summaryrefslogtreecommitdiff
path: root/src/mainboard
AgeCommit message (Expand)Author
2015-04-06global: Refactor get_option usageVarad Gautam
2015-04-05mainboard/lenovo/x201: correct sata_port_mapAlexander Couzens
2015-04-05intel/nehalem: rename copypasted smi finalizer functionAlexander Couzens
2015-04-04rk3288: set cpu frequency up to 1.8GHzhuang lin
2015-04-04veyron_pinky/rk3288: Use KHz, MHz and GHz constantsJulius Werner
2015-04-04samus: Disable USB Port 5Duncan Laurie
2015-04-04samus: Add new memory typeDuncan Laurie
2015-04-04samus: Set codec PDM clock output to 3MHzBen Zhang
2015-04-04samus: Change touchscreen bootloader mode i2c addressDuncan Laurie
2015-04-04samus: Enable GSPI0 interfaceDuncan Laurie
2015-04-04samus: Enable GPIO9 as touchpad wakeDuncan Laurie
2015-04-04samus: Update thermal max for broadwellDuncan Laurie
2015-04-04samus: Assign GPIO2 to HP_AMP_SHDN_LBen Zhang
2015-04-04samus: Make codec interrupt active highBen Zhang
2015-04-04samus: Add codec platform data for jack detectBen Zhang
2015-04-04samus: Change GPIO controller label to INT3437:00Duncan Laurie
2015-04-04samus: Enable update screen for software syncDuncan Laurie
2015-04-04samus: Add smbios_mainboard_version to define board versionDuncan Laurie
2015-04-04samus: Add codec platform info in ACPIDuncan Laurie
2015-04-04Drop (empty) google/snow mainboard directoryStefan Reinauer
2015-04-04rk3288: Pass SPI bus speed in as parameter to init functionDavid Hendricks
2015-04-02pinky: Move some init to mainboard bootblockDavid Hendricks
2015-04-02rk3288/pinky: Move uart address to mainboard KconfigDavid Hendricks
2015-04-02Nyans: replace cpu_reset with hard_resetDaisuke Nojiri
2015-04-02urara: Configure UART line control to 8N1Ionela Voinescu
2015-04-02coreboot: rk3288: add new ddr config and support ddr3 freq up to 800mhzjinkun.hong
2015-04-02rockchip: support pwm regulatorhuang lin
2015-04-02rockchip: support i2c clock settinghuang lin
2015-04-02pinky: Force delay for EC SPI transfersDavid Hendricks
2015-04-02veyron_pinky: Add rev2 support, clean up mainboard.cJulius Werner
2015-04-02veyron: select rw romstage using vboot2Daisuke Nojiri
2015-04-02samus: Fix codec interrupt and add GPIO definesDuncan Laurie
2015-04-02samus: Clean up touch wake sourcesDuncan Laurie
2015-04-02samus: Fix and clean up GPIOs and EC info/eventsDuncan Laurie
2015-04-02samus: Ensure PD controller is in RO mode for recoveryDuncan Laurie
2015-04-02Samus: fix unused GPIO pinKenji Chen
2015-04-02pinky: Enable EC_SOFTWARE_SYNCDavid Hendricks
2015-04-02mainboard/asus/kfsn4-dre: Set maximum installable memory to 64GBTimothy Pearson
2015-04-01mainboard/supermicro/h8qme_fam10: Fix indentations and spellingTimothy Pearson
2015-04-01mainboards/amdfam10: Copy DIMM information to cbmem after romstageTimothy Pearson
2015-04-01mainboards: fix spd generationAaron Durbin
2015-04-01cbfs: correct types used for accessing filesAaron Durbin
2015-03-31cbfs: remove cbfs_core.h includesAaron Durbin
2015-03-30google/veyron_pinky: Don't auto select CHROMEOSAaron Durbin
2015-03-30google/nyan_blaze: Don't auto select CHROMEOSAaron Durbin
2015-03-30Update hex values to CBFS binary name types in MakefilesMartin Roth
2015-03-30emulation/imgvp-pistachio: Drop boardPatrick Georgi
2015-03-29mainboard/asus/kfsn4-dre: Enable BIOS recovery jumperTimothy Pearson
2015-03-28pistachio: don't open code ramstage loadingAaron Durbin
2015-03-28storm: fix SW_RESET signal polarityVadim Bendebury
2015-03-28storm: deassert SW_RESET signal at startupVadim Bendebury
2015-03-28storm: make sure board ID is calculated only onceVadim Bendebury
2015-03-28storm: reset TPM properly on proto0Vadim Bendebury
2015-03-28storm: supply vboot GPIO settings in coreboot tableVadim Bendebury
2015-03-28blaze: update EMC BCT tableNeil Chen
2015-03-28ryu: Add padconfigs for volup and voldown buttonsFurquan Shaikh
2015-03-28rush: ryu: remove mainboard_add_memory_ranges()Aaron Durbin
2015-03-28tegra132/rush/ryu: Use CLK_RST_REG instead of &clk_rst->...Furquan Shaikh
2015-03-28Ryu: Move I2C6 init to ramstageTom Warren
2015-03-28Ryu: Rewrite I2C6 mux initTom Warren
2015-03-28rush: use generic spin table supportAaron Durbin
2015-03-28ryu: use generic spin tableAaron Durbin
2015-03-28rush: Get rid of coreboot setting up DMA areas for libpayloadFurquan Shaikh
2015-03-28ryu: Get rid of coreboot setting up DMA areas for libpayloadFurquan Shaikh
2015-03-28rush: Add cpu devices to devicetreeTom Warren
2015-03-28ryu: remove bring_up_secondary_cpu from devicetreeAaron Durbin
2015-03-27rk3288: Add GPIO() macroJulius Werner
2015-03-27pinky: Add mainboard-specific bootblock initDavid Hendricks
2015-03-27urara: use proper SOC nameVadim Bendebury
2015-03-27urara: introduce board skeletonVadim Bendebury
2015-03-27ryu: add cpus to device treeAaron Durbin
2015-03-27ryu: remove call to soc_configure_i2c6pad()Aaron Durbin
2015-03-27ryu: Remove old/unused BCT cfg filesTom Warren
2015-03-27ryu: fix power button polarityAaron Durbin
2015-03-27rush: use names for gpiosAaron Durbin
2015-03-27ryu: configure plld for display usageAaron Durbin
2015-03-27ryu: bring up secondary coreAaron Durbin
2015-03-27ryu: normalize board idAaron Durbin
2015-03-27ryu: initialize LTE modemBen Chan
2015-03-27ryu: use named bus numbers instead of literalsAaron Durbin
2015-03-27ryu: Add pad/funit init for i2c6 (audio codec, etc.)Tom Warren
2015-03-27samus: Update SPD with correct geometry and timingsDuncan Laurie
2015-03-27samus: Add PD MCU ACPI device and unmask host eventShawn Nematbakhsh
2015-03-27samus: Updates for EVT boardDuncan Laurie
2015-03-27samus: Switch to using broadwell platform ASLDuncan Laurie
2015-03-27samus: Enable WLAN wake GPIO in _PRWDuncan Laurie
2015-03-27samus: Fix some SPD geometry againDuncan Laurie
2015-03-27samus: Disable CMDPWR on broadwellKane Chen
2015-03-27samus: Update SPDDuncan Laurie
2015-03-26rush: Remove CHROMEOS defaultPatrick Georgi
2015-03-26ryu: enable external usb 2.0 portAaron Durbin
2015-03-26rush: Add usb support for rush in corebootFurquan Shaikh
2015-03-26ryu: convert hardware initialization to funit APIAaron Durbin
2015-03-26rush: support for DMA regionFurquan Shaikh
2015-03-26tegra: Clean up USB codeFurquan Shaikh
2015-03-26ryu: support for DMA regionAaron Durbin
2015-03-26rush: Convert rush initialization to use funitcfg apiFurquan Shaikh
2015-03-26t132: ryu: Correct how board id is retrievedJimmy Zhang
2015-03-26fix how to interpret board id read from gpiosDaisuke Nojiri
2015-03-26Restore name of the function reading tertiary GPIO statesVadim Bendebury
generated by cgit v1.2.3 (git 2.25.1) at 2024-12-27 06:32:18 +0000