diff options
Diffstat (limited to 'src/northbridge/intel/i82810')
| -rw-r--r-- | src/northbridge/intel/i82810/debug.c | 4 | ||||
| -rw-r--r-- | src/northbridge/intel/i82810/raminit.c | 6 | ||||
| -rw-r--r-- | src/northbridge/intel/i82810/raminit.h | 4 |
3 files changed, 7 insertions, 7 deletions
diff --git a/src/northbridge/intel/i82810/debug.c b/src/northbridge/intel/i82810/debug.c index 87b039f5f5..5bddbb60a3 100644 --- a/src/northbridge/intel/i82810/debug.c +++ b/src/northbridge/intel/i82810/debug.c @@ -8,8 +8,8 @@ static void dump_spd_registers(void) device = DIMM_SPD_BASE + i; if (device) { int j; - print_debug("dimm: "); - print_debug_hex8(i); + print_debug("dimm: "); + print_debug_hex8(i); print_debug(".0: "); print_debug_hex8(device); for(j = 0; j < 256; j++) { diff --git a/src/northbridge/intel/i82810/raminit.c b/src/northbridge/intel/i82810/raminit.c index fbb64f6088..81148e313d 100644 --- a/src/northbridge/intel/i82810/raminit.c +++ b/src/northbridge/intel/i82810/raminit.c @@ -312,7 +312,7 @@ static void set_dram_buffer_strength(void) SPD_NUM_DIMM_BANKS) > 1; d1.ss = !d1.ds; } - + buff_sc = 0; /* Tame the beast... */ @@ -350,7 +350,7 @@ static void set_dram_buffer_strength(void) buff_sc |= 1 << 14; if (!d0.size && d1.size) buff_sc |= 1 << 15; - + print_debug("BUFF_SC calculated to 0x"); print_debug_hex16(buff_sc); print_debug("\n"); @@ -371,7 +371,7 @@ static void sdram_set_registers(void) /* Ideally, this should be R/W for as many ranges as possible. */ pci_write_config8(PCI_DEV(0, 0, 0), PAMR, 0xff); - + /* Set size for onboard-VGA framebuffer. */ reg8 = pci_read_config8(PCI_DEV(0, 0, 0), SMRAM); reg8 &= 0x3f; /* Disable graphics (for now). */ diff --git a/src/northbridge/intel/i82810/raminit.h b/src/northbridge/intel/i82810/raminit.h index 5a06dd171d..8c558a5699 100644 --- a/src/northbridge/intel/i82810/raminit.h +++ b/src/northbridge/intel/i82810/raminit.h @@ -27,7 +27,7 @@ /* DIMM0 is at 0x50, DIMM1 is at 0x51. */ #define DIMM_SPD_BASE 0x50 -/* The following table has been bumped over to this header to avoid clutter in +/* The following table has been bumped over to this header to avoid clutter in * raminit.c. It's used to translate the value read from SPD Byte 31 to a value * the northbridge can understand in DRP, aka Rx52[7:4], [3:0]. Where most * northbridges have some sort of simple calculation that can be done for this, @@ -38,7 +38,7 @@ /* TODO: Find a better way of doing this. */ static const uint8_t translate_spd_to_i82810[] = { - /* Note: 4MB sizes are not supported, so dual-sided DIMMs with a 4MB + /* Note: 4MB sizes are not supported, so dual-sided DIMMs with a 4MB * side can't be either, at least for now. */ /* TODO: For above case, only use the other side if > 4MB, and get some |