summaryrefslogtreecommitdiff
path: root/src/soc/rockchip/rk3399
AgeCommit message (Expand)Author
2016-10-06rockchip: Correct and standardize clock divisor range assertionsJulius Werner
2016-10-06rockchip/rk3399: Move big CPU cluster initialization into ramstageJulius Werner
2016-10-04rockchip/rk3399: Fix rkclk_init() to actually use PERILP1_PCLK_HZJulius Werner
2016-10-04rockchip: Remove pulls for gpio_output(), clean up codeJulius Werner
2016-10-04rockchip/rk3399: Remove CONFIG_ARM64_A53_ERRATUM_843419Julius Werner
2016-09-20gru: Add watchdog reset supportJulius Werner
2016-09-20gru: Add USB 2.0 PHY tuning for KevinJulius Werner
2016-08-31rockchip/rk3399: Add pwm_regulator.c for pwm then ramp boot up cpuEric Gao
2016-08-31rockchip/rk3399: Move romstage.c to mainboard/gruShunqian Zheng
2016-08-27rockchip/rk3399: Enable ramstage compression, shuffle around memlayoutJulius Werner
2016-08-27gru: Make SDRAM parameters individual struct files in CBFSJulius Werner
2016-08-19rockchip/rk3399 & gru/kevin: support sdram 933MHz on kevinLin Huang
2016-08-17google/gru: Add new PWM regulator duty numbers for revision 6Julius Werner
2016-08-16Revert "rockchip: rk3399: enable sdhci clk for emmc"Shunqian Zheng
2016-08-11rockchip/rk3399: Add code to neuter Type-C PHY for firmware USBJulius Werner
2016-08-09rockchip/rk3399: sdram: correct read obs and set DQS driver registerLin Huang
2016-08-03google/gru: Add code to support I2C TPM for KevinJulius Werner
2016-07-28rockchip/rk3399: sdram: correct controller vref settingLin Huang
2016-07-25rockchip/rk3399: set CA drive strength to 48ohmsLin Huang
2016-07-19rockchip/rk3399: Remove unused variableMartin Roth
2016-07-18gru: implement hw reset functionVadim Bendebury
2016-07-15rockchip/rk3399: extend romstage rangeLin Huang
2016-07-15rockchip/rk3399: set kevin rev3 pwm regulator initial value to 0.95vLin Huang
2016-07-15rockchip/rk3399: Remove empty function in sdram.cDerek Basehore
2016-07-15rockchip/rk3399: Change copy_to_reg arg typeDerek Basehore
2016-07-15rockchip/rk3399: Directly access variables in sdram.cDerek Basehore
2016-07-15rockchip/rk3399: cleanup variables in dram_all_configDerek Basehore
2016-07-15rockchip/rk3399: add/remove local variables to sdram_initDerek Basehore
2016-07-13rk3399: allow more room for CBMEM consoleVadim Bendebury
2016-07-12rockchip/rk3399: Fix pinctrl pull bias settingsShunqian Zheng
2016-07-12rockchip/rk3399: initialize apll_bLin Huang
2016-07-12rockchip/rk3399: Use apll instead of apll_l defineLin Huang
2016-07-12rockchip/rk3399: calculate clocks based on parent clock speedLin Huang
2016-07-12rockchip/rk3399: Clean up comments in sdram.cDerek Basehore
2016-07-07soc: Remove newline from `CHIP_NAME`Paul Menzel
2016-06-24rk3399: clean up sdram controller initialization codeVadim Bendebury
2016-06-23rockchip/rk3399: fix sdram training issueLin Huang
2016-06-23rockchip/rk3399: Clean up voltage rail settingsLin Huang
2016-06-23rk3399: add definition for SP0 iomuxVadim Bendebury
2016-06-12rockchip: rk3399: pass board specific message to BL31Lin Huang
2016-06-12Kconfig: Set VBOOT_OPROM_MATTERS for relevant non-x86 devicesJulius Werner
2016-06-12rockchip: gru: Add USB DRD DWC3 controller supportLiangfeng Wu
2016-06-08rockchip: rk3399: Add support i2sXing Zheng
2016-06-08gru: kevin: configure board GPIOsVadim Bendebury
2016-06-08rk3399: add ability to configure SPI5Vadim Bendebury
2016-06-07rockchip: gru: update the hynix lpddr3 config to run at 928MHzShunqian Zheng
2016-06-03rockchip: gru: enable eDP displayLin Huang
2016-06-03rockchip: rk3399: initialize display for eDPShunqian Zheng
2016-05-18rockchip: rk3399: enable sdhci clk for emmcShunqian Zheng
2016-05-18rockchip: rk3399: configure emmc clkLin Huang
2016-05-18rk3399: add GPIO register definitions for SDMMC0Vadim Bendebury
2016-05-18rockchip: rk3399: improve sdram driverLin Huang
2016-05-18rockchip: rk3399: add tsadc driverShunqian Zheng
2016-05-18rockchip: rk3399: add routines to set vop clocksShunqian Zheng
2016-05-09drivers/uart: Use uart_platform_refclk for all UART modelsLee Leahy
2016-05-09rockchip/rk3399: protect the DRAM address for atfCaesar Wang
2016-05-09google/gru: enable pp1500 and pp3000 rails as soon as possibleVadim Bendebury
2016-05-09rockchip/rk3399: Set all 4 DVFS voltage rails to 1.1V @300kHzVadim Bendebury
2016-05-09rockchip: rk3399: support saradcLin Huang
2016-05-09rockchip: rk3399: enable arm trust firmwareLin Huang
2016-05-09rockchip: make sure sdram top does not spill into MMIO spaceLin Huang
2016-05-09rockchip: rk3399: add sdram driverLin Huang
2016-05-09rockchip: rk3399: init the secure settingShunqian Zheng
2016-05-09rockchip: rk3399: enable pwmLin Huang
2016-05-09rockchip: rk3399: add gpio driverVadim Bendebury
2016-05-09rockchip: rk3399: add i2c clock driverhuang lin
2016-05-09rockchip: rk3399: add spi clock driverShunqian Zheng
2016-05-09rockchip: rk3399: enable mmuLin Huang
2016-05-09rockchip: rk3399: add functions to configure ddrc freqShunqian Zheng
2016-05-09rockchip: rk3399: support basic clock driverLin Huang
2016-05-09rockchip: rk3399: use static pointers to regs as they compile to faster codeVadim Bendebury
2016-05-09rockchip: rk3399: add the GRF header fileLin Huang
2016-05-09rockchip: rk3399: add simplest sdram to fix compiling errorShunqian Zheng
2016-05-09rockchip/rk*: replace UART special snowflake with standard driverPatrick Georgi
2016-04-16google/gru: Incorporate feedback to #14279Patrick Georgi
2016-04-13rockchip/rk3399: Add a stub implementation of the rk3399 SOChuang lin