Age | Commit message (Collapse) | Author |
|
This is necessary to support generic gpio interface in src/lib. This
file will be later populated with more GPIO definitions.
BRANCH=none
BUG=chrome-os-partner:31438
TEST=none
Change-Id: I3fa93f1b3b1ce99d921bbfb378b3f7ae4eb652c2
Signed-off-by: Stefan Reinauer <reinauer@chromium.org>
Original-Commit-Id: 26f564ee10a770d57cb4af0a8ab5a264aaf1a7cd
Original-Change-Id: I68c9c3a28fcc747575436b502cb25b31afed8700
Original-Signed-off-by: Vadim Bendebury <vbendeb@chromium.org>
Original-Reviewed-on: https://chromium-review.googlesource.com/226181
Original-Reviewed-by: Aaron Durbin <adurbin@chromium.org>
Reviewed-on: http://review.coreboot.org/9184
Tested-by: build bot (Jenkins)
Reviewed-by: Ronald G. Minnich <rminnich@gmail.com>
|
|
Urara CBFS header configuration is broken. CBFS header needs to be
right above the bootblock, and the CBFS data - 0x100 bytes above, to
allow room for proper CBFS wrapper structures.
Ideally only the header offset should be specified (and even that
could be derived from the bootblock size). But this is a more generic
problem to be addressed with different architectures' image layout
requirements in mind.
BRANCH=none
BUG=chrome-os-partner:31438
TEST=coreboot image passes the integrity check now (it was failing
before because CBGS header was overlaying the bootblock)
$ FEATURES=noclean emerge-urara coreboot
$ /build/urara/tmp/portage/sys-boot/coreboot-9999/work/coreboot-9999/build/util/bimgtool/bimgtool \
/build/urara/firmware/coreboot.rom.serial
$ cbfstool /build/urara/firmware/coreboot.rom.serial print
coreboot.rom.serial: 1024 kB, bootblocksize 9956, romsize 1048576, offset 0x4100
alignment: 64 bytes, architecture: mips
Name Offset Type Size
fallback/romstage 0x4100 stage 7100
fallback/ramstage 0x5d00 stage 18995
config 0xa780 raw 2452
(empty) 0xb140 null 1003096
Change-Id: Id615bdcc6261dea9f36a409bd90f1e4764353bb9
Signed-off-by: Stefan Reinauer <reinauer@chromium.org>
Original-Commit-Id: 8a0115963aa7460e4c7255ab8508d7d52d67fb67
Original-Change-Id: Id200ab5421661ef39b7c7713e931c39153fdc8be
Original-Signed-off-by: Vadim Bendebury <vbendeb@chromium.org>
Original-Reviewed-on: https://chromium-review.googlesource.com/227523
Original-Reviewed-by: Stefan Reinauer <reinauer@chromium.org>
Reviewed-on: http://review.coreboot.org/9187
Tested-by: build bot (Jenkins)
Reviewed-by: Ronald G. Minnich <rminnich@gmail.com>
|
|
The console interface changed in upstream, and the
driver didn't reflect that yet.
This wasn't obvious because the driver wasn't compiled
at all.
Change-Id: Id18391e62e7ebd8f5fc929838ce27bf414e364f9
Signed-off-by: Patrick Georgi <pgeorgi@google.com>
Reviewed-on: http://review.coreboot.org/9165
Tested-by: build bot (Jenkins)
Reviewed-by: Aaron Durbin <adurbin@google.com>
|
|
Use the run_ramstage() function to load and run ramstage.
Change-Id: I783801bf506fa2f9608eefe1cd20257292c80af5
Signed-off-by: Aaron Durbin <adurbin@chromium.org>
Reviewed-on: http://review.coreboot.org/9148
Reviewed-by: Patrick Georgi <pgeorgi@google.com>
Tested-by: build bot (Jenkins)
|
|
The Serial Peripheral Flash Interface (SPFI) block allows
communication with various devices over the SPI bus.
It uses a configurable transaction interface and it clocks
the bus according to the configured command, address, gap (aka
dummy) and data lengths.
This controller requires the SPI_ATOMIC_SEQUENCING flag set
(write and read done in the same transaction) as it cannot
directly control CS and will assert/de-assert CS at the
beginning/end of a transaction itself.
Note that the size of any transfer cannot be greater than
64KB - 1, as this is configured in a 16-bit field.
The SOC has 2 SPFI interfaces each of them providing 5 slave select
lines. SPFI 0 supports single and dual modes, SPFI 1 supports
single, dual and quad modes.
For SPFI interface 0:
- The block needs the system PLL and the following top level
SPI clock registers to be set:
- CR_cr_top_spi0clkinternal_CTRL[2:0] with division value
- CR_MIPS_CLOCK_GATE[19]: bit cr_top_SPI0CLKOUT_MIPS set
- CR_cr_top_SPI0CLKOUT_CTRL[6:0] with division value
- The following MFIO configuration parameters are also required:
Signal name Pad name MFIO mode
spim0_d0_txd MFIO_MIPS_10 0
spim0_d1_rxd MFIO_MIPS_9 0
spim0_mclk MFIO_MIPS_8 0
spim0_cs0 MFIO_MIPS_2 1
spim0_cs1 MFIO_MIPS_1 1
spim0_cs2 MFIO_MIPS_55 1
MFIO_MIPS_28 1
spim0_cs3 MFIO_MIPS_56 1
MFIO_MIPS_29 1
spim0_cs4 MFIO_MIPS_57 1
MFIO_MIMPS_30 1
For SPFI interface 1:
- The block needs the system PLL and the following top level
SPI clock registers to be set:
- CR_cr_top_spi1clkinternal_CTRL[2:0] with division value
- CR_MIPS_CLOCK_GATE[20]: bit cr_top_SPI1CLKOUT_MIPS set
- CR_cr_top_SPI1CLKOUT_CTRL[6:0] with division value
- The following MFIO configuration parameters are also required:
Signal name Pad name MFIO mode
spim1_d0_txd MFIO_MIPS_5 0
spim1_d1_rxd MFIO_MIPS_4 0
spim1_mclk MFIO_MIPS_3 0
spim1_d2 MFIO_MIPS_6 0
spim1_d3 MFIO_MIPS_7 0
spim1_cs0 MFIO_MIPS_0 0
spim1_cs1 MFIO_MIPS_1 0
MFIO_MIPS_58 1
spim1_cs2 MFIO_MIPS_2 0
MFIO_MIPS_55 2
MFIO_MIPS_31 1
spim1_cs3 MFIO_MIPS_56 2
spim1_cs4 MFIO_MIPS_57 2
BUG=chrome-os-partner:31438, chrome-os-partner:32441
TEST=Tested as bare-metal driver on Pistachio FPGA
Change-Id: I3b3e4475976e6fba58cef93b12d997ec5cb26341
Signed-off-by: Patrick Georgi <pgeorgi@chromium.org>
Original-Commit-Id: 621849942e27f7d6cf2c8ade7f2c4d18d2318b91
Original-Change-Id: Ib257eb6236bd2895281175871b4ab979660f1239
Original-Signed-off-by: Ionela Voinescu <ionela.voinescu@imgtec.com>
Original-Reviewed-on: https://chromium-review.googlesource.com/217320
Original-Reviewed-by: Vadim Bendebury <vbendeb@chromium.org>
Reviewed-on: http://review.coreboot.org/9049
Tested-by: build bot (Jenkins)
Reviewed-by: Stefan Reinauer <stefan.reinauer@coreboot.org>
|
|
Danube has become Pistachio, let's rename all instances where this SOC
is mentioned.
BUG=none
TEST=board urara still builds
Change-Id: Iea91419121eb6ab5665c2f9f95e82f461905268e
Signed-off-by: Patrick Georgi <pgeorgi@chromium.org>
Original-Commit-Id: 58696cc7c77a70dca2bfd512d695d143e1097a78
Original-Change-Id: Ie5ede401c4f69ed5d832a9eabac008eeac6db62d
Original-Signed-off-by: Vadim Bendebury <vbendeb@chromium.org>
Original-Reviewed-on: https://chromium-review.googlesource.com/220401
Original-Reviewed-by: Andrew Bresticker <abrestic@chromium.org>
Reviewed-on: http://review.coreboot.org/9048
Tested-by: build bot (Jenkins)
Reviewed-by: Stefan Reinauer <stefan.reinauer@coreboot.org>
|