Age | Commit message (Expand) | Author |
2008-06-22 | flashrom: A few changes were committed before the DoC remove, update README. | Peter Stuge |
2008-06-22 | flashrom: Remove dead M-Systems Disk on Chip code | Peter Stuge |
2008-06-22 | flashrom: Update test status to TEST_OK_PREW for ST M50FLW080A and SST49LF008A | Peter Stuge |
2008-06-22 | flashrom: Some Makefile cleaning | Peter Stuge |
2008-06-21 | flashrom: Fix OBJS in Makefile to compile stm50flw0x0x.c like the others | Peter Stuge |
2008-06-21 | flashrom: Uppercase AMIC since that's what they write in datasheets. | Peter Stuge |
2008-06-21 | flashrom: Update comment to match delay change in probe_jedec() r3373 | Peter Stuge |
2008-06-21 | flashrom: Update test status for Atmel AT29C020 and SST29EE010 | Peter Stuge |
2008-06-21 | flashrom: Increase delay in probe_jedec() to 2ms to reliably detect AT29C020 | Peter Stuge |
2008-06-20 | flashrom: Show expected and read byte on verify failure. Trivial. | Peter Stuge |
2008-06-18 | flashrom: Add support for AMIC Technology A49LF040A and do not probe W29EE011... | Jens Kuehnel |
2008-06-18 | flashrom: Force read unknown flash chips | Peter Stuge |
2008-06-13 | flashrom: Board enable and autodetection for GIGABYTE GA-7VT600 | Peter Stuge |
2008-06-11 | flashrom: Add support for Amic Technology A29040B flash chip. | Peter Stuge |
2008-06-11 | flashrom: Board enable and autodetection for BioStar P4M80-M4. | Peter Stuge |
2008-06-03 | Ward writes: | Peter Stuge |
2008-05-27 | Revert r3357 and fix it as intended to (forgotten header commit instead of typo) | Mart Raudsepp |
2008-05-27 | Fix typo introduced in r3356 that breaks build (trivial). | Mart Raudsepp |
2008-05-27 | flashrom: MX25L4005, S25FL016A, W39V040B, W39V080A, SST49LF008A tests. | Peter Stuge |
2008-05-27 | Mark SST49LF004A/B as tested (trivial). | Mart Raudsepp |
2008-05-26 | Mark the following chips as tested (trivial). | Uwe Hermann |
2008-05-22 | A bunch of cosmetic improvements (trivial). | Uwe Hermann |
2008-05-22 | Mark more chips as tested (all operations), tested on ASUS P4B266 (trivial). | Uwe Hermann |
2008-05-22 | Add support for the ASUS P4B266 board. | Uwe Hermann |
2008-05-22 | Add support for Amic A25L40P SPI flash. | Rudolf Marek |
2008-05-22 | Changes to make flashrom compile (and work) on FreeBSD. | Andriy Gapon |
2008-05-21 | Myles reported SST49LF080A status -> TESTED_PREW | Peter Stuge |
2008-05-17 | flashrom: Support Pm49FL004/2 Block Locking Registers | Nikolay Petukhov |
2008-05-16 | I looked at the datasheet and erase_sector_39sf020() is totally and | Carl-Daniel Hailfinger |
2008-05-16 | ICH8 and ICH9 have an almost identical SPI interface, only the location | Carl-Daniel Hailfinger |
2008-05-16 | Add support for the Atmel AT25DF321 SPI flash (tested). | Dominik Geyer |
2008-05-16 | Add support for SPI chips on ICH9. This is done by using the generic SPI | Dominik Geyer |
2008-05-16 | Enable IT8716F LPC-to-SPI write cycle translation in flashrom if the | Carl-Daniel Hailfinger |
2008-05-15 | Print detailed status register information for SST25VF series flash. | Carl-Daniel Hailfinger |
2008-05-15 | Lots of new SST flash chip IDs. Only a subset has been added to | Carl-Daniel Hailfinger |
2008-05-15 | Add support for the JEDEC RES (Read Electronic Signature and Resume from | Carl-Daniel Hailfinger |
2008-05-14 | Add more infrastructure for flashrom ICH9 support. | Carl-Daniel Hailfinger |
2008-05-14 | Add the Intel 6300ESB as known chipset to the chipset struct enables. | Claus Gindhart |
2008-05-14 | Fix crash caused by division by zero for unknown flash chips. | Carl-Daniel Hailfinger |
2008-05-14 | Check the JEDEC vendor ID for correct parity. Flash chips which can be | Carl-Daniel Hailfinger |
2008-05-14 | Add lots of ATMEL SPI flash chips to flash.h. | Carl-Daniel Hailfinger |
2008-05-13 | flashrom: Move all IT87xx specific SPI routines from spi.c to a separate | Carl-Daniel Hailfinger |
2008-05-13 | flashrom: Move the SPI #defines from spi.c to spi.h | Carl-Daniel Hailfinger |
2008-05-13 | Change the SPI parts of flashrom to prepare for a merge of | Carl-Daniel Hailfinger |
2008-05-12 | MX25L3205 and W25x40 have been confirmed to probe/read/erase/write OK | Carl-Daniel Hailfinger |
2008-05-12 | Add SST39VF512, SST39VF010, SST39VF040 support to flashrom. The SST39LF | Carl-Daniel Hailfinger |
2008-05-10 | Improve flashrom SPI abstraction, second step. | Carl-Daniel Hailfinger |
2008-05-10 | flashrom: Rename generic_spi_*() functions to spi_*() | Peter Stuge |
2008-05-08 | flashrom: Probe for up to 3 flash chips. | Claus Gindhart |
2008-05-03 | flashrom: Add a tested bitmap field to the flash chip table. | Peter Stuge |
2008-04-29 | flashrom: Enable ROM decode range to 1MB for vt8237r | Bari Ari |
2008-04-28 | The generic jedec.c does not work for the ST M50FLW flash | Claus Gindhart |
2008-04-28 | flashrom: Handle NULL probe, erase and write function pointers in the | Peter Stuge |
2008-04-24 | Flash pages, which where excluded from updating using the exclude or the | Claus Gindhart |
2008-04-07 | ST M50FW016 and ST M50FW040 support the 82802ab command set, not jedec. | Ed Swierk |
2008-03-18 | Add ICH9 detection to flashrom. Straight from the datasheet, untested. | Carl-Daniel Hailfinger |
2008-03-18 | oops. forgot to add the file. | Stefan Reinauer |
2008-03-17 | Support for the Winbond W39V080FA series of chips. | Stefan Reinauer |
2008-03-16 | check whether SST FWH chip was successfully erased on flashchip -E, too | Stefan Reinauer |
2008-03-16 | Sort list of flash chips alphabetically, add comment (trivial). | Uwe Hermann |
2008-03-15 | remove nasty warning that happened due to our vendor detection | Stefan Reinauer |
2008-03-14 | Re-add code erroneously removed in r3140. | Uwe Hermann |
2008-03-14 | Changes M50FW080 to use 82802ab.c instead of jedec.c. This fixes the problem ... | Joseph Smith |
2008-03-14 | Prepare for ICH7/ICH8 SPI support by adding some debugging for all | Carl-Daniel Hailfinger |
2008-03-14 | Fix broken flashrom build. | Uwe Hermann |
2008-03-14 | Fix up one forgotten revert in r3140. | Carl-Daniel Hailfinger |
2008-03-14 | Revert the delete of 82802ab.c in r3137. | Carl-Daniel Hailfinger |
2008-03-13 | Also print the chip vendor name in --list-supported output (trivial). | Uwe Hermann |
2008-03-13 | Also print the required -m option in --list-supported output (trivial). | Uwe Hermann |
2008-03-13 | Drop 82802ab.c as it is identical to sharplhf00l04.c. | Carl-Daniel Hailfinger |
2008-03-12 | Drop the useless rom.layout file. It's just an example, likely never | Uwe Hermann |
2008-03-12 | Add --list-supported option to flashrom which lists the supported | Uwe Hermann |
2008-03-04 | Add missing license header to layout.c. The file was written by | Uwe Hermann |
2008-02-20 | flashrom: Add board_enable for Artec Group DBE61 and DBE62 | Mart Raudsepp |
2008-02-14 | With this small change it is possible to build flashrom again when | Clark Rawlins |
2008-02-11 | flashrom: further cleanups to enable_flash_cs5536 | Mart Raudsepp |
2008-02-09 | Flashrom: Add board enable for VIA EPIA SP. | Luc Verhaegen |
2008-02-08 | Improve error handling and make RCONF_DEFAULT_MSR address be a constant. | Mart Raudsepp |
2008-02-08 | This implements support for devices using AMD Geode companion chip | Mart Raudsepp |
2008-02-06 | Handle JEDEC JEP106W continuation codes in SPI RDID. Some vendors like | Carl-Daniel Hailfinger |
2008-01-27 | Make the vendor name optional in the -m flashrom parameter when there's only | Peter Stuge |
2008-01-27 | Forgot to add Spansion S25FL016A to README, trivial. | Peter Stuge |
2008-01-26 | Correctly disable the ROM area Write Protect bit in the Geode LX. | Marc Jones |
2008-01-25 | Add ids and chip entry for Spansion S25FL016A to flashrom, tested, | Peter Stuge |
2008-01-22 | Here is just a little and simple patch to get the MX25L3205D working. | Harald Gutmann |
2008-01-22 | Flashrom did not use the read function for verifying, it used direct memory | Carl-Daniel Hailfinger |
2008-01-22 | Make sure we delay writing the next byte long enough in SPI byte | Carl-Daniel Hailfinger |
2008-01-21 | Omitting the wait for SPI ready when there is no data to be read, e.g. | Ronald Hoogenboom |
2008-01-21 | This patch adds version information to flashrom. Because 'v' and 'V' | Bernhard Walle |
2008-01-19 | Support SPI flash chips bigger than 512 kByte sitting behind IT8716F | Ronald Hoogenboom |
2008-01-18 | Minor documentation improvements/fixes in the README and manpage (trivial). | Uwe Hermann |
2008-01-18 | rename linuxbios_* files in utils repository. | Stefan Reinauer |
2008-01-18 | for some reasons the externals did not get committed. | Stefan Reinauer |
2008-01-11 | This patch removes '\n' from the help output since this looks a bit strange. | Bernhard Walle |
2008-01-10 | Enable MX25L8005 support in flashrom. The #defines were already there. | Harald Gutmann |
2008-01-07 | Add support for the SST25VF040B 4 Mbit SPI flash chip. | Carl-Daniel Hailfinger |
2008-01-04 | Add board enable for the gigabyte ga_2761gxdk board | Ronald G. Minnich |
2008-01-04 | Print at least the vendor for SPI flash chips if the exact chip ID is | Carl-Daniel Hailfinger |
2007-12-31 | Unfortunately, EN29F002T, EN29F002AT, EN29F002ANT, EN29F002NT all have | Carl-Daniel Hailfinger |
2007-12-31 | Add continuation ID support to jedec.c | Carl-Daniel Hailfinger |