summaryrefslogtreecommitdiff
path: root/src/soc/nvidia/tegra124
AgeCommit message (Expand)Author
2015-04-21arm(64): Replace write32() and friends with writel()Julius Werner
2015-04-18vboot: make vboot2_verify_firmware returnDaisuke Nojiri
2015-04-17chromeos: Move memlayout.h/symbols.h into common directoryJulius Werner
2015-04-17uart: pass register width in the coreboot tableVadim Bendebury
2015-04-14CBFS: Automate ROM image layout and remove hardcoded offsetsJulius Werner
2015-04-10vboot: move vboot files to designated directoryDaisuke Nojiri
2015-04-10gpio: Extend common GPIO header, simplify function namesJulius Werner
2015-04-08timer: Add generic udelay() implementationAaron Durbin
2015-04-08tegra124: Change all SoC headers to <soc/headername.h> systemJulius Werner
2015-04-06New mechanism to define SRAM/memory map with automatic bounds checkingJulius Werner
2015-04-04tegra124: use known-good drive for fast-train onlyNeil Chen
2015-04-04tegra124: add support for full DP link trainingNeil Chen
2015-04-03tegra124: implement platform_prog_run()Aaron Durbin
2015-04-02Nyans: replace cpu_reset with hard_resetDaisuke Nojiri
2015-03-31cbfs: remove cbfs_core.h includesAaron Durbin
2015-03-26tegra: Clean up USB codeFurquan Shaikh
2015-03-24vboot2: separate verstage from bootblockDaisuke Nojiri
2015-03-24nyans: reduce code duplication in bootblock and romstagesDaisuke Nojiri
2015-03-23vboot2: read secdata and nvdataDaisuke Nojiri
2015-03-21tegra124: switch to stopwatch APIAaron Durbin
2015-03-17coreboot classes: Add dynamic classes to corebootFurquan Shaikh
2015-03-13nyan: Remove broken setup_display() from romstageJulius Werner
2015-03-02coreboot arm: Define function for setting cntfrq registerFurquan Shaikh
2015-02-25tegra124: Clean up ARM UART driver buildMarc Jones
2015-02-17T124: perform ram_repair when CPU rail is powered on in warmbootYen Lin
2015-02-17T124: perform ram_repair when CPU rail is powered on in coldbootYen Lin
2015-02-17tegra124: Correct cpu power on sequence and CPUPWRGOOD_TIMEJimmy Zhang
2015-01-27CBMEM: Always use DYNAMIC_CBMEMKyösti Mälkki
2015-01-27vboot2: implement select_firmware for pre-romstage verificationDaisuke Nojiri
2015-01-27vboot2: add verstageStefan Reinauer
2015-01-14Revert "vboot2: add verstage"Paul Menzel
2015-01-13vboot2: add verstageDaisuke Nojiri
2015-01-09tegra124: fix and fine tune the warm boot codeJoseph Lo
2015-01-04tegra124: configure DP with correct pixel clockVince Hsu
2014-12-30i2c: Add software_i2c driver for I2C debugging and emulationJulius Werner
2014-12-30tegra124: Active dc/sor register change immediatelyVince Hsu
2014-12-30tegra124: display clock should be initialized before any accessVince Hsu
2014-12-26tegra124: Add a utility function to read the cause of the most recent reset.Gabe Black
2014-12-19nyan*: Add fast link training functionsJimmy Zhang
2014-12-17tegra124: modify panel init sequenceKen Chang
2014-12-17nyan*: enable CLAMP_INPUTSKen Chang
2014-12-17ARM: Use LPAE for Virtual Address TranslationDaisuke Nojiri
2014-12-17tegra124: change PLLD VCO calculation algorithmKen Chang
2014-12-16tegra124: Allow "best" PLLD parameters for unmatched pixel clock.Hung-Te Lin
2014-12-16tegra124: Always enable DC when attaching SOR.Hung-Te Lin
2014-12-16nyan*: debug: Add sor registers dump functionJimmy Zhang
2014-12-16tegra124: clock: Enforce PLL constraints for VCO and CFJulius Werner
2014-12-16nyan*: Set SOR_NV_PDISP_SOR_DP_SPARE0 registerJimmy Zhang
2014-12-16nyan*: merge a couple of sor setting difference from kernel driverJimmy Zhang
2014-12-16nyan*: Apply sor fix from kernel dc driverJimmy Zhang
2014-12-16tegra124: Initialize display panel by EDID.Hung-Te Lin
2014-12-15tegra124: set MOT bit for I2C-over-AUXKen Chang
2014-12-15tegra124: Setup clock PLLD by approximating display panel pixel clock.Hung-Te Lin
2014-12-15tegra124: Release DMA channel at end of transactionDavid Hendricks
2014-12-15tegra124: Use correct mask for APB bus widthDavid Hendricks
2014-12-15nyan: Enable the cbmem console on nyan and allocate space for it in SRAM.Gabe Black
2014-12-15tegra124: More improvements to the clock initialization macros.Gabe Black
2014-12-15tegra: spi: Read the command1 register to ensure the write to it completes.Gabe Black
2014-12-15tegra124: A couple clock fixes.Gabe Black
2014-12-15tegra124: Add tegra_dc_i2c_aux_read to allow reading EDID.Hung-Te Lin
2014-12-15tegra124: Skip display init when vboot says we don't need it.Gabe Black
2014-12-09spi: Eliminate the spi_cs_activate and spi_cs_deactivate functions.Gabe Black
2014-12-09spi: Factor EC protocol details out of the SPI drivers.Gabe Black
2014-12-02Replace hlt with halt()Patrick Georgi
2014-11-18tegra124: remove spurious error messagePatrick Georgi
2014-11-18tegra124: actually parse is_lvdsPatrick Georgi
2014-11-14tegra124: allow tegra124 devices to run vboot rmoduleAaron Durbin
2014-11-14tegra124: i2c: Reset the controller when there's an error.Gabe Black
2014-11-14tegra124: fix the dangerous VPR write orderJoseph Lo
2014-11-14tegra124: Add some functions for resetting peripherals.Gabe Black
2014-11-14t124: Clean up display init functionsJimmy Zhang
2014-11-13arm: Put assembly functions into separate sectionsJulius Werner
2014-11-13tegra124: Add a macro specifically for configuring the I2C controller clocks.Gabe Black
2014-11-13tegra124: Fix some bugs in the clock configuration macros.Gabe Black
2014-11-13t124: Skip PLLP init to 408MHzJimmy Zhang
2014-11-13t124: nyan: Enable lock bit on pllJimmy Zhang
2014-11-13tegra124: fix OSC initialization on LP0 resumeAndrew Bresticker
2014-11-13tegra124: fix PLLU parametersAndrew Bresticker
2014-11-13tegra124: Make the PLLX frequency selectable by model.Gabe Black
2014-11-12tegra124: enable JTAG in Security ModeJimmy Zhang
2014-11-12tegra124: Program PWM1 to drive panel backlightAndrew Chew
2014-11-12tegra124: Fix PWM pinmux functionsAndrew Chew
2014-11-12tegra124: Add PWM base addressAndrew Chew
2014-11-12tegra124: nyan: Keep in memory structures below 4GB.Gabe Black
2014-11-09arm: Thumb ALL the things!Julius Werner
2014-11-01{cpu,soc}: Use DEVICE_NOOP macro over dummy symbolEdward O'Callaghan
2014-10-22tegra/nyan*: sdram updatesTom Warren
2014-10-16uarts: 32/64 cleanupRonald G. Minnich
2014-09-22tegra124/nyan: memory and display updatesAndrew Bresticker
2014-09-22arm: Move libgcc assembly macros to arch/asm.hJulius Werner
2014-09-22Add check_member macro to allow clean and easy struct offset checkingJulius Werner
2014-09-17spi: add Kconfig variable for dual-output read enableDavid Hendricks
2014-09-13arm: Move exception_init() close to console_init()Julius Werner
2014-09-13tegra124/nyan: display, clock, and other updatesJulius Werner
2014-09-12tegra124/nyan: various fixes and additionsHung-Te Lin
2014-09-11tegra124/nyan: rougly stable code baseGabe Black
2014-09-10tegra124: Make tegra124 compilable with serial turned off.Gabe Black
2014-09-10nyan: Use the new pinmux functions as part of UART setup.Gabe Black
2014-09-10nvidia-cbootimage: integrate into coreboot makeIsaac Christensen
2014-09-09arm: Update a stale comment in bootblock .S filesDavid Hendricks
generated by cgit v1.2.3 (git 2.25.1) at 2024-11-24 22:59:42 +0000