Age | Commit message (Expand) | Author |
2016-11-20 | intel sandy/ivy: Improve DIMM replacement detection | Kyösti Mälkki |
2016-11-20 | mainboard/google/reef: Update DPTF parameters provided from thermal team | Tim Chen |
2016-11-18 | google/chromeec: Add common infrastructure for boot-mode switches | Furquan Shaikh |
2016-11-17 | google/snappy: Update DPTF settings | Wisley Chen |
2016-11-17 | mainboard/google/reef: disable unused devices | Jagadish Krishnamoorthy |
2016-11-17 | mainboard/google/reef: set i2c bus timings by rise/fall times | Aaron Durbin |
2016-11-17 | google/gru: Move to one CA training pattern | Derek Basehore |
2016-11-17 | google/gru: Add new CA training pattern | Derek Basehore |
2016-11-17 | google/oak: Add more DRAM modules support | PH Hsu |
2016-11-16 | mainboard/google/reef: Add proper DMIC endpoints based on DMIC config pin | Sathyanarayana Nujella |
2016-11-16 | google/eve: Fill out memory ID table | Duncan Laurie |
2016-11-15 | google/link/i915.c: Fix build error when native gfx init enabled | Iru Cai |
2016-11-14 | google/chell : update DPTF policy settings | Sumeet Pawnikar |
2016-11-11 | mainboard/google/snappy: Configure PERST pin | Wisley Chen |
2016-11-11 | google/snappy: update timing of sdmode toggling | Wisley Chen |
2016-11-11 | mainboard/google/snappy: Set PL1 override to 12000mW | Wisley Chen |
2016-11-11 | soc/intel/skylake: move i2c voltage config to own variable | Aaron Durbin |
2016-11-10 | mainboard/google/reef: Add digitizer device to devicetree | Furquan Shaikh |
2016-11-10 | mainboard/google/reef: Tune digitizer I2C frequency to 400kHz | Furquan Shaikh |
2016-11-10 | drivers/i2c/wacom: Make the driver more generic | Furquan Shaikh |
2016-11-10 | mainboard/google/pyro: Set PL1 override to 12000mW | Kevin Chiu |
2016-11-10 | google/pyro: Tune i2c frequency to 400 Khz | Kevin Chiu |
2016-11-10 | google/pyro: update timing of sdmode toggling | Kevin Chiu |
2016-11-10 | mainboard/google/pyro: Configure PERST pin | Kevin Chiu |
2016-11-10 | mainboard/google/reef: Add support for RECOVERY_MRC_CACHE | Furquan Shaikh |
2016-11-09 | mainboard/google/reef: use common google smbios mainboard version | Aaron Durbin |
2016-11-09 | google/pyro: Update WACOM touchscreen ACPI _HID | Janice Li |
2016-11-07 | google/lars: Update DPTF settings | Sumeet Pawnikar |
2016-11-07 | mainboard/google/reef: update DMIC related pins configuration | Sathyanarayana Nujella |
2016-11-04 | reef: tune trackpad i2c frequency to 400kHz | Aaron Durbin |
2016-11-04 | reef: tune tpm i2c frequency to 400kHz | Aaron Durbin |
2016-11-03 | google/veyron*: change .ddrconfig from 14 to 3 | ZhengShunQian |
2016-11-03 | google/veyron*: add DDR configs for new samsung DDR | ZhengShunQian |
2016-11-02 | rockchip/rk3399: display: Do not allocate framebuffer in coreboot | Lin Huang |
2016-11-02 | rockchip/rk3399: sdram: also prepare the index1 configuration | Lin Huang |
2016-11-01 | google/eve: Add new board | Duncan Laurie |
2016-10-28 | lars/kunimitsu: Add other sensor in _ART for fan control | Sumeet Pawnikar |
2016-10-28 | mainboard/google/reef: allow variants to override NHLT OEM strings | Aaron Durbin |
2016-10-28 | mainboard/google/reef: update comment for DMIC config usage | Aaron Durbin |
2016-10-27 | mainboard/google/reef: drop disabling periodic training for micron | Aaron Durbin |
2016-10-27 | mainboard/google/reef: clarify memory part number details | Aaron Durbin |
2016-10-27 | skylake: Use COMMON_FADT | Duncan Laurie |
2016-10-26 | google/reef/variants/pyro: Use WCOM Touchscreen driver | Furquan Shaikh |
2016-10-25 | google/oak: Add derivative board Hana | Yidi Lin |
2016-10-25 | rockchip/rk3399: gru/kevin: drop unused sdram configs | Lin Huang |
2016-10-25 | rockchip/rk3399: reset system if DDR init fails | Lin Huang |
2016-10-25 | mainboard/google/reef: Add PowerResource for ELAN touchscreen | Furquan Shaikh |
2016-10-20 | mainboard/google/reef: add snappy variant | Wisley Chen |
2016-10-18 | mainboard/google/reef: Configure PERST pin for reef DVT | Vaibhav Shankar |
2016-10-16 | mainboard/google/reef: Set PL1 override to 12000mW | Venkateswarlu Vinjamuri |
2016-10-10 | google/reef: update timing of sdmode toggling | Sathyanarayana Nujella |
2016-10-08 | google/oak: Increase the driving strength for 4GB DRAMs | PH Hsu |
2016-10-08 | google/gru: Add USB 2.0 PHY tuning for Kevin PHY0 and PHY1 | William wu |
2016-10-07 | google/reef/variants/pyro: Add support for GPIO output polarity | Martin Roth |
2016-10-07 | src/mainboard: Remove whitespace after sizeof | Elyes HAOUAS |
2016-10-07 | src/mainboard: Remove unnecessary whitespace | Elyes HAOUAS |
2016-10-07 | x86/acpi_device: Add support for GPIO output polarity | Furquan Shaikh |
2016-10-07 | google/gru: drive WLAN_MODULE_RST# low as early as possible | Brian Norris |
2016-10-07 | google/gru: set W2W_DIFFCS_DLY to 5 | Lin Huang |
2016-10-07 | google/gru: pass apio number to arm-trust-firmware | Lin Huang |
2016-10-07 | google/gru: pass the gpio power supply enable pin to bl31 | Lin Huang |
2016-10-07 | mainboard/google/reef: add pyro variant. | Kevin Chiu |
2016-10-06 | rockchip: rk3399: improve write leveling flow | Jianqun Xu |
2016-10-06 | google/gru: Shrink RW_ELOG region to 4KB | Julius Werner |
2016-10-06 | rockchip: rk3399: improve sdram noc timing | Lin Huang |
2016-10-06 | rockchip/rk3399: lower kevin board sdram frequency to 800MHz | Lin Huang |
2016-10-06 | google/veyron_rialto: Add lpddr3-K4E6E304EB-2GB-1CH memory configuration | Jeffy Chen |
2016-10-06 | rockchip/rk3399: Move big CPU cluster initialization into ramstage | Julius Werner |
2016-10-04 | google/gru: Ensure correct pull resistors for special-function pins | Julius Werner |
2016-10-04 | gru: Increase SPI speed to 33MHz | Simon Glass |
2016-10-04 | google/gru: Init the PWM pinmux after setting up the PWM | Douglas Anderson |
2016-10-04 | src/mainboard: Remove unnecessary semicolon | Elyes HAOUAS |
2016-10-03 | google/gale: Remove #ifdef of Kconfig bool symbol | Martin Roth |
2016-10-03 | google/gale/Kconfig: Change wording of Kconfig option | Martin Roth |
2016-10-02 | Kconfig: Update default hex values to start with 0x | Martin Roth |
2016-10-01 | mainboard/google/reef: Update DPTF policy temp. values for CPU | Sumeet Pawnikar |
2016-10-01 | mainboard/google/reef: unconditionally set MAINBOARD_FAMILY | Aaron Durbin |
2016-09-30 | google/reef: Fix default values in Kconfig | Martin Roth |
2016-09-30 | Kconfig: Prefix hex defaults with 0x | Martin Roth |
2016-09-30 | mainboard/google/stout/romstage.c: Use tabs for indents | Elyes HAOUAS |
2016-09-28 | google/reef: Mark touchpad and touchscreen as probed devices | Duncan Laurie |
2016-09-26 | mainboards,ec: provide common declaration for mainboard_ec_init() | Aaron Durbin |
2016-09-26 | mainboards/google/reef: use chromeec's ASL lid switch implementation | Aaron Durbin |
2016-09-26 | soc/intel/apollolake: provide power button ACPI device | Aaron Durbin |
2016-09-21 | google/enguarde: Adapt to current tree | Patrick Georgi |
2016-09-21 | google/enguarde: Upstream Lenovo N21 Chromebook | Matt DeVillier |
2016-09-21 | mainboard/google/reef: Enable cr50 TPM interrupt | Duncan Laurie |
2016-09-21 | Makefiles: update cbfs types from bare numbers to values | Martin Roth |
2016-09-20 | src/mainboard/getac - kontron: Add space around operators | Elyes HAOUAS |
2016-09-20 | gru/kevin: Decrease voltage for little cpu 1.5G to 1.15v | Shunqian Zheng |
2016-09-20 | Veyron: Increase bit-per-pixel to 32 | Daisuke Nojiri |
2016-09-20 | google/gru: Fix up PWM regulator ranges | Julius Werner |
2016-09-20 | Gru: Increase bit-per-pixel to 32 | Daisuke Nojiri |
2016-09-20 | gru: Add watchdog reset support | Julius Werner |
2016-09-19 | Revert "mainboard/google/reef: Enable cr50 TPM interrupt" | Duncan Laurie |
2016-09-19 | mainboard/google/reef: Enable cr50 TPM interrupt | Duncan Laurie |
2016-09-20 | gru: Add USB 2.0 PHY tuning for Kevin | Julius Werner |
2016-09-19 | mainboard/google/reef: Configure WLAN as wake source | Vaibhav Shankar |
2016-09-15 | mainboard/reef: add variant support to ASL code | Aaron Durbin |
2016-09-15 | google/reef: Remove setting of GPIO_TIER1_SCI enable bit | Shaunak Saha |