Age | Commit message (Expand) | Author |
2015-04-20 | console: copy ns16550 driver from u-boot | Daisuke Nojiri |
2015-04-20 | rk3288: Disable ramstage compression by default | Julius Werner |
2015-04-18 | vboot: make vboot2_verify_firmware return | Daisuke Nojiri |
2015-04-18 | ipq806x: initialize UART even when console is not enabled | Vadim Bendebury |
2015-04-18 | ipq806x: uart: replace hardware accessors | Vadim Bendebury |
2015-04-18 | broadwell: Set C9/C10 vccmin | Duncan Laurie |
2015-04-18 | broadwell: Disable XHCI compliance mode entry | Duncan Laurie |
2015-04-18 | soc/intel/common: Add common reset code | Lee Leahy |
2015-04-18 | soc/intel/common: Add function to protect MRC cache | Duncan Laurie |
2015-04-18 | broadwell: add ROM stage pre console init call back | Wenkai Du |
2015-04-17 | cygnus: enable mmu | Daisuke Nojiri |
2015-04-17 | cygnus: configure memlayout | Daisuke Nojiri |
2015-04-17 | cygnus: add timer functions | Daisuke Nojiri |
2015-04-17 | pistachio: Move console UART to a Kconfig variable | David Hendricks |
2015-04-17 | qualcomm/ipq806x: add spi_crop_chunk() | Patrick Georgi |
2015-04-17 | pistachio: add DDR2 initialization code | Ionela Voinescu |
2015-04-17 | ipq806x: extend GSBI driver to support i2c on any GSBI block | Sourabh Banerjee |
2015-04-17 | ipq806x: add LPASS clock control driver | Vadim Bendebury |
2015-04-17 | rk3288: Add software I2C support | Julius Werner |
2015-04-17 | ipq806x: Add support for mmu in bootblock. | Deepa Dinamani |
2015-04-17 | broadcom/cygnus: add new SoC driver | Daisuke Nojiri |
2015-04-17 | chromeos: Provide common watchdog reboot support | Julius Werner |
2015-04-17 | chromeos: Move memlayout.h/symbols.h into common directory | Julius Werner |
2015-04-17 | storm: define location for storing CBFS header value | Vadim Bendebury |
2015-04-17 | pistachio: report UART register width | Vadim Bendebury |
2015-04-17 | uart: pass register width in the coreboot table | Vadim Bendebury |
2015-04-17 | exynos: return correct value when init_default_cbfs_media fails | Daisuke Nojiri |
2015-04-17 | rk3288: detect sdram size at runtime | huang lin |
2015-04-17 | rk3288: Handle framebuffer through memlayout, not the resource system | Julius Werner |
2015-04-17 | bg4cd: define custom romstage entry | Daisuke Nojiri |
2015-04-17 | rk3288: Add a config variable hack to skip display init | David Hendricks |
2015-04-17 | veyron: Activate Winbond SPI driver | Julius Werner |
2015-04-15 | rk3288: support edp HPD function | huang lin |
2015-04-15 | rk3288: set the rk808 BUCK default inductor current to max value | huang lin |
2015-04-15 | rk3288: Fix failing LPDDR3 reboot test | jinkun.hong |
2015-04-15 | rk3288: Fix failing DDR3 reboot test | jinkun.hong |
2015-04-15 | ipq806x: load and start RPM | Vadim Bendebury |
2015-04-15 | storm: Add watchdog reset api. | Deepa Dinamani |
2015-04-15 | ipq806x: Load TZBSP blob from coreboot ramstage | Vikas Das |
2015-04-15 | storm: use different CBFS caches before and after DRAM is available | Vadim Bendebury |
2015-04-15 | storm: configure/enable vboot2 support | Vadim Bendebury |
2015-04-15 | ipq8064: add DRAM initialization code | Vadim Bendebury |
2015-04-15 | ipq806x: add i2c driver | Vadim Bendebury |
2015-04-15 | google/storm: prepare enabling vboot2 | Vadim Bendebury |
2015-04-15 | ipq806x: modify imem layout | Deepa Dinamani |
2015-04-15 | soc/ipq806x: Disable LPAE mode. | Deepa Dinamani |
2015-04-15 | ipq806x: set architecture to ARMV7 | Vadim Bendebury |
2015-04-15 | broadwell: Fixes for _SWS support | Duncan Laurie |
2015-04-15 | broadwell: Remove unused bootblock code | Duncan Laurie |
2015-04-15 | broadwell: Clean up ME device and add new ME10 flow | Duncan Laurie |
2015-04-15 | soc/baytrail: Use microcode from the blobs repository | Marc Jones |
2015-04-15 | soc/broadwell: Use microcode from the blobs repository | Marc Jones |
2015-04-15 | rk3288: send correct EDID buffer size | huang lin |
2015-04-15 | rk808: Implement RTC driver | David Hendricks |
2015-04-15 | veyron_*: Move PMIC_BUS to a Kconfig variable | David Hendricks |
2015-04-15 | rk3288: Implement support for CRYPTO module and use it in vboot hashing | Julius Werner |
2015-04-15 | veyron_*: Use common CBFS wrapper | David Hendricks |
2015-04-15 | veyron: Move backlight gpio control to mainboard.c | huang lin |
2015-04-15 | veyron: Trigger hard reset (via GPIO) if last reboot was caused by watchdog | Julius Werner |
2015-04-15 | veyron: Turn off SD card power in romstage | Julius Werner |
2015-04-15 | rk3288: implement spi_crop_chunk() | Patrick Georgi |
2015-04-14 | broadwell: Remove TPM device from lpc.asl | Duncan Laurie |
2015-04-14 | pistachio: implement clock setup for I2C0 | Ionela Voinescu |
2015-04-14 | pistachio: Fix ROM clock base address | Ionela Voinescu |
2015-04-14 | urara: add clock setup for MIPS CPU, ROM and Ethernet | Ionela Voinescu |
2015-04-14 | pistachio: fix clocks setup code | Ionela Voinescu |
2015-04-14 | pistachio: Use 1.8433179 MHz for UART refclk | David Hendricks |
2015-04-14 | pistachio: increase size of bootblock to 18 KB | Ionela Voinescu |
2015-04-14 | pistachio: change memory layout as to allow bigger CBFS cache | Ionela Voinescu |
2015-04-14 | pistachio: spi: use same clock edge for RX and TX | Ionela Voinescu |
2015-04-14 | urara: Configure clocks and MFIOs | Ionela Voinescu |
2015-04-14 | tegra132: lock down VPR | Aaron Durbin |
2015-04-14 | rush: Enable dp display | Jimmy Zhang |
2015-04-14 | ryu: display: Add function to pass mode info to payload | Jimmy Zhang |
2015-04-14 | ryu: display: Set display shift clock divider | Jimmy Zhang |
2015-04-14 | rush: Configure display related clock, pad, and power | Jimmy Zhang |
2015-04-14 | rush: Add dp related parameters | Jimmy Zhang |
2015-04-14 | rk3288: Fix memlayout to allow a little more bootblock space | Julius Werner |
2015-04-14 | rk3288: Add CBMEM console support and fix RETURN_FROM_VERSTAGE | Julius Werner |
2015-04-14 | timer: Reestablish init_timer(), consolidate timer initialization calls | Julius Werner |
2015-04-14 | CBFS: Automate ROM image layout and remove hardcoded offsets | Julius Werner |
2015-04-14 | storm: add ipq8064 blobs to the CBFS | Vadim Bendebury |
2015-04-14 | ipq8064: use the new utility to build bootblock | Vadim Bendebury |
2015-04-13 | broadwell: Work around VBIOS framebuffer issue | Duncan Laurie |
2015-04-13 | rk3288/exynos5250/exynos5420: Consolidate timer files | Julius Werner |
2015-04-13 | rk3288: Increase PD_BUS_ACLK (SRAM clock) to improve boot speed | Julius Werner |
2015-04-13 | storm: Fix timer init order problem | Julius Werner |
2015-04-13 | ipq806x: copy i2c, qup, and gsbi drivers from depthcharge | Daisuke Nojiri |
2015-04-13 | rk3288: Move UART initialization to bootblock_mainboard_early_init() | Julius Werner |
2015-04-13 | arm: Add bootblock_mainboard_early_init() for pre-console initialization | Julius Werner |
2015-04-13 | arm: Redesign mainboard and SoC hooks for bootblock | Julius Werner |
2015-04-13 | rush: Add and select DO_SOR_INIT config option | Jimmy Zhang |
2015-04-13 | ryu: Add and select DO_DSI_INIT config option | Jimmy Zhang |
2015-04-13 | ryu: display: Move display api to mainboard | Jimmy Zhang |
2015-04-13 | ryu: display: Split dc functions from dsi display code | Jimmy Zhang |
2015-04-13 | rk3288: Increase the delay after DDR reset de-assert to 10us. | Dailunxue |
2015-04-13 | t132: Add I2S1 support to funit | Tom Warren |
2015-04-13 | spi: support controllers with limited transfer size capabilities | Vadim Bendebury |
2015-04-13 | broadwell: Fix incorrect SATA port map mask | Wenkai Du |
2015-04-13 | urara: add support for DMA coherent memory area | Ionela Voinescu |