summaryrefslogtreecommitdiff
AgeCommit message (Expand)Author
2015-04-06Add predefined __ROMSTAGE__ and __RAMSTAGE__ macrosJulius Werner
2015-04-06build system: run linker scripts through the preprocessorPatrick Georgi
2015-04-06tegra132: Add tegra_lp0_resume codeYen Lin
2015-04-06baytrail: Fix hdmi audio choppy issueKein Yuan
2015-04-06baytrail: reinitialize spi controller in SMM finalizationAaron Durbin
2015-04-06arch/arm64/boot.c: Only return if condition is metPaul Menzel
2015-04-05acpi: protect acpi generators from PRE_RAM & SMMAlexander Couzens
2015-04-05mainboard/lenovo/x201: correct sata_port_mapAlexander Couzens
2015-04-05intel/nehalem: rename copypasted smi finalizer functionAlexander Couzens
2015-04-04build system: rename __BOOT_BLOCK__ and __VER_STAGE__Patrick Georgi
2015-04-04build system x86: deprecate bootblock_lds and ldscripts variablesPatrick Georgi
2015-04-04build system: use full (in-tree) pathsPatrick Georgi
2015-04-04rk3288: set cpu frequency up to 1.8GHzhuang lin
2015-04-04rk3288: guarantee i2c low period more than 1.3ushuang lin
2015-04-04t132: Enable SMMU translationsFurquan Shaikh
2015-04-04tegra132: Store ODMDATA from BCT into PMC scratch for use by kernelTom Warren
2015-04-04tegra132: remove framebuffer reservationAaron Durbin
2015-04-04veyron_pinky/rk3288: Use KHz, MHz and GHz constantsJulius Werner
2015-04-04stddef: Add KHz, MHz and GHz constantsAaron Durbin
2015-04-04samus: Disable USB Port 5Duncan Laurie
2015-04-04broadwell: Enable turbo ratio if availableDuncan Laurie
2015-04-04Broadwell: Pass TSC value to romstage_mainLee Leahy
2015-04-04Add table driven way to add platform specific reg_script routinesLee Leahy
2015-04-04samus: Add new memory typeDuncan Laurie
2015-04-04samus: Set codec PDM clock output to 3MHzBen Zhang
2015-04-04broadwell: fix typo in pei_dataDuncan Laurie
2015-04-04broadwell: Add USB3 PHY tuning fields to PEI DATADuncan Laurie
2015-04-04samus: Change touchscreen bootloader mode i2c addressDuncan Laurie
2015-04-04samus: Enable GSPI0 interfaceDuncan Laurie
2015-04-04Baytrail: Fix no_dev_behind_port not executed for RP1/2/3.Kenji Chen
2015-04-04samus: Enable GPIO9 as touchpad wakeDuncan Laurie
2015-04-04samus: Update thermal max for broadwellDuncan Laurie
2015-04-04samus: Assign GPIO2 to HP_AMP_SHDN_LBen Zhang
2015-04-04samus: Make codec interrupt active highBen Zhang
2015-04-04Broadwell: Fix PCIe L1 Sub-State capability ID not filled.Kenji Chen
2015-04-04samus: Add codec platform data for jack detectBen Zhang
2015-04-04samus: Change GPIO controller label to INT3437:00Duncan Laurie
2015-04-04samus: Enable update screen for software syncDuncan Laurie
2015-04-04samus: Add smbios_mainboard_version to define board versionDuncan Laurie
2015-04-04broadwell: Fix building with USE=quiet-cbDuncan Laurie
2015-04-04samus: Add codec platform info in ACPIDuncan Laurie
2015-04-04Drop (empty) google/snow mainboard directoryStefan Reinauer
2015-04-04arm64: make secmon link with the manual templateAaron Durbin
2015-04-04armv4: Add verstage to armv4Furquan Shaikh
2015-04-04armv7: Add config option guard for verstage classFurquan Shaikh
2015-04-04tegra124: use known-good drive for fast-train onlyNeil Chen
2015-04-04tegra124: add support for full DP link trainingNeil Chen
2015-04-04rk3288: Replace SPI fifo_size with constantDavid Hendricks
2015-04-04rk3288: Pass SPI bus speed in as parameter to init functionDavid Hendricks
2015-04-04build system: Introduce manual file typePatrick Georgi
2015-04-04build system: Allow defining generic rulesPatrick Georgi
2015-04-04build system: create proper dependency filesPatrick Georgi
2015-04-04x86: rename ldscript_failover.ld to failover.ldPatrick Georgi
2015-04-03tegra132: implement platform_prog_run()Aaron Durbin
2015-04-03tegra124: implement platform_prog_run()Aaron Durbin
2015-04-03rmodule: use struct prog while loading rmodulesAaron Durbin
2015-04-03program loading: unify on struct progAaron Durbin
2015-04-03program loading: add prog_run() functionAaron Durbin
2015-04-03program loading: introduce struct progAaron Durbin
2015-04-02pinky: Move some init to mainboard bootblockDavid Hendricks
2015-04-02rk3288/pinky: Move uart address to mainboard KconfigDavid Hendricks
2015-04-02rk3288: remove duplicated #define `PERI_ACLK_DIV_SHIFT`Aaron Durbin
2015-04-02Nyans: replace cpu_reset with hard_resetDaisuke Nojiri
2015-04-02Broadwell: Select PCIE_L1_SUB_STATE and apply Broadwell settings.Kenji Chen
2015-04-02pistachio: add gpio type definitionVadim Bendebury
2015-04-02Clean up architecture-specific KconfigsJulius Werner
2015-04-02build system: extend src-to-obj for non-.c/.S filesPatrick Georgi
2015-04-02urara: Fix CBFS header definitionsVadim Bendebury
2015-04-02urara: Configure UART line control to 8N1Ionela Voinescu
2015-04-02mips: do not place branch instructions in branch delay slotVadim Bendebury
2015-04-02coreboot: rk3288: add new ddr config and support ddr3 freq up to 800mhzjinkun.hong
2015-04-02rockchip: support pwm regulatorhuang lin
2015-04-02rockchip: support i2c clock settinghuang lin
2015-04-02pinky: Force delay for EC SPI transfersDavid Hendricks
2015-04-02veyron_pinky: Add rev2 support, clean up mainboard.cJulius Werner
2015-04-02veyron: select rw romstage using vboot2Daisuke Nojiri
2015-04-02southbridge/amd/pi: Add initialization of 8254 and 8259Dave Frodin
2015-04-02broadwell: Disable ADSP power gating feature by defaultDuncan Laurie
2015-04-02chromeec: Add wakeup delay after SPI /CS assertionDavid Hendricks
2015-04-02samus: Fix codec interrupt and add GPIO definesDuncan Laurie
2015-04-02chromeec: Fix logging of EC wake eventsDuncan Laurie
2015-04-02samus: Clean up touch wake sourcesDuncan Laurie
2015-04-02broadwell: Add event log entry for GPIO27Duncan Laurie
2015-04-02arm: Prevent compilation of old, experimental SMP supportJulius Werner
2015-04-02Broadwell: Reg_Script: add END tag to array "smbus_init_script"Ryan Lin
2015-04-02samus: Fix and clean up GPIOs and EC info/eventsDuncan Laurie
2015-04-02chromeec: Add battery status event and re-enable _BIXDuncan Laurie
2015-04-02Broadwell: Synchronize for power management with FRCKenji Chen
2015-04-02Broadwell: Synchronize RO, Link Arbiter, and OBFF with FRCKenji Chen
2015-04-02Broadwell: Revise programming flow for write-once registersKenji Chen
2015-04-02broadwell: Configure IOSF Port and Grant CountKenji Chen
2015-04-02vpd: retrieve mac addresses and pass them to bootloaderVadim Bendebury
2015-04-02Samus: Synchronization with FRC to enable PCIe Relaxed Order.Kenji Chen
2015-04-02samus: Ensure PD controller is in RO mode for recoveryDuncan Laurie
2015-04-02chromeec: Add support for v3 commands on LPCDuncan Laurie
2015-04-02chromeec: Add commands to check PD image typeDuncan Laurie
2015-04-02chromeec: Update ec_commands.h from EC repositoryDuncan Laurie
2015-04-02baytrail: Change USB3 PLL VCO and iCLK PLL current on BYT-M/D CPUKein Yuan
2015-04-02broadwell: Update PCIe configuration to follow BWGKane Chen
2015-04-02chromeos: Add WiFi calibration CBMEM entry pointer to coreboot tableVadim Bendebury