Age | Commit message (Expand) | Author |
2016-10-06 | rockchip: rk3399: improve write leveling flow | Jianqun Xu |
2016-10-06 | rockchip/rk3399: Move TTB to the end of SRAM | Julius Werner |
2016-10-06 | rockchip: spi: Add support for 16-bit APB reads | Simon Glass |
2016-10-06 | rockchip: Correct and standardize clock divisor range assertions | Julius Werner |
2016-10-06 | rockchip/rk3399: Move big CPU cluster initialization into ramstage | Julius Werner |
2016-10-04 | rockchip: spi: Set rxd sample delay when using high speed | Simon Glass |
2016-10-04 | rockchip/rk3399: Fix rkclk_init() to actually use PERILP1_PCLK_HZ | Julius Werner |
2016-10-04 | rockchip: Remove pulls for gpio_output(), clean up code | Julius Werner |
2016-10-04 | rockchip/rk3399: Remove CONFIG_ARM64_A53_ERRATUM_843419 | Julius Werner |
2016-09-20 | rockchip: spi: Improve SPI read efficiency | Simon Glass |
2016-09-20 | gru: Add watchdog reset support | Julius Werner |
2016-09-20 | gru: Add USB 2.0 PHY tuning for Kevin | Julius Werner |
2016-08-31 | rockchip/rk3399: Add pwm_regulator.c for pwm then ramp boot up cpu | Eric Gao |
2016-08-31 | rockchip/rk3399: Move romstage.c to mainboard/gru | Shunqian Zheng |
2016-08-27 | rockchip/rk3399: Enable ramstage compression, shuffle around memlayout | Julius Werner |
2016-08-27 | gru: Make SDRAM parameters individual struct files in CBFS | Julius Werner |
2016-08-19 | rockchip/rk3399 & gru/kevin: support sdram 933MHz on kevin | Lin Huang |
2016-08-17 | google/gru: Add new PWM regulator duty numbers for revision 6 | Julius Werner |
2016-08-16 | Revert "rockchip: rk3399: enable sdhci clk for emmc" | Shunqian Zheng |
2016-08-11 | rockchip/rk3399: Add code to neuter Type-C PHY for firmware USB | Julius Werner |
2016-08-10 | rockchip/common: Set weekday to unknown in rtc_get() | Martin Roth |
2016-08-09 | rockchip/rk3399: sdram: correct read obs and set DQS driver register | Lin Huang |
2016-08-03 | google/gru: Add code to support I2C TPM for Kevin | Julius Werner |
2016-07-28 | rockchip/rk3399: sdram: correct controller vref setting | Lin Huang |
2016-07-25 | rockchip/rk3399: set CA drive strength to 48ohms | Lin Huang |
2016-07-19 | rockchip/rk3399: Remove unused variable | Martin Roth |
2016-07-18 | gru: implement hw reset function | Vadim Bendebury |
2016-07-15 | rockchip/rk3399: extend romstage range | Lin Huang |
2016-07-15 | rockchip/rk3399: set kevin rev3 pwm regulator initial value to 0.95v | Lin Huang |
2016-07-15 | rockchip/rk3399: Remove empty function in sdram.c | Derek Basehore |
2016-07-15 | rockchip/rk3399: Change copy_to_reg arg type | Derek Basehore |
2016-07-15 | rockchip/rk3399: Directly access variables in sdram.c | Derek Basehore |
2016-07-15 | rockchip/rk3399: cleanup variables in dram_all_config | Derek Basehore |
2016-07-15 | rockchip/rk3399: add/remove local variables to sdram_init | Derek Basehore |
2016-07-13 | rk3399: allow more room for CBMEM console | Vadim Bendebury |
2016-07-12 | rockchip/rk3399: Fix pinctrl pull bias settings | Shunqian Zheng |
2016-07-12 | rockchip/rk3399: initialize apll_b | Lin Huang |
2016-07-12 | rockchip/rk3399: Use apll instead of apll_l define | Lin Huang |
2016-07-12 | rockchip/rk3399: calculate clocks based on parent clock speed | Lin Huang |
2016-07-12 | rockchip/rk3399: Clean up comments in sdram.c | Derek Basehore |
2016-07-07 | soc: Remove newline from `CHIP_NAME` | Paul Menzel |
2016-06-24 | rk3399: clean up sdram controller initialization code | Vadim Bendebury |
2016-06-23 | rockchip/rk3399: fix sdram training issue | Lin Huang |
2016-06-23 | rockchip/rk3399: Clean up voltage rail settings | Lin Huang |
2016-06-23 | rk3399: add definition for SP0 iomux | Vadim Bendebury |
2016-06-21 | rockchip: gpio: add macro so we can get gpio number | Lin Huang |
2016-06-12 | rockchip: rk3399: pass board specific message to BL31 | Lin Huang |
2016-06-12 | Kconfig: Set VBOOT_OPROM_MATTERS for relevant non-x86 devices | Julius Werner |
2016-06-12 | rockchip: gru: Add USB DRD DWC3 controller support | Liangfeng Wu |
2016-06-08 | rockchip: rk3399: Add support i2s | Xing Zheng |
2016-06-08 | gru: kevin: configure board GPIOs | Vadim Bendebury |
2016-06-08 | rk3399: add ability to configure SPI5 | Vadim Bendebury |
2016-06-07 | rockchip: gru: update the hynix lpddr3 config to run at 928MHz | Shunqian Zheng |
2016-06-06 | rk3288: Remove duplicate timestamp_init() | Julius Werner |
2016-06-03 | rockchip: gru: enable eDP display | Lin Huang |
2016-06-03 | rockchip: rk3399: initialize display for eDP | Shunqian Zheng |
2016-05-18 | rockchip: rk3399: enable sdhci clk for emmc | Shunqian Zheng |
2016-05-18 | rockchip: rk3399: configure emmc clk | Lin Huang |
2016-05-18 | rk3399: add GPIO register definitions for SDMMC0 | Vadim Bendebury |
2016-05-18 | rockchip: rk3399: improve sdram driver | Lin Huang |
2016-05-18 | rockchip: rk3399: add tsadc driver | Shunqian Zheng |
2016-05-18 | rockchip: revert the common tsadc header | Shunqian Zheng |
2016-05-18 | rockchip: rk3399: add routines to set vop clocks | Shunqian Zheng |
2016-05-09 | drivers/uart: Use uart_platform_refclk for all UART models | Lee Leahy |
2016-05-09 | rockchip/rk3399: protect the DRAM address for atf | Caesar Wang |
2016-05-09 | rockchip: move vop driver from rk3288 to rockchip common | Shunqian Zheng |
2016-05-09 | rockchip/rk3288: Shuffle memlayout to make it fit | Julius Werner |
2016-05-09 | google/gru: enable pp1500 and pp3000 rails as soon as possible | Vadim Bendebury |
2016-05-09 | rockchip/rk3399: Set all 4 DVFS voltage rails to 1.1V @300kHz | Vadim Bendebury |
2016-05-09 | rockchip/*: refactor edp driver | Lin Huang |
2016-05-09 | rockchip/spi: Allow SPI buses > 2 | Patrick Georgi |
2016-05-09 | rockchip: rk3399: support saradc | Lin Huang |
2016-05-09 | rockchip: rk3399: enable arm trust firmware | Lin Huang |
2016-05-09 | rockchip: make sure sdram top does not spill into MMIO space | Lin Huang |
2016-05-09 | rockchip: rk3399: add sdram driver | Lin Huang |
2016-05-09 | rockchip: rk3399: init the secure setting | Shunqian Zheng |
2016-05-09 | rockchip: rk3399: enable pwm | Lin Huang |
2016-05-09 | rockchip: rk3399: add gpio driver | Vadim Bendebury |
2016-05-09 | rockchip: refactor gpio driver | Shunqian Zheng |
2016-05-09 | rockchip: rk3399: add i2c clock driver | huang lin |
2016-05-09 | rockchip: rk3399: add spi clock driver | Shunqian Zheng |
2016-05-09 | rockchip: rk3399: enable mmu | Lin Huang |
2016-05-09 | rockchip: rk3399: add functions to configure ddrc freq | Shunqian Zheng |
2016-05-09 | rockchip: rk3399: support basic clock driver | Lin Huang |
2016-05-09 | rockchip: rk3399: use static pointers to regs as they compile to faster code | Vadim Bendebury |
2016-05-09 | rockchip: rk3399: add the GRF header file | Lin Huang |
2016-05-09 | rockchip: rk3399: add simplest sdram to fix compiling error | Shunqian Zheng |
2016-05-09 | rockchip/rk*: replace UART special snowflake with standard driver | Patrick Georgi |
2016-04-16 | google/gru: Incorporate feedback to #14279 | Patrick Georgi |
2016-04-14 | src/soc/rockchip: Update license headers | Martin Roth |
2016-04-13 | rockchip/common: do not retrieve register pointer twice | Vadim Bendebury |
2016-04-13 | rockchip/rk3288: refactor pwm driver | Lin Huang |
2016-04-13 | rockchip/rk3288: refactor i2c interface to allow support of rk3399 | huang lin |
2016-04-13 | rockchip/rk3399: Add a stub implementation of the rk3399 SOC | huang lin |
2016-04-07 | rockchip: refactor to sharing code among similar SOCs | Vadim Bendebury |
2016-04-07 | edid: Make framebuffer row alignment configurable | Julius Werner |
2016-03-24 | edid: Add helper function to calculate bits-per-pixel dependent values | Julius Werner |
2016-03-16 | rockchip: update make_idb.py | huang lin |
2016-02-12 | timestamp: Remove HAS_PRECBMEM_TIMESTAMP_REGION Kconfig | Julius Werner |
2016-02-09 | rockchip/rk3288: UART uses 32bit wide registers | Patrick Georgi |