1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
|
/* SPDX-License-Identifier: GPL-2.0-only */
#include <device/mmio.h>
#include <bootblock_common.h>
#include <delay.h>
#include <soc/grf.h>
#include <gpio.h>
#include <soc/clock.h>
#include <soc/i2c.h>
#include <soc/pwm.h>
#include <soc/spi.h>
#include <vendorcode/google/chromeos/chromeos.h>
#include "board.h"
#include "pwm_regulator.h"
void bootblock_mainboard_early_init(void)
{
/* Configure all programmable IO voltage domains (3D/4A and 2A/2B) early
so that we know we can use our GPIOs reliably in following code. */
write32(&rk3399_grf->io_vsel, RK_SETBITS(1 << 1 | 1 << 0));
/* On Scarlet-based boards, the 4C/4D domain is 1.8V (on others 3.0V) */
if (CONFIG(GRU_BASEBOARD_SCARLET))
write32(&rk3399_grf->io_vsel, RK_SETBITS(1 << 3));
/* Reconfigure GPIO1 from dynamic voltage selection through GPIO0_B1 to
hardcoded 1.8V, and change that pin to a normal GPIO. The TRM says
this is already the power-on reset, but we all know that TRMs lie. */
write32(&rk3399_pmugrf->soc_con0, RK_SETBITS(1 << 9 | 1 << 8));
write32(&rk3399_pmugrf->gpio0b_iomux, RK_CLRBITS(3 << 2));
/* Enable rails powering GPIO blocks, among other things. */
gpio_output(GPIO_P30V_EN, 1);
if (!CONFIG(GRU_BASEBOARD_SCARLET))
gpio_output(GPIO_P15V_EN, 1); /* Scarlet: EC-controlled */
if (CONFIG(CONSOLE_SERIAL)) {
_Static_assert(CONFIG_CONSOLE_SERIAL_UART_ADDRESS == UART2_BASE,
"CONSOLE_SERIAL_UART should be UART2");
/* iomux: select gpio4c[4:3] as uart2 dbg port */
write32(&rk3399_grf->iomux_uart2c, IOMUX_UART2C);
/* grf soc_con7[11:10] use for uart2 select */
write32(&rk3399_grf->soc_con7, UART2C_SEL);
}
}
static void configure_spi_flash(void)
{
gpio_input(GPIO(1, A, 7)); /* SPI1_MISO remove pull-up */
gpio_input(GPIO(1, B, 0)); /* SPI1_MOSI remove pull-up */
gpio_input(GPIO(1, B, 1)); /* SPI1_CLK remove pull-up */
gpio_input(GPIO(1, B, 2)); /* SPI1_CS remove pull-up */
rockchip_spi_init(CONFIG_BOOT_DEVICE_SPI_FLASH_BUS, 33*MHz);
rockchip_spi_set_sample_delay(CONFIG_BOOT_DEVICE_SPI_FLASH_BUS, 5);
write32(&rk3399_pmugrf->spi1_rxd, IOMUX_SPI1_RX);
write32(&rk3399_pmugrf->spi1_csclktx, IOMUX_SPI1_CSCLKTX);
}
static void configure_ec(void)
{
gpio_input(GPIO(2, C, 4)); /* SPI5_MISO remove pull-up */
gpio_input(GPIO(2, C, 5)); /* SPI5_MOSI remove pull-up */
gpio_input(GPIO(2, C, 6)); /* SPI5_CLK remove pull-up */
gpio_input_pullup(GPIO(2, C, 7)); /* SPI5_CS confirm pull-up */
rockchip_spi_init(CONFIG_EC_GOOGLE_CHROMEEC_SPI_BUS, 3093750);
write32(&rk3399_grf->iomux_spi5, IOMUX_SPI5);
}
static void configure_tpm(void)
{
if (CONFIG(GRU_HAS_TPM2)) {
rockchip_spi_init(CONFIG_DRIVER_TPM_SPI_BUS, 1500*KHz);
if (CONFIG(GRU_BASEBOARD_SCARLET)) {
gpio_input(GPIO(2, B, 1)); /* SPI2_MISO no-pull */
gpio_input(GPIO(2, B, 2)); /* SPI2_MOSI no-pull */
gpio_input(GPIO(2, B, 3)); /* SPI2_CLK no-pull */
gpio_input_pullup(GPIO(2, B, 4)); /* SPI2_CS */
write32(&rk3399_grf->iomux_spi2, IOMUX_SPI2);
} else {
gpio_input(GPIO(3, A, 4)); /* SPI0_MISO no-pull */
gpio_input(GPIO(3, A, 5)); /* SPI0_MOSI no-pull */
gpio_input(GPIO(3, A, 6)); /* SPI0_CLK no-pull */
gpio_input_pullup(GPIO(3, A, 7)); /* SPI0_CS */
write32(&rk3399_grf->iomux_spi0, IOMUX_SPI0);
}
gpio_input_irq(GPIO_TPM_IRQ, IRQ_TYPE_EDGE_RISING, GPIO_PULLUP);
} else {
gpio_input(GPIO(1, B, 7)); /* I2C0_SDA remove pull-up */
gpio_input(GPIO(1, C, 0)); /* I2C0_SCL remove pull-up */
i2c_init(0, 400*KHz);
write32(&rk3399_pmugrf->iomux_i2c0_scl, IOMUX_I2C0_SCL);
write32(&rk3399_pmugrf->iomux_i2c0_sda, IOMUX_I2C0_SDA);
}
}
static void speed_up_boot_cpu(void)
{
pwm_regulator_configure(PWM_REGULATOR_LIT, 1150);
udelay(200);
rkclk_configure_cpu(APLL_1512_MHZ, CPU_CLUSTER_LITTLE);
}
void bootblock_mainboard_init(void)
{
speed_up_boot_cpu();
if (rkclk_was_watchdog_reset())
reboot_from_watchdog();
configure_spi_flash();
configure_ec();
configure_tpm();
setup_chromeos_gpios();
}
|
