1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
|
# Flashing with fwupd
#### **Requirements:**
* fwupd version 1.5.6 or later
* The battery must be charged to at least 30%
* The charger must be connected (either USB-C or DC Jack)
* BIOS Lock must be disabled
* Supported Linux distribution (Ubuntu 20.04 +, Linux Mint 20.1 + elementaryOS 6 +, Manjaro 21+)
**fwupd 1.5.6 or later**
To check the version of **fwupd** you have installed, open a terminal window and enter the below command:
```
fwupdmgr --version
```
This will show the version number. **1.5.6** or greater will work.
On Ubuntu 20.04, Ubuntu 20.10, Linux Mint 20.1 and elementaryOS 6, fwupd 1.5.6 can be installed from our PPA with the below terminal commands:
```
sudo add-apt-repository ppa:starlabs/ppa
sudo apt update
sudo apt install fwupd
```
On Manjaro:
```
sudo pacman -Sy fwupd-git flashrom-starlabs
```
Instructions for other distributions will be added once fwupd 1.5.6 is available. If you are not using one of the distributions listed above, it is possible to install coreboot using a Live USB.
**Disable BIOS Lock**
BIOS Lock must be disabled when switching from the standard AMI (American Megatrends Inc.) firmware to coreboot. To disable BIOS Lock:
1\. Start with your LabTop turned off\. Turn it on whilst holding the **F2** key to access the BIOS settings.
2\. When the BIOS settings load, use the arrow keys to navigate to the **Advanced** tab\. Here you will see **BIOS Lock**\.
3\. Press `Enter` to change this setting from **Enabled** to **Disabled**
4\. Next, press the `F10` key to **Save & Exit** and then `Enter` to confirm.
#### **Switching Branch**
Switching branch refers to changing from AMI firmware to coreboot, or vice versa.
First, check for new firmware files with the below terminal command:
```
fwupdmgr refresh --force
```
Then, to change branch, enter the below terminal command:
```
fwupdmgr switch-branch
```
You can then select which branch you would like to use, by typing in the corresponding number:
You will be prompted to confirm, press `y` to continue or `n` to cancel.
Once the switch has been completed, you will be prompted to restart.
The next reboot can take up to **5 minutes,** do not interrupt this process or disconnect the charger. Once the reboot is complete, that's it - you'll continue to receive updates for whichever branch you are using.
You can switch branch at any time.
|
