10-06rockchip: rk3399: improve write leveling flowJianqun Xu
2016-10-06google/gru: Shrink RW_ELOG region to 4KBJulius Werner
2016-10-06rockchip: rk3399: improve sdram noc timingLin Huang
2016-10-06rockchip/rk3399: lower kevin board sdram frequency to 800MHzLin Huang
2016-10-06rockchip/rk3399: Move big CPU cluster initialization into ramstageJulius Werner
2016-10-04google/gru: Ensure correct pull resistors for special-function pinsJulius Werner
2016-10-04gru: Increase SPI speed to 33MHzSimon Glass
2016-10-04google/gru: Init the PWM pinmux after setting up the PWMDouglas Anderson
2016-10-02Kconfig: Update default hex values to start with 0xMartin Roth
2016-09-20gru/kevin: Decrease voltage for little cpu 1.5G to 1.15vShunqian Zheng
2016-09-20google/gru: Fix up PWM regulator rangesJulius Werner
2016-09-20Gru: Increase bit-per-pixel to 32Daisuke Nojiri
2016-09-20gru: Add watchdog reset supportJulius Werner
2016-09-20gru: Add USB 2.0 PHY tuning for KevinJulius Werner
2016-08-31rockchip/rk3399: Add pwm_regulator.c for pwm then ramp boot up cpuEric Gao
2016-08-31rockchip/rk3399: Move romstage.c to mainboard/gruShunqian Zheng
2016-08-27gru: Make SDRAM parameters individual struct files in CBFSJulius Werner
2016-08-19rockchip/rk3399 & gru/kevin: support sdram 933MHz on kevinLin Huang
2016-08-18Kconfig: rename BOOT_MEDIA_SPI_BUS to BOOT_DEVICE_SPI_FLASH_BUSAaron Durbin
2016-08-16Revert "rockchip: rk3399: enable sdhci clk for emmc"Shunqian Zheng
2016-08-13Revert "gru: Show the current time on start-up"Julius Werner
2016-08-11rockchip/rk3399: Add code to neuter Type-C PHY for firmware USBJulius Werner
2016-08-09google/gru: Fix rk3399-gru write protectDouglas Anderson
2016-08-09google/gru: Update board/RAM ID ADC valuesJulius Werner
2016-08-03google/gru: Add code to support I2C TPM for KevinJulius Werner
2016-08-03google/gru: Add support for Gru rev1Julius Werner
2016-07-28google/gru & kevin: Update DRAM configurationLin Huang
2016-07-28chromeos: Clean up elog handlingFurquan Shaikh
2016-07-28vboot: Separate vboot from chromeosFurquan Shaikh
2016-07-25google/gru: Change UART _Static_assert() condition to #ifJulius Werner
2016-07-18gru: implement hw reset functionVadim Bendebury
2016-07-13gru: Enable TPM2Vadim Bendebury
2016-07-13oak/gru: Fix derivative KconfigsJulius Werner
2016-07-12google/gru: Read RAM & board ids from the ADCShelley Chen
2016-07-12google/gru: Enable coreboot read recovery eventShelley Chen
2016-07-12google/gru: enable EC software syncShelley Chen
2016-07-10gru: include ram_code in coreboot tableVadim Bendebury
2016-06-24rockchip/rk3399: provide multiple SDRAM configurationsLin Huang
2016-06-24gru: Add elog supportSimon Glass
2016-06-24gru: Add get_developer_mode_switch()Simon Glass
2016-06-24gru: Show the current time on start-upSimon Glass
2016-06-24gru: Enable EC-based RTCSimon Glass
2016-06-23rockchip/rk3399: correct sdram inc file DENALI_CTL_217_DATA valueLin Huang
2016-06-23gru: kevin: initialize cr50 SPI interfaceVadim Bendebury
2016-06-21rockchip: kevin/gru: Slow memory down to 300 MHzDouglas Anderson
2016-06-21rockchip: gru: pass poweroff gpio parameter to BL31Lin Huang
2016-06-21rockchip: gru: pass reset gpio parameter to BL31Lin Huang
2016-06-12rockchip: gru: Add USB DRD DWC3 controller supportLiangfeng Wu
2016-06-08rockchip: rk3399: Add support i2sXing Zheng
2016-06-08gru: kevin: enable EC SPI interfaceVadim Bendebury
2016-06-08gru: kevin: configure board GPIOsVadim Bendebury
2016-06-08gru: kevin: define GPIOs used on both platformsVadim Bendebury
2016-06-07Kevin/Gru : Update Board ID table.jongpil19.jung
2016-06-07rockchip: gru: update the hynix lpddr3 config to run at 928MHzShunqian Zheng
2016-06-03rockchip: gru: enable eDP displayLin Huang
2016-05-18rockchip: rk3399: enable sdhci clk for emmcShunqian Zheng
2016-05-18rockchip: rk3399: configure emmc clkLin Huang
2016-05-18rk3399: set proper configuration of SDMMC interfaceVadim Bendebury
2016-05-18gru: set correct gpio for SD card detectVadim Bendebury
2016-05-18Gru: support 4GB sdram on gruLin Huang
2016-05-09google/gru: enable pp1500 and pp3000 rails as soon as possibleVadim Bendebury
2016-05-09google/gru: kevin: use board version specific SD detect GPIO pinVadim Bendebury
2016-05-09google/gru: select 1.8V as gpio2ab io domainLin Huang
2016-05-09google/gru: add board nameVadim Bendebury
generated by cgit v1.2.3 (git 2.25.1) at 2024-11-26 14:05:32 +0000