1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
|
##
## This file is part of the coreboot project.
##
## Copyright (C) 2007 Uwe Hermann <uwe@hermann-uwe.de>
##
## This program is free software; you can redistribute it and/or modify
## it under the terms of the GNU General Public License as published by
## the Free Software Foundation; either version 2 of the License, or
## (at your option) any later version.
##
## This program is distributed in the hope that it will be useful,
## but WITHOUT ANY WARRANTY; without even the implied warranty of
## MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
## GNU General Public License for more details.
##
## You should have received a copy of the GNU General Public License
## along with this program; if not, write to the Free Software
## Foundation, Inc., 51 Franklin St, Fifth Floor, Boston, MA 02110-1301 USA
##
uses HAVE_MP_TABLE
uses CONFIG_CBFS
uses HAVE_PIRQ_TABLE
uses USE_FALLBACK_IMAGE
uses USE_FAILOVER_IMAGE
uses HAVE_FALLBACK_BOOT
uses HAVE_FAILOVER_BOOT
uses HAVE_HARD_RESET
uses IRQ_SLOT_COUNT
uses HAVE_OPTION_TABLE
uses CONFIG_MAX_CPUS
uses CONFIG_MAX_PHYSICAL_CPUS
uses CONFIG_LOGICAL_CPUS
uses CONFIG_IOAPIC
uses CONFIG_SMP
uses FALLBACK_SIZE
uses FAILOVER_SIZE
uses ROM_SIZE
uses ROM_SECTION_SIZE
uses ROM_IMAGE_SIZE
uses ROM_SECTION_SIZE
uses ROM_SECTION_OFFSET
uses CONFIG_ROM_PAYLOAD
uses CONFIG_ROM_PAYLOAD_START
uses CONFIG_COMPRESSED_PAYLOAD_NRV2B
uses CONFIG_COMPRESSED_PAYLOAD_LZMA
uses CONFIG_PRECOMPRESSED_PAYLOAD
uses PAYLOAD_SIZE
uses _ROMBASE
uses XIP_ROM_SIZE
uses XIP_ROM_BASE
uses STACK_SIZE
uses HEAP_SIZE
uses USE_OPTION_TABLE
uses LB_CKS_RANGE_START
uses LB_CKS_RANGE_END
uses LB_CKS_LOC
uses MAINBOARD_PART_NUMBER
uses MAINBOARD_VENDOR
uses MAINBOARD
uses MAINBOARD_PCI_SUBSYSTEM_VENDOR_ID
uses MAINBOARD_PCI_SUBSYSTEM_DEVICE_ID
uses COREBOOT_EXTRA_VERSION
uses _RAMBASE
uses TTYS0_BAUD
uses TTYS0_BASE
uses TTYS0_LCS
uses DEFAULT_CONSOLE_LOGLEVEL
uses MAXIMUM_CONSOLE_LOGLEVEL
uses MAINBOARD_POWER_ON_AFTER_POWER_FAIL
uses CONFIG_CONSOLE_SERIAL8250
uses HAVE_INIT_TIMER # ?
uses CROSS_COMPILE
uses CC
uses HOSTCC
uses OBJCOPY
uses CONFIG_CONSOLE_VGA
uses CONFIG_PCI_ROM_RUN
uses CONFIG_USBDEBUG_DIRECT
uses HW_MEM_HOLE_SIZEK
uses HW_MEM_HOLE_SIZE_AUTO_INC
uses K8_HT_FREQ_1G_SUPPORT
uses HT_CHAIN_UNITID_BASE
uses HT_CHAIN_END_UNITID_BASE
uses SB_HT_CHAIN_ON_BUS0
uses SB_HT_CHAIN_UNITID_OFFSET_ONLY
uses USE_DCACHE_RAM
uses DCACHE_RAM_BASE
uses DCACHE_RAM_SIZE
uses DCACHE_RAM_GLOBAL_VAR_SIZE
uses CONFIG_USE_INIT
uses SERIAL_CPU_INIT
uses ENABLE_APIC_EXT_ID
uses APIC_ID_OFFSET
uses LIFT_BSP_APIC_ID
uses CONFIG_PCI_64BIT_PREF_MEM
uses CONFIG_LB_MEM_TOPK
uses CONFIG_AP_CODE_IN_CAR
uses MEM_TRAIN_SEQ
uses WAIT_BEFORE_CPUS_INIT
uses CONFIG_USE_PRINTK_IN_CAR
default ROM_SIZE = 512 * 1024
default FALLBACK_SIZE = (256 * 1024) - (4 * 1024)
default FAILOVER_SIZE = 4 * 1024
default CONFIG_LB_MEM_TOPK = 2048 # 1MB more for pgtbl.
default HAVE_FALLBACK_BOOT = 1
default HAVE_FAILOVER_BOOT = 1
default HAVE_HARD_RESET = 1
default HAVE_PIRQ_TABLE = 1
default IRQ_SLOT_COUNT = 11 # TODO: Check if correct.
default HAVE_MP_TABLE = 1 # TODO: Check if correct.
default HAVE_OPTION_TABLE = 1
default CONFIG_SMP = 1
default CONFIG_MAX_CPUS = 2
default CONFIG_MAX_PHYSICAL_CPUS = 1
default CONFIG_LOGICAL_CPUS = 1
# default SERIAL_CPU_INIT = 0
default ENABLE_APIC_EXT_ID = 0
default APIC_ID_OFFSET = 0x10
default LIFT_BSP_APIC_ID = 1
# Move the default coreboot CMOS range off of AMD RTC registers.
default LB_CKS_RANGE_START = 49
default LB_CKS_RANGE_END = 122
default LB_CKS_LOC = 123
# Memory hole size. 0 means disable, others will enable the hole. In that
# case, if it is smaller than mmio_basek, it will use mmio_basek instead.
# default HW_MEM_HOLE_SIZEK = 0x200000 # 2GB
default HW_MEM_HOLE_SIZEK = 0x100000 # 1GB
# default HW_MEM_HOLE_SIZEK = 0x80000 # 512MB
# Make auto increase hole size to avoid hole_startk equal to basek so as
# to make some kernel happy.
# default HW_MEM_HOLE_SIZE_AUTO_INC = 1
# Opteron K8 1G HT support.
default K8_HT_FREQ_1G_SUPPORT = 1
# HT Unit ID offset, default is 1, the typical one, 0 means only one HT device.
default HT_CHAIN_UNITID_BASE = 0
# Real SB Unit ID, default is 0x20, mean don't touch it at last.
# default HT_CHAIN_END_UNITID_BASE = 0x6
# Make the SB HT chain on bus 0, default is not (0).
default SB_HT_CHAIN_ON_BUS0 = 2
# Only offset for SB chain? Default is yes (1).
default SB_HT_CHAIN_UNITID_OFFSET_ONLY = 0
# Allow capable device use that above 4GB.
# default CONFIG_PCI_64BIT_PREF_MEM = 1
default CONFIG_CONSOLE_VGA = 1 # Needed for VGA.
default CONFIG_PCI_ROM_RUN = 1 # Needed for VGA.
default CONFIG_USBDEBUG_DIRECT = 0
default USE_DCACHE_RAM = 1
default DCACHE_RAM_BASE = 0xc8000
default DCACHE_RAM_SIZE = 0x08000
default DCACHE_RAM_GLOBAL_VAR_SIZE = 0x01000
default CONFIG_USE_INIT = 0
default CONFIG_AP_CODE_IN_CAR = 0
default MEM_TRAIN_SEQ = 2
default WAIT_BEFORE_CPUS_INIT = 0
default CONFIG_IOAPIC = 1
default MAINBOARD_PART_NUMBER = "K9N Neo (MS-7260)"
default MAINBOARD_VENDOR = "MSI"
default MAINBOARD_PCI_SUBSYSTEM_VENDOR_ID = 0x1462
default MAINBOARD_PCI_SUBSYSTEM_DEVICE_ID = 0x7260
default ROM_IMAGE_SIZE = 65536
default STACK_SIZE = 0x2000
default HEAP_SIZE = 0x8000
default USE_OPTION_TABLE = (!USE_FALLBACK_IMAGE) && (!USE_FAILOVER_IMAGE)
default _RAMBASE = 0x00100000
default CONFIG_ROM_PAYLOAD = 1
default CC = "$(CROSS_COMPILE)gcc -m32"
default HOSTCC = "gcc"
default CONFIG_USE_PRINTK_IN_CAR = 1
default CONFIG_CONSOLE_SERIAL8250 = 1
default TTYS0_BAUD = 115200
default TTYS0_BASE = 0x3f8
default TTYS0_LCS = 0x3
default DEFAULT_CONSOLE_LOGLEVEL = 9
default MAXIMUM_CONSOLE_LOGLEVEL = 9
default MAINBOARD_POWER_ON_AFTER_POWER_FAIL = "MAINBOARD_POWER_ON"
#
# CBFS
#
#
default CONFIG_CBFS=0
end
|
