diff options
-rw-r--r-- | src/soc/amd/picasso/chip.h | 3 | ||||
-rw-r--r-- | src/soc/amd/picasso/include/soc/southbridge.h | 7 | ||||
-rw-r--r-- | src/soc/amd/picasso/southbridge.c | 44 |
3 files changed, 54 insertions, 0 deletions
diff --git a/src/soc/amd/picasso/chip.h b/src/soc/amd/picasso/chip.h index b641379605..ac1a12c6b1 100644 --- a/src/soc/amd/picasso/chip.h +++ b/src/soc/amd/picasso/chip.h @@ -154,6 +154,9 @@ struct soc_amd_picasso_config { USB_OC_PIN_5 = 0x5, USB_OC_NONE = 0xf, } usb_port_overcurrent_pin[USB_PORT_COUNT]; + + /* The array index is the general purpose PCIe clock output number. */ + enum gpp_clk_req_setting gpp_clk_config[GPP_CLK_OUTPUT_COUNT]; }; typedef struct soc_amd_picasso_config config_t; diff --git a/src/soc/amd/picasso/include/soc/southbridge.h b/src/soc/amd/picasso/include/soc/southbridge.h index b5792139da..168b2b2e22 100644 --- a/src/soc/amd/picasso/include/soc/southbridge.h +++ b/src/soc/amd/picasso/include/soc/southbridge.h @@ -245,6 +245,13 @@ /* IO 0xf0 NCP Error */ #define NCP_WARM_BOOT BIT(7) /* Write-once */ +/* this is for the devicetree setting and not the values written to the register */ +enum gpp_clk_req_setting { + GPP_CLK_ON, /* GPP clock always on; default */ + GPP_CLK_REQ, /* GPP clock controlled by corresponding #CLK_REQx pin */ + GPP_CLK_OFF, /* GPP clk off */ +}; + typedef struct aoac_devs { unsigned int :7; unsigned int ic2e:1; /* 7: I2C2 */ diff --git a/src/soc/amd/picasso/southbridge.c b/src/soc/amd/picasso/southbridge.c index 2a5f822b8f..9772e9bc31 100644 --- a/src/soc/amd/picasso/southbridge.c +++ b/src/soc/amd/picasso/southbridge.c @@ -307,6 +307,48 @@ static void al2ahb_clock_gate(void) write8((void *)(al2ahb_base + AL2AHB_CONTROL_HCLK_OFFSET), al2ahb_val); } +/* configure the genral purpose PCIe clock outputs according to the devicetree settings */ +static void gpp_clk_setup(void) +{ + const struct soc_amd_picasso_config *cfg = config_of_soc(); + + /* look-up table to be able to iterate over the PCIe clock output settings */ + const uint8_t gpp_clk_shift_lut[GPP_CLK_OUTPUT_COUNT] = { + GPP_CLK0_REQ_SHIFT, + GPP_CLK1_REQ_SHIFT, + GPP_CLK2_REQ_SHIFT, + GPP_CLK3_REQ_SHIFT, + GPP_CLK4_REQ_SHIFT, + GPP_CLK5_REQ_SHIFT, + GPP_CLK6_REQ_SHIFT, + }; + + uint32_t gpp_clk_ctl = misc_read32(GPP_CLK_CNTRL); + + for (int i = 0; i < GPP_CLK_OUTPUT_COUNT; i++) { + gpp_clk_ctl &= ~GPP_CLK_REQ_MASK(gpp_clk_shift_lut[i]); + /* + * The remapping of values is done so that the default of the enum used for the + * devicetree settings is the clock being enabled, so that a missing devicetree + * configuration for this will result in an always active clock and not an + * inactive PCIe clock output. + */ + switch (cfg->gpp_clk_config[i]) { + case GPP_CLK_REQ: + gpp_clk_ctl |= GPP_CLK_REQ_EXT(gpp_clk_shift_lut[i]); + break; + case GPP_CLK_OFF: + gpp_clk_ctl |= GPP_CLK_REQ_OFF(gpp_clk_shift_lut[i]); + break; + case GPP_CLK_ON: + default: + gpp_clk_ctl |= GPP_CLK_REQ_ON(gpp_clk_shift_lut[i]); + } + } + + misc_write32(GPP_CLK_CNTRL, gpp_clk_ctl); +} + void southbridge_init(void *chip_info) { struct chipset_state *state; @@ -322,6 +364,8 @@ void southbridge_init(void *chip_info) acpi_clear_pm_gpe_status(); al2ahb_clock_gate(); + + gpp_clk_setup(); } void southbridge_final(void *chip_info) |