summaryrefslogtreecommitdiff
path: root/src/cpu/samsung/exynos5420
AgeCommit message (Expand)Author
2014-07-08cpu: Trivial - drop trailing blank lines at EOFEdward O'Callaghan
2014-07-05spi: Change spi_xfer to work in units of bytes instead of bits.Gabe Black
2014-07-05spi: Remove unused parameters from spi_flash_probe and setup_spi_slave.Gabe Black
2014-05-06Introduce stage-specific architecture for corebootFurquan Shaikh
2014-05-03Move ARCH_* from board/Kconfig to cpu or soc Kconfig.Furquan Shaikh
2014-04-30console: Move UART port defaults to mainboardKyösti Mälkki
2014-04-30console: Drop EARLY_CONSOLE optionKyösti Mälkki
2014-04-30uart: Support multiple portsKyösti Mälkki
2014-04-09uart: Redefine Kconfig optionsKyösti Mälkki
2014-04-09console uart: Fill coreboot table entriesKyösti Mälkki
2014-04-09uart: Prepare to support multiple base addressesKyösti Mälkki
2014-03-04console: Use single driver entry for UARTsKyösti Mälkki
2014-03-04console: Fix includesKyösti Mälkki
2014-03-04samsung/exynos5: Fix baudrate calculationKyösti Mälkki
2014-02-06ARMv7: Remove static CBMEM allocationKyösti Mälkki
2013-12-21pit: disable LCD FETs before doing any graphics initDavid Hendricks
2013-12-21exynos5420: Assign corect parent PLLsDavid Hendricks
2013-12-21exynos5420: don't assume MPLL for i2c parent clockDavid Hendricks
2013-12-21exynos5420: Set SPLL to 400MHzDavid Hendricks
2013-12-21exynos5420: re-factor clock_get_periph_rate()David Hendricks
2013-12-21exynos5420: add a peripheral clock select --> PLL decoderDavid Hendricks
2013-12-21exynos5420: add CPLL and DPLL to the known list of PLLsDavid Hendricks
2013-12-21exynos5420: correct the PMS value for CPLLDavid Hendricks
2013-12-21exynos5420: Configure the UART pins unconditionallyGabe Black
2013-12-21exynos5420: re-factor the SDMMC GPIO config routinesDavid Hendricks
2013-12-21exynos5420: configure SD_0_CDn as VDDEN for eMMCDavid Hendricks
2013-12-21exynos5420: init APLL at 1800MHzDavid Hendricks
2013-12-21exynos5xxx: use oscillator clock when changing ARM frequencyDavid Hendricks
2013-12-21exynos5420: set L2ACTLR parameters for A15 coresDavid Hendricks
2013-12-21exynos5420: minor correction to CPU frequency printDavid Hendricks
2013-12-21armv7/exynos: Fix and remove memory reset workaroundsHung-Te Lin
2013-12-21Pit: graphicsRonald G. Minnich
2013-12-21Pit: correctly initialize trust zoneRonald G. Minnich
2013-12-21exynos5420: update set_cpu_id()David Hendricks
2013-12-21Exynos 5420: Enable dynamic CBMEMStefan Reinauer
2013-12-21exynos5420: Fix some clock settingsGabe Black
2013-12-21exynos5420: Fix the clock divisor maskGabe Black
2013-12-21exynos5420: Get rid of the PWM code like on the 5250Gabe Black
2013-12-21exynos5420: Apply pwm const fix to the 5420 as wellGabe Black
2013-12-20armv7: Remove SYS_TEXT_BASE config.Hung-Te Lin
2013-12-12exynos5420: Setup clocks for MMC bus controller.Hung-Te Lin
2013-09-28exynos5420: Fix build warningAllen Martin
2013-07-10i2c: Change the type of the data parameter to uint8_t.Gabe Black
2013-07-10armv7/exynos5420: Remove the extra reopen when reading SPI.Hung-Te Lin
2013-07-10armv7/exynos5420: Apply new implementation for SPI transmission.Hung-Te Lin
2013-07-10armv7/exynos5420: Add output ability and half-duplex mode in SPI driver.Hung-Te Lin
2013-07-10armv7/exynos5420: Revise SPI open/close/reset procedure.Hung-Te Lin
2013-07-10armv7/exynos5420: Provide configuration for SPI0~SPI2.Hung-Te Lin
2013-07-10armv7/exynos5420: Change SPI module to standard <spi-generic> interface.Hung-Te Lin
2013-07-10armv7/exynos5420: Clean up unused header and constants in spi.cHung-Te Lin
2013-07-10armv7/exynos5420: Revise SPI device list in cpu.hHung-Te Lin
2013-07-10arm/exynos: Correct SPI session commands.Hung-Te Lin
2013-07-10exynos5420: i2c: Fix error handling.Gabe Black
2013-07-10exynos5420: Clock the mmc blocks off of the mpll.Gabe Black
2013-07-10exynos5420: use speed parameter in i2c_init() for HSI2CDavid Hendricks
2013-07-10exynos5420: Change some clock settings.Gabe Black
2013-07-10exynos5420: Fix the way the rate of the input clock for i2c buses is found.Gabe Black
2013-07-10Exynos5420: Initialize USB PHYStefan Reinauer
2013-07-10Exynos: Only compile UART in if serial console is selectedStefan Reinauer
2013-07-10Exynos5420: add code to make sure resume will work on DRAM.Ronald G. Minnich
2013-07-10Simplify early / bootblock console codeStefan Reinauer
2013-07-10exynos5420: Switch to fixed size types in dmc.h.Gabe Black
2013-07-10exynos5420: Revamp the high speed I2C driver.Gabe Black
2013-07-10Samsung CPUs: Unify KconfigStefan Reinauer
2013-07-10exynos5420: update I2C code, add HSI2C/USI supportDavid Hendricks
2013-07-10ARM: when setting a GPIO to put, set the value, then the directionRonald G. Minnich
2013-07-10exynox5420: Remove the 5250 clock registers and fix the SPI frequency.Gabe Black
2013-07-10PIT: memory setupRonald G. Minnich
2013-07-10exynos5420: add I2C8-10 to clock_get_periph_rate()David Hendricks
2013-07-10exynos5420: Implement support for the pinmux as functions.Gabe Black
2013-07-10ARM: Separate the early console (romstage) from the bootblock console.Gabe Black
2013-07-10exynos5420: Clear the framebuffer before making it uncacheableStefan Reinauer
2013-07-10exynos5420: Don't disable and re-enable the MMU when uncaching the framebufferStefan Reinauer
2013-07-10exynos5420: Simplify the graphics code by eliminating the unused color mapStefan Reinauer
2013-07-10exynos5420: Fix some problems with the clock management code.Gabe Black
2013-07-10armv7: Reserve space BL1 and checksum header by specifying bootblock offset.Hung-Te Lin
2013-07-10exynos5420: Replace the 5250 clock logic with 5420.Gabe Black
2013-07-10exynos5420: Make the ps_hold_setup function public.Gabe Black
2013-07-10Exynos5420: Clean up console codeStefan Reinauer
2013-07-10exynos5420: Replace the 5250 GPIO code with code that should work on 5420.Gabe Black
2013-07-10pit: Fix some settings for the exynos5420 CPU.Gabe Black
2013-07-10pit: Create an exynos5420 directory which is nearly a copy of exynos5250.Gabe Black
generated by cgit v1.2.3 (git 2.25.1) at 2024-11-25 00:27:52 +0000