| Age | Commit message (Collapse) | Author |
|---|
|
The console interface changed in upstream, and the
driver didn't reflect that yet.
This wasn't obvious because the driver wasn't compiled
at all.
Change-Id: Id18391e62e7ebd8f5fc929838ce27bf414e364f9
Signed-off-by: Patrick Georgi <pgeorgi@google.com>
Reviewed-on: http://review.coreboot.org/9165
Tested-by: build bot (Jenkins)
Reviewed-by: Aaron Durbin <adurbin@google.com>
|
|
Use the run_ramstage() function to load and run ramstage.
Change-Id: I783801bf506fa2f9608eefe1cd20257292c80af5
Signed-off-by: Aaron Durbin <adurbin@chromium.org>
Reviewed-on: http://review.coreboot.org/9148
Reviewed-by: Patrick Georgi <pgeorgi@google.com>
Tested-by: build bot (Jenkins)
|
|
The Serial Peripheral Flash Interface (SPFI) block allows
communication with various devices over the SPI bus.
It uses a configurable transaction interface and it clocks
the bus according to the configured command, address, gap (aka
dummy) and data lengths.
This controller requires the SPI_ATOMIC_SEQUENCING flag set
(write and read done in the same transaction) as it cannot
directly control CS and will assert/de-assert CS at the
beginning/end of a transaction itself.
Note that the size of any transfer cannot be greater than
64KB - 1, as this is configured in a 16-bit field.
The SOC has 2 SPFI interfaces each of them providing 5 slave select
lines. SPFI 0 supports single and dual modes, SPFI 1 supports
single, dual and quad modes.
For SPFI interface 0:
- The block needs the system PLL and the following top level
SPI clock registers to be set:
- CR_cr_top_spi0clkinternal_CTRL[2:0] with division value
- CR_MIPS_CLOCK_GATE[19]: bit cr_top_SPI0CLKOUT_MIPS set
- CR_cr_top_SPI0CLKOUT_CTRL[6:0] with division value
- The following MFIO configuration parameters are also required:
Signal name Pad name MFIO mode
spim0_d0_txd MFIO_MIPS_10 0
spim0_d1_rxd MFIO_MIPS_9 0
spim0_mclk MFIO_MIPS_8 0
spim0_cs0 MFIO_MIPS_2 1
spim0_cs1 MFIO_MIPS_1 1
spim0_cs2 MFIO_MIPS_55 1
MFIO_MIPS_28 1
spim0_cs3 MFIO_MIPS_56 1
MFIO_MIPS_29 1
spim0_cs4 MFIO_MIPS_57 1
MFIO_MIMPS_30 1
For SPFI interface 1:
- The block needs the system PLL and the following top level
SPI clock registers to be set:
- CR_cr_top_spi1clkinternal_CTRL[2:0] with division value
- CR_MIPS_CLOCK_GATE[20]: bit cr_top_SPI1CLKOUT_MIPS set
- CR_cr_top_SPI1CLKOUT_CTRL[6:0] with division value
- The following MFIO configuration parameters are also required:
Signal name Pad name MFIO mode
spim1_d0_txd MFIO_MIPS_5 0
spim1_d1_rxd MFIO_MIPS_4 0
spim1_mclk MFIO_MIPS_3 0
spim1_d2 MFIO_MIPS_6 0
spim1_d3 MFIO_MIPS_7 0
spim1_cs0 MFIO_MIPS_0 0
spim1_cs1 MFIO_MIPS_1 0
MFIO_MIPS_58 1
spim1_cs2 MFIO_MIPS_2 0
MFIO_MIPS_55 2
MFIO_MIPS_31 1
spim1_cs3 MFIO_MIPS_56 2
spim1_cs4 MFIO_MIPS_57 2
BUG=chrome-os-partner:31438, chrome-os-partner:32441
TEST=Tested as bare-metal driver on Pistachio FPGA
Change-Id: I3b3e4475976e6fba58cef93b12d997ec5cb26341
Signed-off-by: Patrick Georgi <pgeorgi@chromium.org>
Original-Commit-Id: 621849942e27f7d6cf2c8ade7f2c4d18d2318b91
Original-Change-Id: Ib257eb6236bd2895281175871b4ab979660f1239
Original-Signed-off-by: Ionela Voinescu <ionela.voinescu@imgtec.com>
Original-Reviewed-on: https://chromium-review.googlesource.com/217320
Original-Reviewed-by: Vadim Bendebury <vbendeb@chromium.org>
Reviewed-on: http://review.coreboot.org/9049
Tested-by: build bot (Jenkins)
Reviewed-by: Stefan Reinauer <stefan.reinauer@coreboot.org>
|
|
Danube has become Pistachio, let's rename all instances where this SOC
is mentioned.
BUG=none
TEST=board urara still builds
Change-Id: Iea91419121eb6ab5665c2f9f95e82f461905268e
Signed-off-by: Patrick Georgi <pgeorgi@chromium.org>
Original-Commit-Id: 58696cc7c77a70dca2bfd512d695d143e1097a78
Original-Change-Id: Ie5ede401c4f69ed5d832a9eabac008eeac6db62d
Original-Signed-off-by: Vadim Bendebury <vbendeb@chromium.org>
Original-Reviewed-on: https://chromium-review.googlesource.com/220401
Original-Reviewed-by: Andrew Bresticker <abrestic@chromium.org>
Reviewed-on: http://review.coreboot.org/9048
Tested-by: build bot (Jenkins)
Reviewed-by: Stefan Reinauer <stefan.reinauer@coreboot.org>
|
|
Bootblock stack on Danube should be SRAM and defined separately from
the rest of the coreboot stack. The actual coreboot stack will be
defined later.
The top of the stack should be above the bottom, as the stack grows
towards lower addresses.
BUG=chrome-os-partner:31438
TEST=ran bootblock on simulator under codescape, observed stack
properly initialized.
Change-Id: I43d2bae5f85a09a95ca0103b253399bd92555aef
Signed-off-by: Patrick Georgi <pgeorgi@chromium.org>
Original-Commit-Id: e02724cb4b30990ebaa631dabb45917af29d6437
Original-Change-Id: I3c37c8b5a1c0e7fd19411558a8f6d899fc283191
Original-Signed-off-by: Vadim Bendebury <vbendeb@chromium.org>
Original-Reviewed-on: https://chromium-review.googlesource.com/218732
Original-Reviewed-by: Aaron Durbin <adurbin@chromium.org>
Reviewed-on: http://review.coreboot.org/8767
Tested-by: build bot (Jenkins)
Reviewed-by: Stefan Reinauer <stefan.reinauer@coreboot.org>
Reviewed-by: Paul Menzel <paulepanter@users.sourceforge.net>
|
|
Actual timer support is not yet available for Danube, it will be added
soon. For now, just to make the target build, modify it to use
GENERIC_UDELAY and HAVE_MONOTONIC_TIMER configuration option.
BUG=none
TEST=the target builds again
Change-Id: Iad1ceb966d5dbc8687b966be4d2506c8f92eba5a
Signed-off-by: Patrick Georgi <pgeorgi@chromium.org>
Original-Commit-Id: 261837539fb5a31f96e682edbcbbbc0e588f2750
Original-Change-Id: Ie3289eace9d2baadd01bd641b5dffc635ac80c0f
Original-Signed-off-by: Vadim Bendebury <vbendeb@chromium.org>
Original-Reviewed-on: https://chromium-review.googlesource.com/220395
Original-Reviewed-by: Aaron Durbin <adurbin@chromium.org>
Reviewed-on: http://review.coreboot.org/8765
Tested-by: build bot (Jenkins)
Reviewed-by: Stefan Reinauer <stefan.reinauer@coreboot.org>
|
|
Romstage initialization code does not need to be board specific, keep
it in the SOC directory. Should there be a need for the board specific
code, it can be added later.
BUG=chrome-os-partner:31438
TEST=with upcoming patches, the urara board coreboot builds fine
Change-Id: Ib619fa9313d463ded13e9259e50bb5aeaab4fb05
Signed-off-by: Patrick Georgi <pgeorgi@chromium.org>
Original-Commit-Id: 2c08977aaa5e9b5da29359d1920d7d8b61ce86d3
Original-Change-Id: I27e2d225bd36c42ccd29128d0ea9a970566c02af
Original-Signed-off-by: Vadim Bendebury <vbendeb@chromium.org>
Original-Reviewed-on: https://chromium-review.googlesource.com/215992
Original-Reviewed-by: Aaron Durbin <adurbin@chromium.org>
Reviewed-on: http://review.coreboot.org/8764
Tested-by: build bot (Jenkins)
Reviewed-by: Stefan Reinauer <stefan.reinauer@coreboot.org>
|
|
These modules are necessary to resolve external names when building
the board image. These are just skeletons for now which will be filled
later.
BUG=chrome-os-partner:31438
TEST=when config is enabled, emerge-urara coreboot succeeds. more
extensive testing to come later
Change-Id: I0fcb5d33187172ecac77041425402b33e89e8944
Signed-off-by: Patrick Georgi <pgeorgi@chromium.org>
Original-Commit-Id: 94ec79b0ab872f5c5fe7db5bef5fdabf77d6b3b6
Original-Change-Id: I69cc178976a910ebf8031ed9ac9ad67b4cc0878a
Original-Signed-off-by: Vadim Bendebury <vbendeb@chromium.org>
Original-Reviewed-on: https://chromium-review.googlesource.com/215678
Original-Reviewed-by: Aaron Durbin <adurbin@chromium.org>
Reviewed-on: http://review.coreboot.org/8763
Tested-by: build bot (Jenkins)
Reviewed-by: Stefan Reinauer <stefan.reinauer@coreboot.org>
|
|
Add build infrastructure and basic support code for the ImgTec Danube
SoC. This support is sufficient to run on a simulator.
BUG=chrome-os-partner:31438
TEST=none yet
Change-Id: I59e36589765bf06b075fd4850215a0ef71246bb1
Signed-off-by: Patrick Georgi <pgeorgi@chromium.org>
Original-Commit-Id: 881278d7fbb8e6803bc8f6f9e84c64640b097401
Original-Change-Id: Ia7ed7288b13085db7ff37b5ad75d978b6137f958
Original-Signed-off-by: Paul Burton <paul.burton@imgtec.com>
Original-Signed-off-by: Vadim Bendebury <vbendeb@chromium.org>
Original-Reviewed-on: https://chromium-review.googlesource.com/207974
Original-Reviewed-by: Aaron Durbin <adurbin@chromium.org>
Reviewed-on: http://review.coreboot.org/8762
Tested-by: build bot (Jenkins)
Reviewed-by: Patrick Georgi <pgeorgi@google.com>
|
