|
The Serial Peripheral Flash Interface (SPFI) block allows
communication with various devices over the SPI bus.
It uses a configurable transaction interface and it clocks
the bus according to the configured command, address, gap (aka
dummy) and data lengths.
This controller requires the SPI_ATOMIC_SEQUENCING flag set
(write and read done in the same transaction) as it cannot
directly control CS and will assert/de-assert CS at the
beginning/end of a transaction itself.
Note that the size of any transfer cannot be greater than
64KB - 1, as this is configured in a 16-bit field.
The SOC has 2 SPFI interfaces each of them providing 5 slave select
lines. SPFI 0 supports single and dual modes, SPFI 1 supports
single, dual and quad modes.
For SPFI interface 0:
- The block needs the system PLL and the following top level
SPI clock registers to be set:
- CR_cr_top_spi0clkinternal_CTRL[2:0] with division value
- CR_MIPS_CLOCK_GATE[19]: bit cr_top_SPI0CLKOUT_MIPS set
- CR_cr_top_SPI0CLKOUT_CTRL[6:0] with division value
- The following MFIO configuration parameters are also required:
Signal name Pad name MFIO mode
spim0_d0_txd MFIO_MIPS_10 0
spim0_d1_rxd MFIO_MIPS_9 0
spim0_mclk MFIO_MIPS_8 0
spim0_cs0 MFIO_MIPS_2 1
spim0_cs1 MFIO_MIPS_1 1
spim0_cs2 MFIO_MIPS_55 1
MFIO_MIPS_28 1
spim0_cs3 MFIO_MIPS_56 1
MFIO_MIPS_29 1
spim0_cs4 MFIO_MIPS_57 1
MFIO_MIMPS_30 1
For SPFI interface 1:
- The block needs the system PLL and the following top level
SPI clock registers to be set:
- CR_cr_top_spi1clkinternal_CTRL[2:0] with division value
- CR_MIPS_CLOCK_GATE[20]: bit cr_top_SPI1CLKOUT_MIPS set
- CR_cr_top_SPI1CLKOUT_CTRL[6:0] with division value
- The following MFIO configuration parameters are also required:
Signal name Pad name MFIO mode
spim1_d0_txd MFIO_MIPS_5 0
spim1_d1_rxd MFIO_MIPS_4 0
spim1_mclk MFIO_MIPS_3 0
spim1_d2 MFIO_MIPS_6 0
spim1_d3 MFIO_MIPS_7 0
spim1_cs0 MFIO_MIPS_0 0
spim1_cs1 MFIO_MIPS_1 0
MFIO_MIPS_58 1
spim1_cs2 MFIO_MIPS_2 0
MFIO_MIPS_55 2
MFIO_MIPS_31 1
spim1_cs3 MFIO_MIPS_56 2
spim1_cs4 MFIO_MIPS_57 2
BUG=chrome-os-partner:31438, chrome-os-partner:32441
TEST=Tested as bare-metal driver on Pistachio FPGA
Change-Id: I3b3e4475976e6fba58cef93b12d997ec5cb26341
Signed-off-by: Patrick Georgi <pgeorgi@chromium.org>
Original-Commit-Id: 621849942e27f7d6cf2c8ade7f2c4d18d2318b91
Original-Change-Id: Ib257eb6236bd2895281175871b4ab979660f1239
Original-Signed-off-by: Ionela Voinescu <ionela.voinescu@imgtec.com>
Original-Reviewed-on: https://chromium-review.googlesource.com/217320
Original-Reviewed-by: Vadim Bendebury <vbendeb@chromium.org>
Reviewed-on: http://review.coreboot.org/9049
Tested-by: build bot (Jenkins)
Reviewed-by: Stefan Reinauer <stefan.reinauer@coreboot.org>
|
