Age | Commit message (Expand) | Author |
2020-08-23 | soc/intel/cnl: Configure FSP option PcieRpSlotImplemented | Nico Huber |
2020-08-07 | soc/intel/cnl: Set Heci1Disable depending on devicetree config | Felix Singer |
2020-05-26 | cannonlake: update processor power limits configuration | Sumeet R Pawnikar |
2020-05-18 | src: Remove leading blank lines from SPDX header | Elyes HAOUAS |
2020-05-11 | treewide: Remove "this file is part of" lines | Patrick Georgi |
2020-05-09 | src/: Replace GPL boilerplate with SPDX headers | Patrick Georgi |
2020-04-20 | mb/google/drallion: Increase Melfas touchscreen stop delay to 115ms | John Su |
2020-04-06 | mb/google/drallion: Use SPDX for GPL-2.0-only files | Angel Pons |
2020-03-18 | mainboard/google: Remove copyright notices | Patrick Georgi |
2020-03-11 | mb/google/drallion/variants/drallion: Set PCH Thermal Trip point to 77°C | Sumeet Pawnikar |
2020-02-24 | gfx: Move drivers/generic/gfx to drivers/gfx/generic | Furquan Shaikh |
2020-02-24 | mb/google/drallion: Set GPP_G4 and GPP_G6 to NC pin | Eric Lai |
2020-02-17 | mb/google/drallion/variants/drallion: Update thermal configuration for DPTF | John Su |
2020-02-17 | mb/google/drallion: Set cpu_pl2_4_cfg to baseline for Drallion | John Su |
2020-02-17 | mb/google/drallion: Correct USB3 OC pin configuration | Eric Lai |
2020-02-09 | mb/google/drallion: Add new SPD files for drallion | Ian Feng |
2020-02-09 | mb/google/drallion: Tuning WWAN power sequence | Eric Lai |
2020-02-05 | mb/google/drallion: Fine tune touch screen power sequence | Eric Lai |
2020-01-24 | mb/google/drallion: Remove fixed IccMax values | John Su |
2020-01-02 | mb/**/hda_verb.{c,h}: use denary numerals for codec IDs | Angel Pons |
2019-12-19 | mb/google/drallion: Remove Wilco 1.0 CML code from drallion code | Eric Lai |
2019-12-16 | mb/g/drallion: Remove Wilco 1.0 CML variants from drallion code | Mike Wiitala |
2019-12-11 | mb/google/drallion/variants/drallion: Update thermal configuration for DPTF | John Su |
2019-12-04 | mb/google/drallion/variants/drallion: Adjust all I2C CLK to meet spec | John Su |
2019-12-03 | mb/google/drallion: Disable GPIO dynamic PM configuration | Subrata Banik |
2019-12-02 | mb/g/drallion: Enable privacy screen on Drallion variant | Mathew King |
2019-11-27 | soc/intel/cannonlake: Disable USB2 PHY Power gating | Surendranath Gurivireddy |
2019-11-06 | mb/g/drallion: Override smbios enclosure type for drallion | Mathew King |
2019-11-06 | mb/g/drallion: Consolidate 360 sensor board detection | Mathew King |
2019-11-04 | mb/google/drallion: Update GPIO table | Eric Lai |
2019-11-04 | mb/google/drallion: Correct GPP_E7 as stop pin | Eric Lai |
2019-11-04 | mb/google/drallion: fix GPP_E16 glitch when enter S5 | Eric Lai |
2019-11-01 | mb/google/drallion: Add second touch pad support | Eric Lai |
2019-10-31 | mb/google/drallion: Turn off HDMI power when enter s0ix and S5 | Eric Lai |
2019-10-22 | mb/google/drallion: Change touch enable pin default value | Eric Lai |
2019-10-16 | mb/google/drallion: Add new SPD file for drallion | Bora Guvendik |
2019-10-08 | mb/google/drallion: Add detect pin for Wacom touchscreen | Frank Wu |
2019-10-02 | mb/google/drallion: Disable GBE in firmware for drallion variants | Thejaswani Putta |
2019-10-02 | mb/google/drallion: Dynamicly disable memory channel | Eric Lai |
2019-09-30 | mb/google/drallion: Clean up devicetree config | Aamir Bohra |
2019-09-30 | mb/google/drallion: Configure LPSS controller parameters | Aamir Bohra |
2019-09-30 | mb/google/drallion: Adjust GPD3 pin termination | Bora Guvendik |
2019-09-30 | mb/google/drallion: De-assert WWAN reset signal | Aamir Bohra |
2019-09-28 | mb/google/variants/drallion: Update the spd index map | Aamir Bohra |
2019-09-28 | mb/google/drallion: Set UART for console to UART controller 0 | Aamir Bohra |
2019-09-19 | mb/google/drallion: add sku id base on sensor detection | Eric Lai |
2019-09-19 | mb/google/drallion: Add memory init setup for drallion | Thejaswani Putta |
2019-09-18 | mb/google/drallion: Add SPD files for drallion | Amanda Huang |
2019-09-18 | mb/google/drallion: Enable 360 sensor detection | Bernardo Perez Priego |
2019-09-18 | mb/google/drallion: Update gpio config for drallion | Varun Joshi |
2019-09-13 | mb/google/drallion: Use arcada_ish.bin for arcada_cml | Selma BENSAID |
2019-09-12 | soc/intel/cnl: Remove unnecessary FSP UPD “PchPwrOptEnable” usage | Subrata Banik |
2019-09-11 | mb/google/drallion: enable Elan and Melfas touch panel | Eric Lai |
2019-09-09 | mb/google/drallion: modify USB setting | Eric Lai |
2019-09-05 | mb/google/drallion: modify PCIE setting | Eric Lai |
2019-09-02 | mb/google/drallion: add memory sku id | Eric Lai |
2019-09-02 | mb/google/drallion: Enable HDA for drallion platform | Aamir Bohra |
2019-08-30 | mb/google/drallion: change servo board debug to UART 0 | Eric Lai |
2019-08-28 | mb/google/drallion: add dummy SPD file | Eric Lai |
2019-08-23 | mb/google/drallion: Add two variants - arcada_cml & sarien_cml | Thejaswani Putta |
2019-08-05 | mb/google/drallion: Add new mainboard | Thejaswani Putta |