Age | Commit message (Expand) | Author |
2010-04-14 | drop quite a lot of dead code that did nothing but produce warnings and make | Stefan Reinauer |
2010-04-09 | Drop the need for cpu_reset, it's really just a short cut to stage2. | Stefan Reinauer |
2010-04-09 | copy_and_run.c is not needed twice, and it is used on non-car too. | Stefan Reinauer |
2010-04-08 | Clean up fidvid files using indent. | Myles Watson |
2010-04-08 | Replace dual_core and quad_core CMOS (nvram) options with multi_core. Fix so... | Myles Watson |
2010-04-07 | move amd K8/Fam10 "bus detection" function prototypes to a common place. | Stefan Reinauer |
2010-04-07 | - unify use of SB_HT_CHAIN_UNITID_OFFSET_ONLY | Stefan Reinauer |
2010-03-31 | Drop \r\n and \n\r as both print_XXX and printk now do this internally. | Stefan Reinauer |
2010-03-31 | This patch drops arch/i386/lib/console.c and arch/i386/lib/console_print.c and | Stefan Reinauer |
2010-03-30 | - drop unneeded Makefile.inc | Stefan Reinauer |
2010-03-30 | drop USE_INIT from mainboard Kconfig files, it's already set in src/Kconfig | Stefan Reinauer |
2010-03-30 | unify cmos.layout wrt AMD extended configuration registers. | Stefan Reinauer |
2010-03-29 | This drops the ASSEMBLY define from romstage.c, too | Stefan Reinauer |
2010-03-29 | __PRE_RAM__ is now correctly specified in the Makefile. No need to hack it into | Stefan Reinauer |
2010-03-29 | This patch drops the coreboot CMOS checksum ranges from Kconfig because | Stefan Reinauer |
2010-03-29 | dualcore.h and quadcore.h are almost exactly the same. | Stefan Reinauer |
2010-03-28 | drop unneeded __ROMCC__ checks when the check for __PRE_RAM__ is more | Stefan Reinauer |
2010-03-22 | Fix all the format string warnings. | Myles Watson |
2010-03-22 | printk_foo -> printk(BIOS_FOO, ...) | Stefan Reinauer |
2010-03-18 | Remove remaining uses of | Patrick Georgi |
2010-03-18 | Rework boolean expression (DeMorgan and all) for | Patrick Georgi |
2010-03-18 | Remove fallback/normal handling in mainboards' | Patrick Georgi |
2010-03-17 | Remove failover/fallback/normal handling in mainboards' | Patrick Georgi |
2010-03-17 | remove more warnings, and fix some boards (watchdog.h) | Stefan Reinauer |
2010-03-13 | Fix supermicro/h8qme_fam10 by enabling SPD ROM properly. | Knut Kujat |
2010-03-11 | Replace clear_memory with memset. | Myles Watson |
2010-02-28 | disable AP_CODE_IN_CAR. The K8 code has an alternate code path to do the job, | Stefan Reinauer |
2010-02-28 | - Add config flag for boards that have their own fadt.c | Patrick Georgi |
2010-02-27 | - make HAVE_HARD_RESET match what newconfig did | Patrick Georgi |
2010-02-27 | This does the following: | Stefan Reinauer |
2010-02-25 | drop unused file | Stefan Reinauer |
2010-02-25 | Move the ldscripts logic to src/arch/i386/Makefile.inc | Patrick Georgi |
2010-02-25 | Unify crt0s setup to src/arch/i386/Makefile.inc. This variable | Patrick Georgi |
2010-02-24 | Several fixes to the supermicro/h8qme_fam10 board, so it | Knut Kujat |
2010-02-23 | Only handle code as "driver" that actually uses our driver | Patrick Georgi |
2010-02-15 | Various license header consistency fixes (trivial). | Uwe Hermann |
2010-02-09 | Move all the copies of the romstage.inc rule to | Patrick Georgi |
2010-02-08 | Clean up ACPI: | Patrick Georgi |
2010-02-08 | straighten naming scheme for application processor rom stage files. | Stefan Reinauer |
2010-02-08 | janitor task: unify and cleanup naming. | Stefan Reinauer |
2010-02-07 | newconfig is no more. | Patrick Georgi |
2010-02-03 | Supermicro H8QME-2+ (Fam10) whitespace fixes (trivial). | Uwe Hermann |
2010-02-03 | This patch adds the Supermicro H8QME-2+ (fam10) Motherboard with the | Knut Kujat |
2010-01-30 | * fix crt0s/ldscripts paths to fix out of tree build. | Stefan Reinauer |
2010-01-25 | More Kconfig changes to improve match with newconfig: | Patrick Georgi |
2010-01-25 | Align several kconfig options to match newconfig: | Patrick Georgi |
2010-01-18 | Move all IOAPIC selection to southbridges, and remove them | Patrick Georgi |
2010-01-06 | Kconfig builds all boards now. | Patrick Georgi |
2010-01-05 | * Explicitly add __PRE_RAM__ where it should be added. | Stefan Reinauer |
2009-12-02 | Trivial fixes for kconfig. They fix all non-fam10 build failures. | Myles Watson |
2009-11-27 | Eliminate special case id.inc/id.lds in favor of a configuration variable ID_... | Patrick Georgi |
2009-11-27 | Make newconfig and kconfig agree on MAINBOARD_PCI_SUBSYSTEM_{VENDOR,DEVICE}_ID | Patrick Georgi |
2009-11-06 | Remove drivers/pci/onboard. The only purpose was for option ROMs, which are | Myles Watson |
2009-11-06 | Drop all pre-CBFS rom_address entries in Config.lb/devicetree.cb. | Uwe Hermann |
2009-11-06 | Split the two usages of __ROMCC__: | Myles Watson |
2009-10-26 | Define some variables that were not defined. There are a couple left. | Myles Watson |
2009-10-24 | Major cleanups of the hard_reset() code and config in coreboot. | - supermicro/x6dhe_g/auto.c |
2009-10-24 | move all register fram definitions to arch/register.h | Stefan Reinauer |
2009-10-23 | Drop dead K8_SCAN_PCI_BUS code. It's a bad idea to scan the PCI busses before | Myles Watson |
2009-10-20 | Remove CONFIG_CPU_AMD_FAM10 & CONFIG_CPU_AMDK8 from mainboards. They should be | Myles Watson |
2009-10-20 | Fix all board names in Kconfig as per wiki / vendor website. | Uwe Hermann |
2009-10-18 | Simplify Kconfig files by using "select" where possible (trivial). | Uwe Hermann |
2009-10-17 | Move files from src/cpu/x86/{fpu,mmx,sse}/ to x86/ | Peter Stuge |
2009-10-16 | Fix AP_CODE_IN_CAR (only selected for two boards), STACK_SIZE, and HEAP_SIZE. | Myles Watson |
2009-10-16 | Drop enable_mmx.inc. It reads (only) "Enabling mmx registers is a noop" | Peter Stuge |
2009-10-16 | Set default ROM sizes per-board to match the ROM chip that came | Uwe Hermann |
2009-10-16 | Change CONFIG_LB_MEM_TOPK to CONFIG_RAMTOP to match CONFIG_RAMBASE. | Myles Watson |
2009-10-15 | Add CONFIG_GENERATE_* for tables so that the user can select which tables not | Myles Watson |
2009-10-11 | Remove useless udelay() duplication. | Uwe Hermann |
2009-10-09 | Remaining boards are Kconfig'd now. Whether they work | Patrick Georgi |
2009-10-07 | Major CONFIG_IRQ_TABLE_COUNT fixing and cleanups. Some of these boards | Uwe Hermann |
2009-10-07 | Convert all "default y" options to "select FOO" (shorter). | Uwe Hermann |
2009-10-07 | Kconfig: | Patrick Georgi |
2009-10-06 | Various fixes to Kconfig: All kconfig-boards should have a | Patrick Georgi |
2009-10-04 | This does away with CONFIG_ROM_PAYLOAD_START and CONFIG_PAYLOAD_SIZE. | Patrick Georgi |
2009-10-03 | Move HAVE_FAILOVER_BOOT and USE_FAILOVER_IMAGE from | Patrick Georgi |
2009-10-03 | Remove: | Patrick Georgi |
2009-10-03 | Remove duplicate and not too useful Kconfig board comments as | Uwe Hermann |
2009-09-30 | Add supermicro h8dmr fam10 target. This is largely a mashup of the tyan s2912 | Ward Vandewege |
2009-09-29 | Fix a number of board names in Kconfig (trivial). | Uwe Hermann |
2009-09-29 | Remove MAINBOARD_OPTIONS, which is a relic from early | Patrick Georgi |
2009-09-25 | some progress on kconfig: | Patrick Georgi |
2009-09-23 | simplify source tree hierarchy: move files from sdram/ and ram/ to lib/ | Stefan Reinauer |
2009-08-12 | Kconfig! | Patrick Georgi |
2009-08-11 | Enable CBFS everywhere. All boards compiled for me (abuild tested), | Patrick Georgi |
2009-07-28 | Fix erroneous comment in src/mainboard/h8dmr/Options.lb | Ward Vandewege |
2009-07-02 | Convert Supermicro H8DMR to CBFS. Also clean up some whitespace in | Ward Vandewege |
2009-06-30 | the tool chain settings should not be in renamed (as they will never live in | Stefan Reinauer |
2009-06-30 | This patch unifies the use of config options in v2 to all start with CONFIG_ | Stefan Reinauer |
2009-06-19 | Undo my ugly commit that added uses clauses in lots of places instead of one. | Myles Watson |
2009-06-17 | Fix configuration of boards that didn't have uses CONFIG_USE_INIT. Trivial. | Myles Watson |
2009-06-06 | When I started refactoring mainboard Config.lb, I added two different | Carl-Daniel Hailfinger |
2009-06-03 | Revert "CMOS: Add set_option and rework get_option." | Luc Verhaegen |
2009-06-03 | CMOS: Add set_option and rework get_option. | Luc Verhaegen |
2009-05-22 | Fix MAINBOARD_PART_NUMBER to be h8dme, I forgot to change it from the h8dmr | Ward Vandewege |
2009-05-01 | Trivial patch to make #defines generated from cmos.layout have unique names. ... | Myles Watson |
2009-04-30 | Refactor copy_and_run so that it uses a single code base instead of | Patrick Georgi |
2009-04-28 | Enable HAVE_HIGH_TABLES by default for northbridges with | Patrick Georgi |
2009-04-28 | add_mainboard_resources is necessary for some boards (eg. kontron), but | Patrick Georgi |
2009-04-27 | Add high tables support for Supermicro H8DME. | Ward Vandewege |