diff options
Diffstat (limited to 'src/northbridge/intel/e7505')
| -rw-r--r-- | src/northbridge/intel/e7505/raminit.c | 15 |
1 files changed, 0 insertions, 15 deletions
diff --git a/src/northbridge/intel/e7505/raminit.c b/src/northbridge/intel/e7505/raminit.c index 892bfadd23..444ab162ff 100644 --- a/src/northbridge/intel/e7505/raminit.c +++ b/src/northbridge/intel/e7505/raminit.c @@ -340,7 +340,6 @@ static struct dimm_size sdram_spd_get_page_size(uint16_t dimm_socket_address) if (value > 2) die("Bad SPD value\n"); if (value == 2) { - pgsz.side2 = pgsz.side1; // Assume symmetric banks until we know differently value = smbus_read_byte(dimm_socket_address, SPD_NUM_COLUMNS); if (value < 0) @@ -413,14 +412,12 @@ static struct dimm_size spd_get_dimm_size(unsigned int dimm_socket_address) struct dimm_size sz = sdram_spd_get_page_size(dimm_socket_address); if (sz.side1 > 0) { - value = smbus_read_byte(dimm_socket_address, SPD_NUM_ROWS); die_on_spd_error(value); sz.side1 += value & 0xf; if (sz.side2 > 0) { - // Double-sided DIMM if (value & 0xF0) sz.side2 += value >> 4; // Asymmetric @@ -496,7 +493,6 @@ static uint8_t spd_get_supported_dimms(const struct mem_controller *ctrl) // since we only support dual-channel. for (i = 0; i < MAX_DIMM_SOCKETS_PER_CHANNEL; i++) { - uint16_t channel0_dimm = ctrl->channel0[i]; uint16_t channel1_dimm = ctrl->channel1[i]; uint8_t bDualChannel = 1; @@ -565,7 +561,6 @@ static uint8_t spd_get_supported_dimms(const struct mem_controller *ctrl) // NOTE: unpopulated DIMMs cause read to fail spd_value = smbus_read_byte(channel1_dimm, SPD_MODULE_ATTRIBUTES); if (!(spd_value & MODULE_REGISTERED) || (spd_value < 0)) { - printk(BIOS_DEBUG, "Skipping un-matched DIMMs - only dual-channel operation supported\n"); continue; } @@ -580,7 +575,6 @@ static uint8_t spd_get_supported_dimms(const struct mem_controller *ctrl) if (!are_spd_values_equal (dual_channel_parameters[j], channel0_dimm, channel1_dimm)) { - bDualChannel = 0; break; } @@ -653,7 +647,6 @@ static void do_ram_command(uint8_t command, uint16_t jedec_mode_bits) * Seems like rows 4-7 overlap with 0-3. */ for (i = 0; i < (MAX_NUM_CHANNELS * MAX_DIMM_SOCKETS_PER_CHANNEL); ++i) { - uint8_t dimm_end_64M_multiple = pci_read_config8(MCHDEV, DRB_ROW_0 + i); if (dimm_end_64M_multiple > dimm_start_64M_multiple) { @@ -800,7 +793,6 @@ static void configure_e7501_ram_addresses(const struct mem_controller pci_write_config32(MCHDEV, DRB_ROW_4, 0); for (i = 0; i < MAX_DIMM_SOCKETS_PER_CHANNEL; i++) { - uint16_t dimm_socket_address = ctrl->channel0[i]; struct dimm_size sz; @@ -1020,7 +1012,6 @@ static void configure_e7501_cas_latency(const struct mem_controller *ctrl, uint32_t dimm_compatible_cas_latencies; for (i = 0; i < MAX_DIMM_SOCKETS; i++) { - uint16_t dimm_socket_address; if (!(dimm_mask & (1 << i))) @@ -1098,7 +1089,6 @@ static void configure_e7501_cas_latency(const struct mem_controller *ctrl, dram_timing |= DRT_CAS_2_0; dram_read_timing |= 0x0222; } else if (system_compatible_cas_latencies & SPD_CAS_LATENCY_2_5) { - uint32_t dram_row_attributes = pci_read_config32(MCHDEV, DRA); @@ -1111,7 +1101,6 @@ static void configure_e7501_cas_latency(const struct mem_controller *ctrl, && (dram_row_attributes & 0xff00) && (dram_row_attributes & 0xff0000) && (dram_row_attributes & 0xff000000)) { - // All slots populated dram_read_timing |= 0x0882; } else { @@ -1179,7 +1168,6 @@ static void configure_e7501_dram_controller_mode(const struct mem_controller *ct */ for (i = 0; i < MAX_DIMM_SOCKETS; i++) { - uint32_t dimm_refresh_mode; int value; uint16_t dimm_socket_address; @@ -1250,7 +1238,6 @@ static void configure_e7501_row_attributes(const struct mem_controller uint32_t row_attributes = 0; for (i = 0; i < MAX_DIMM_SOCKETS_PER_CHANNEL; i++) { - uint16_t dimm_socket_address = ctrl->channel0[i]; struct dimm_size page_size; struct dimm_size sdram_width; @@ -1300,7 +1287,6 @@ static void enable_e7501_clocks(uint8_t dimm_mask) pci_write_config8(MCHDEV, 0x8e, 0xb0); for (i = 0; i < MAX_DIMM_SOCKETS_PER_CHANNEL; i++) { - uint8_t socket_mask = 1 << i; if (dimm_mask & socket_mask) @@ -1702,7 +1688,6 @@ void sdram_initialize(void) /* If this is a warm boot, some initialisation can be skipped */ if (!e7505_mch_is_ready()) { - /* The real MCH initialisation. */ timestamp_add_now(TS_INITRAM_START); |