aboutsummaryrefslogtreecommitdiff
path: root/src/southbridge/amd/sb600
AgeCommit message (Collapse)Author
2009-03-04I just went on a bugfix frenzy and fixed all printk format warningsCarl-Daniel Hailfinger
triggered by the AMD 690/SB600 targets. Signed-off-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006@gmx.net> Acked-by: Stefan Reinauer <stepan@coresystems.de> git-svn-id: svn://svn.coreboot.org/coreboot/trunk@3970 2b7e53f0-3cfb-0310-b3e9-8179ed1497e1
2009-02-28coreboot-v2: drop this ugly historic union name in v2 that was dropped in v3Stefan Reinauer
a long time ago. This will make it easier to port v2 boards forward to v3 at some point (and other things) Signed-off-by: Stefan Reinauer <stepan@coresystems.de> Acked-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006@gmx.net> git-svn-id: svn://svn.coreboot.org/coreboot/trunk@3964 2b7e53f0-3cfb-0310-b3e9-8179ed1497e1
2009-02-05Use the correct device for switching on HDA.Dan Lykowski
Reorder HDA (HD Audio) init: The reordering was based on what order things happen in the BIOS Developers guide, RPR, and SATA driver. I fixed the order of the devices that didn't matter to clean up the change log. 1. Enable the Chip 2. Setup the SMBus registers 3. Setup the Device Registers 4. Look for Codec 5. Init Codec The codec init was changed to match the description in the RRG pg 235. Mem Reg: Base + 08h Bit 0. There were unneeded things happening. Added 1ms delay to match the BKDG while waiting for BAR+0xe to set its bits. Signed-off-by: Dan Lykowski <lykowdk@gmail.com> Tested on AMD DBM690T and AMD Pistachio by Maggie Li. Works. Tested on Asus M2A-VM by Carl-Daniel Hailfinger. Improves the situation, but some warnings remain. Acked-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006@gmx.net> git-svn-id: svn://svn.coreboot.org/coreboot/trunk@3930 2b7e53f0-3cfb-0310-b3e9-8179ed1497e1
2009-01-15Adds a retry/faildown to SB600 SATA detection logic.Dan Lykowski
SATA port status kept returning 0x1: BAR5+po+28h 1h = Device presence detected but Phy communication not established This patch adds logic to force 1.5g if the drive fails to communicate at 3.0g. Signed-off-by: Dan Lykowski <lykowdk@gmail.com> Acked-by: Peter Stuge <peter@stuge.se> git-svn-id: svn://svn.coreboot.org/coreboot/trunk@3864 2b7e53f0-3cfb-0310-b3e9-8179ed1497e1
2008-12-29The SB600 RPR documentation does not mention what to do if SATA_BAR0+6Carl-Daniel Hailfinger
is no longer 0xA0 or 0xB0. It simply assumes that will never happen. My 500 GB Seagate Barracuda ST3500820AS triggers that corner case on the first init after poweron. The current code hangs forever with my drive. Fix this by rerunning the init sequence after SATA_BAR0+6 is no longer 0xA0 or 0xB0. Add support for SATA port 2-4 (Primary Slave, Secondary Master, Secondary Slave). If only the 2nd SATA port is connected and the hardware acts strangely (contrary to documentation), it will print the error message below and continue anyway. The official AMD asm code behaves the same way. SATA port 0 status = 0 No Primary Master SATA drive on Slot0 SATA port 1 status = 23 0x6=7f, 0x7=7f drive no longer selected after 0 ms, retrying init [8 repetitions] 0x6=7f, 0x7=7f drive no longer selected after 0 ms, retrying init Primary Slave device is not ready after 10 tries Activate and improve debug messages for SPEW log level. Fix some comments. New log messages look like this: PCI: 00:12.0 init sata_bar0=3020 sata_bar1=3060 sata_bar2=3030 sata_bar3=3070 sata_bar4=3000 sata_bar5=fc309000 SATA port 0 status = 23 0x6=a0, 0x7=80 drive detection not yet completed, waiting... 0x6=a0, 0x7=80 drive detection not yet completed, waiting... [... 281 repetitions ...] 0x6=0, 0x7=50 drive no longer selected after 2820 ms, retrying init drive detection done after 0 ms Primary Master device is ready after 2 tries SATA port 1 status = 23 drive detection done after 0 ms Primary Slave device is ready after 1 tries SATA port 2 status = 0 No Secondary Master SATA drive on Slot2 SATA port 3 status = 0 No Secondary Slave SATA drive on Slot3 With this patch, my Asus M2A-VM boots into Linux without problems. Signed-off-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006@gmx.net> Acked-by: Zheng Bao <zheng.bao@amd.com> git-svn-id: svn://svn.coreboot.org/coreboot/trunk@3845 2b7e53f0-3cfb-0310-b3e9-8179ed1497e1
2008-12-23Fix implicit declarations of pci_read_config32 and pci_write_config32 inMaggie Li
the SB600 code. Signed-off-by: Maggie Li <Maggie.li@amd.com> Reviewed-by: Zheng bao <Zheng.bao@amd.com> Acked-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006@gmx.net> git-svn-id: svn://svn.coreboot.org/coreboot/trunk@3837 2b7e53f0-3cfb-0310-b3e9-8179ed1497e1
2008-12-12Improve comments in early SB600 setup, handle non-LPC strapping andCarl-Daniel Hailfinger
document verification against the data sheets. Signed-off-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006@gmx.net> Acked-by: Maggie Li <maggie.li@amd.com> git-svn-id: svn://svn.coreboot.org/coreboot/trunk@3811 2b7e53f0-3cfb-0310-b3e9-8179ed1497e1
2008-12-01Add AMD sb600 HPET setup and some minor cleanups.Joe Bao
Signed-off-by: Joe Bao <zheng.bao@amd.com> Reviewed-by: Maggie Li <maggie.li@amd.com> Acked-by: Ronald G. Minnich <rminnich@gmail.com> Acked-by: Marc Jones <marcj303@gmail.com> git-svn-id: svn://svn.coreboot.org/coreboot/trunk@3785 2b7e53f0-3cfb-0310-b3e9-8179ed1497e1
2008-11-14drop dead code in sb600 hdaStefan Reinauer
Signed-off-by: Stefan Reinauer <stepan@coresystems.de> Acked-by: Myles Watson <mylesgw@gmail.com> git-svn-id: svn://svn.coreboot.org/coreboot/trunk@3752 2b7e53f0-3cfb-0310-b3e9-8179ed1497e1
2008-10-21I/O ports are 16bit, so change 'unsigned long port_base' to 'u16 port_base'.Uwe Hermann
Also, use more readable #defines instead of hardcoded config ports for PM/PM2 related functions, and simplify them a bit. Build-tested with the AMD dbm690t target. Signed-off-by: Uwe Hermann <uwe@hermann-uwe.de> Acked-by: Marc Jones <marc.jones@amd.com> git-svn-id: svn://svn.coreboot.org/coreboot/trunk@3680 2b7e53f0-3cfb-0310-b3e9-8179ed1497e1
2008-10-21Add missing license header.Uwe Hermann
Signed-off-by: Uwe Hermann <uwe@hermann-uwe.de> Acked-by: Jordan Crouse <jordan.crouse@amd.com> git-svn-id: svn://svn.coreboot.org/coreboot/trunk@3678 2b7e53f0-3cfb-0310-b3e9-8179ed1497e1
2008-10-13Move AMD RS690 and SB600 PCI IDs to pci_ids.h where they should be.Uwe Hermann
Build-tested with the AMD dbm690t board. Signed-off-by: Uwe Hermann <uwe@hermann-uwe.de> Acked-by: Marc Jones <marc.jones@amd.com> git-svn-id: svn://svn.coreboot.org/coreboot/trunk@3655 2b7e53f0-3cfb-0310-b3e9-8179ed1497e1
2008-10-09Added comment about sb600 wideio setting for clarity and a minor witespace ↵Marc Jones
cleanup. (trivial) Signed-off-by: Marc Jones <marcj.jones@amd.com> Acked-by: Marc Jones <marcj.jones@amd.com> git-svn-id: svn://svn.coreboot.org/coreboot/trunk@3643 2b7e53f0-3cfb-0310-b3e9-8179ed1497e1
2008-10-07[PATCH] coreboot: Don't loop forever waiting for HDA codecsJordan Crouse
We shouldn't assume the presence of a working HDA codec, so put in a reasonable timeout of 50usecs (timeout value borrowed from the kernel). This makes SimNow work, since apparently though the codec is present in Simnow, it is non functional. Signed-off-by: Jordan Crouse <jordan.crouse@amd.com> Acked-by: Ronald G. Minnich <rminnich@gmail.com> git-svn-id: svn://svn.coreboot.org/coreboot/trunk@3640 2b7e53f0-3cfb-0310-b3e9-8179ed1497e1
2008-10-03Ron has been doing really good work over in v3. The problem is that the work ↵Marc Jones
got checked into v2. This should get us back to where we were. (trivial) Signed-off-by: Marc Jones <marc.jones@amd.com> Acked-by: Marc Jones <marc.jones@amd.com> git-svn-id: svn://svn.coreboot.org/coreboot/trunk@3636 2b7e53f0-3cfb-0310-b3e9-8179ed1497e1
2008-10-02This is so that people can see it. This is the sb600 for v3. It almost Ronald G. Minnich
certainly won't build -- that comes later. I am hoping to get some eyeballs on it for simple errors. rs690 is next. Signed-off-by: Ronald G. Minnich <rminnich@gmail.com> Acked-by: Ronald G. Minnich <rminnich@gmail.com> git-svn-id: svn://svn.coreboot.org/coreboot/trunk@3630 2b7e53f0-3cfb-0310-b3e9-8179ed1497e1
2008-10-01The ARRAY_SIZE macro is convenient, yet mostly unused. Switch lots ofCarl-Daniel Hailfinger
code to use it. That makes the code more readable and also less error-prone. Abuild tested. Signed-off-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006@gmx.net> Acked-by: Peter Stuge <peter@stuge.se> git-svn-id: svn://svn.coreboot.org/coreboot/trunk@3624 2b7e53f0-3cfb-0310-b3e9-8179ed1497e1
2008-09-22Patch for AMD SB600 chipset.Michael Xie
Most of the functions in SB600 are enabled except power management. Signed-off-by: Michael Xie <Michael.Xie@amd.com> Reviewed-by: Marc Jones <marc.jones@amd.com> Acked-by: Stefan Reinauer <stepan@coresystems.de> git-svn-id: svn://svn.coreboot.org/coreboot/trunk@3589 2b7e53f0-3cfb-0310-b3e9-8179ed1497e1
generated by cgit v1.2.3 (git 2.39.1) at 2024-08-25 03:38:01 +0000