diff options
Diffstat (limited to 'src/mainboard/google/gru/mainboard.c')
| -rw-r--r-- | src/mainboard/google/gru/mainboard.c | 44 |
1 files changed, 28 insertions, 16 deletions
diff --git a/src/mainboard/google/gru/mainboard.c b/src/mainboard/google/gru/mainboard.c index fa127edf82..2542d74106 100644 --- a/src/mainboard/google/gru/mainboard.c +++ b/src/mainboard/google/gru/mainboard.c @@ -34,21 +34,21 @@ /* * We have to drive the stronger pull-up within 1 second of powering up the - * touchpad to prevent its firmware from falling into recovery. + * touchpad to prevent its firmware from falling into recovery. Not on Scarlet. */ static void configure_touchpad(void) { - gpio_output(GPIO(3, B, 4), 1); /* TP's I2C pull-up rail */ + gpio_output(GPIO_TP_RST_L, 1); /* TP's I2C pull-up rail */ } /* * Wifi's PDN/RST line is pulled down by its (unpowered) voltage rails, but * this reset pin is pulled up by default. Let's drive it low as early as we - * can. + * can. Scarlet uses a different WiFi chip that doesn't have this pin anymore. */ -static void deassert_wifi_power(void) +static void assert_wifi_reset(void) { - gpio_output(GPIO(1, B, 3), 0); /* Assert WLAN_MODULE_RST# */ + gpio_output(GPIO_WLAN_RST_L, 0); /* Assert WLAN_MODULE_RST# */ } static void configure_emmc(void) @@ -234,11 +234,21 @@ static void configure_codec(void) static void configure_display(void) { - /* set pinmux for edp HPD*/ - gpio_input_pulldown(GPIO(4, C, 7)); - write32(&rk3399_grf->iomux_edp_hotplug, IOMUX_EDP_HOTPLUG); - - gpio_output(GPIO(4, D, 3), 1); /* CPU3_EDP_VDDEN for P3.3V_DISP */ + if (IS_ENABLED(CONFIG_BOARD_GOOGLE_SCARLET)) { + gpio_output(GPIO(4, D, 1), 0); /* DISPLAY_RST_L */ + gpio_output(GPIO(4, D, 3), 1); /* PPVARP_LCD */ + mdelay(10); + gpio_output(GPIO(4, D, 4), 1); /* PPVARN_LCD */ + mdelay(20 + 2); /* add 2ms for bias rise time */ + gpio_output(GPIO(4, D, 1), 1); /* DISPLAY_RST_L */ + mdelay(30); + } else { + /* set pinmux for edp HPD */ + gpio_input_pulldown(GPIO(4, C, 7)); + write32(&rk3399_grf->iomux_edp_hotplug, IOMUX_EDP_HOTPLUG); + + gpio_output(GPIO(4, D, 3), 1); /* P3.3V_DISP */ + } } static void usb_power_cycle(int port) @@ -321,18 +331,20 @@ static void setup_usb(int port) static void mainboard_init(device_t dev) { - deassert_wifi_power(); - configure_touchpad(); configure_sdmmc(); configure_emmc(); configure_codec(); - configure_display(); + if (display_init_required()) + configure_display(); setup_usb(0); - if (!IS_ENABLED(CONFIG_BOARD_GOOGLE_SCARLET)) - setup_usb(1); + if (!IS_ENABLED(CONFIG_BOARD_GOOGLE_SCARLET)) { + assert_wifi_reset(); /* Scarlet: no WIFI_PD# line */ + configure_touchpad(); /* Scarlet: works differently */ + setup_usb(1); /* Scarlet: only one USB port */ + register_gpio_suspend(); /* Scarlet: all EC-controlled */ + } register_reset_to_bl31(); register_poweroff_to_bl31(); - register_gpio_suspend(); register_apio_suspend(); } |