diff options
Diffstat (limited to 'src/mainboard/supermicro/h8dmr')
-rw-r--r-- | src/mainboard/supermicro/h8dmr/romstage.c | 120 |
1 files changed, 60 insertions, 60 deletions
diff --git a/src/mainboard/supermicro/h8dmr/romstage.c b/src/mainboard/supermicro/h8dmr/romstage.c index b137b6b76e..a7e69bd9b3 100644 --- a/src/mainboard/supermicro/h8dmr/romstage.c +++ b/src/mainboard/supermicro/h8dmr/romstage.c @@ -65,24 +65,24 @@ static inline int spd_read_byte(unsigned device, unsigned address) static void sio_setup(void) { - uint32_t dword; - uint8_t byte; + uint32_t dword; + uint8_t byte; - enable_smbus(); + enable_smbus(); // smbusx_write_byte(1, (0x58 >> 1), 0, 0x80); /* select bank0 */ smbusx_write_byte(1, (0x58 >> 1), 0xb1, 0xff); /* set FAN ctrl to DC mode */ - byte = pci_read_config8(PCI_DEV(0, MCP55_DEVN_BASE+1 , 0), 0x7b); - byte |= 0x20; - pci_write_config8(PCI_DEV(0, MCP55_DEVN_BASE+1 , 0), 0x7b, byte); + byte = pci_read_config8(PCI_DEV(0, MCP55_DEVN_BASE+1 , 0), 0x7b); + byte |= 0x20; + pci_write_config8(PCI_DEV(0, MCP55_DEVN_BASE+1 , 0), 0x7b, byte); - dword = pci_read_config32(PCI_DEV(0, MCP55_DEVN_BASE+1 , 0), 0xa0); - dword |= (1 << 0); - pci_write_config32(PCI_DEV(0, MCP55_DEVN_BASE+1 , 0), 0xa0, dword); + dword = pci_read_config32(PCI_DEV(0, MCP55_DEVN_BASE+1 , 0), 0xa0); + dword |= (1 << 0); + pci_write_config32(PCI_DEV(0, MCP55_DEVN_BASE+1 , 0), 0xa0, dword); - dword = pci_read_config32(PCI_DEV(0, MCP55_DEVN_BASE+1 , 0), 0xa4); - dword |= (1 << 16); - pci_write_config32(PCI_DEV(0, MCP55_DEVN_BASE+1 , 0), 0xa4, dword); + dword = pci_read_config32(PCI_DEV(0, MCP55_DEVN_BASE+1 , 0), 0xa4); + dword |= (1 << 16); + pci_write_config32(PCI_DEV(0, MCP55_DEVN_BASE+1 , 0), 0xa4, dword); } void cache_as_ram_main(unsigned long bist, unsigned long cpu_init_detectedx) @@ -96,90 +96,90 @@ void cache_as_ram_main(unsigned long bist, unsigned long cpu_init_detectedx) DIMM5, DIMM7, 0, 0, }; - struct sys_info *sysinfo = &sysinfo_car; - int needs_reset = 0; - unsigned bsp_apicid = 0; + struct sys_info *sysinfo = &sysinfo_car; + int needs_reset = 0; + unsigned bsp_apicid = 0; - if (!cpu_init_detectedx && boot_cpu()) { + if (!cpu_init_detectedx && boot_cpu()) { /* Nothing special needs to be done to find bus 0 */ /* Allow the HT devices to be found */ enumerate_ht_chain(); sio_setup(); - } + } - if (bist == 0) + if (bist == 0) bsp_apicid = init_cpus(cpu_init_detectedx, sysinfo); w83627hf_set_clksel_48(DUMMY_DEV); winbond_enable_serial(SERIAL_DEV, CONFIG_TTYS0_BASE); - console_init(); + console_init(); /* Halt if there was a built in self test failure */ report_bist_failure(bist); printk(BIOS_DEBUG, "*sysinfo range: [%p,%p]\n",sysinfo,sysinfo+1); - setup_mb_resource_map(); + setup_mb_resource_map(); - printk(BIOS_DEBUG, "bsp_apicid=%02x\n", bsp_apicid); + printk(BIOS_DEBUG, "bsp_apicid=%02x\n", bsp_apicid); - set_sysinfo_in_ram(0); // in BSP so could hold all ap until sysinfo is in ram - setup_coherent_ht_domain(); // routing table and start other core0 + set_sysinfo_in_ram(0); // in BSP so could hold all ap until sysinfo is in ram + setup_coherent_ht_domain(); // routing table and start other core0 - wait_all_core0_started(); + wait_all_core0_started(); #if CONFIG_LOGICAL_CPUS - // It is said that we should start core1 after all core0 launched - /* becase optimize_link_coherent_ht is moved out from setup_coherent_ht_domain, - * So here need to make sure last core0 is started, esp for two way system, - * (there may be apic id conflicts in that case) - */ - start_other_cores(); - wait_all_other_cores_started(bsp_apicid); + // It is said that we should start core1 after all core0 launched + /* becase optimize_link_coherent_ht is moved out from setup_coherent_ht_domain, + * So here need to make sure last core0 is started, esp for two way system, + * (there may be apic id conflicts in that case) + */ + start_other_cores(); + wait_all_other_cores_started(bsp_apicid); #endif - /* it will set up chains and store link pair for optimization later */ - ht_setup_chains_x(sysinfo); // it will init sblnk and sbbusn, nodes, sbdn + /* it will set up chains and store link pair for optimization later */ + ht_setup_chains_x(sysinfo); // it will init sblnk and sbbusn, nodes, sbdn #if CONFIG_SET_FIDVID - { - msr_t msr; - msr = rdmsr(0xc0010042); - printk(BIOS_DEBUG, "begin msr fid, vid %08x, %08x\n", msr.hi, msr.lo); - } - enable_fid_change(); - enable_fid_change_on_sb(sysinfo->sbbusn, sysinfo->sbdn); - init_fidvid_bsp(bsp_apicid); - // show final fid and vid - { - msr_t msr; - msr = rdmsr(0xc0010042); - printk(BIOS_DEBUG, "end msr fid, vid %08x, %08x\n", msr.hi, msr.lo); - } + { + msr_t msr; + msr = rdmsr(0xc0010042); + printk(BIOS_DEBUG, "begin msr fid, vid %08x, %08x\n", msr.hi, msr.lo); + } + enable_fid_change(); + enable_fid_change_on_sb(sysinfo->sbbusn, sysinfo->sbdn); + init_fidvid_bsp(bsp_apicid); + // show final fid and vid + { + msr_t msr; + msr = rdmsr(0xc0010042); + printk(BIOS_DEBUG, "end msr fid, vid %08x, %08x\n", msr.hi, msr.lo); + } #endif init_timer(); // Need to use TMICT to synchronize FID/VID - needs_reset |= optimize_link_coherent_ht(); - needs_reset |= optimize_link_incoherent_ht(sysinfo); - needs_reset |= mcp55_early_setup_x(); + needs_reset |= optimize_link_coherent_ht(); + needs_reset |= optimize_link_incoherent_ht(sysinfo); + needs_reset |= mcp55_early_setup_x(); - // fidvid change will issue one LDTSTOP and the HT change will be effective too - if (needs_reset) { - printk(BIOS_INFO, "ht reset -\n"); - soft_reset(); - } + // fidvid change will issue one LDTSTOP and the HT change will be effective too + if (needs_reset) { + printk(BIOS_INFO, "ht reset -\n"); + soft_reset(); + } - allow_all_aps_stop(bsp_apicid); + allow_all_aps_stop(bsp_apicid); - //It's the time to set ctrl in sysinfo now; + //It's the time to set ctrl in sysinfo now; fill_mem_ctrl(sysinfo->nodes, sysinfo->ctrl, spd_addr); // enable_smbus(); /* enable in sio_setup */ - /* all ap stopped? */ + /* all ap stopped? */ - sdram_initialize(sysinfo->nodes, sysinfo->ctrl, sysinfo); + sdram_initialize(sysinfo->nodes, sysinfo->ctrl, sysinfo); - post_cache_as_ram(); // bsp swtich stack to RAM and copy sysinfo RAM now + post_cache_as_ram(); // bsp swtich stack to RAM and copy sysinfo RAM now } |