aboutsummaryrefslogtreecommitdiff
path: root/src/mainboard/google/hatch/variants/kohaku
AgeCommit message (Expand)Author
2020-05-26cannonlake: update processor power limits configurationSumeet R Pawnikar
2020-05-18src: Remove leading blank lines from SPDX headerElyes HAOUAS
2020-05-11treewide: Remove "this file is part of" linesPatrick Georgi
2020-05-09src/: Replace GPL boilerplate with SPDX headersPatrick Georgi
2020-05-02acpi: Move ACPI table support out of arch/x86 (3/5)Furquan Shaikh
2020-04-24mb/google/hatch: Change baseboard EC wake & SCI masks to match kohakuTim Wawrzynczak
2020-04-06mb/google/hatch: Use SPDX for GPL-2.0-only filesAngel Pons
2020-03-30mb/google/kohaku: Add enable_delay_ms for wacom penEvan Green
2020-03-20drivers/generic/max98357a: Allow custom _HID from configAamir Bohra
2020-03-18mainboard/google: Remove copyright noticesPatrick Georgi
2020-03-02mb/google/kohaku: Add LPDDR 16G 2133 supportSeunghwan Kim
2020-02-01mb/google/hatch: Modify kohaku's EC_SCI_EVENTS maskTim Wawrzynczak
2020-01-22mb/google/hatch: Kohaku: Add MKBP to suspend wake eventsTim Wawrzynczak
2019-12-27mb/google/kohaku: Update reset_delay_ms for digitizer deviceSeunghwan Kim
2019-12-25mb/google/hatch/variant/kohaku: Fix Kohaku baseboard/gpio.c mux commentsEdward O'Callaghan
2019-12-25mainboard/google/hatch: Move gpio GPP_H3 config up from baseboardEdward O'Callaghan
2019-12-25mainboard/google/hatch: Move gpio GPP_A* NC down into baseboardEdward O'Callaghan
2019-12-24mainboard/google/hatch: Remove MAX98357A assumption from baseboardEdward O'Callaghan
2019-12-10mb/google/kohaku: Update TCC offset settingSeunghwan Kim
2019-12-05hatch: Fix FPMCU pwr/rst gpio handlingCraig Hesling
2019-12-04mb/google/kohaku: Adjust I2C clock frequencySeunghwan Kim
2019-11-22mb/google/hatch/variant/kohaku: Config MEM_STRAP GPIOsShelley Chen
2019-11-16kohaku: Set GPP_A10 to NCShelley Chen
2019-10-11mb/google/hatch: Add new touchscreen option for KohakuTim Wawrzynczak
2019-10-09mb/google/hatch: Set FPS as wake sourceShelley Chen
2019-10-08mb/google/kohaku: Assign GPP_A19 as reset_gpio of stylusSeunghwan Kim
2019-09-24mb/google/kohaku: Update DPTF parameters and TCC offset settingSeunghwan Kim
2019-09-16mb/google/kohaku: Update USB port settingsSeunghwan Kim
2019-08-21mb/google/kohaku: Correct DPTF temp sensor IDsSeunghwan Kim
2019-08-20mb/google/kohaku: Use level trigger for touchscreen interruptSeunghwan Kim
2019-08-13mb/google/hatch/var/kohaku: Change Atmel touchscreen HID to PRP0001Furquan Shaikh
2019-08-13mb/google/hatch: Kohaku: Enable DMIC1 in device treeMac Chiang
2019-08-11kohaku: add TEMP_SENSOR_3 and TEMP_SENSOR_4 to DPTFPaul Fagerburg
2019-08-11mb/google/hatch: Fix Kohaku pen GPIO configurationTim Wawrzynczak
2019-08-09mb/google/hatch: Refactor override_early_gpio_tableTim Wawrzynczak
2019-08-07mb/google/hatch: Kohaku: Re-setup dual-routing of EMR_GARAGE_DETTim Wawrzynczak
2019-08-07mb/google/hatch: Kohaku: Add touchscreen controller to device treeTim Wawrzynczak
2019-08-07mb/google/kohaku: Enable stylus pen deviceSeunghwan Kim
2019-08-02mb/google/hatch: Fine-tune Kohaku I2C CLK frequencyPhilip Chen
2019-07-31mb/google/kohaku: Update DPTF parameters and TDP PL1/PL2Seunghwan Kim
2019-07-18mb/google/hatch: Add FP MCU to kohaku device treeShelley Chen
2019-07-13mb/google/hatch: Fix trackpad configuration in overridetreeFurquan Shaikh
2019-06-28mb/google/kohaku: Correct trackpad i2c addressSeunghwan Kim
2019-06-16mb/google/hatch: Move memory strap GPIOs under variant gpio headerAamir Bohra
2019-05-21mb/google/kohaku: Set ACPI_GPIO_IRQ_EDGE_BOTH for headset INTKane Chen
2019-05-15soc/intel/cannonlake: Support different SPD read type for each slotPhilip Chen
2019-04-29mb/google/hatch/variants/kohaku: Add support for LPDDR3 configurationsPaul Fagerburg
2019-04-24mb/google/kohaku: Update overridetree.cbTim Wawrzynczak
2019-04-24mb/google/hatch/var/kohaku: Skip UART0 config in FSPFurquan Shaikh
2019-04-19kohaku: mb/hatch/gpio: Scrub Kohaku GPIOs.Tim Wawrzynczak
2019-04-04mb/google/hatch: Create kohaku variantShelley Chen