diff options
3 files changed, 4 insertions, 1 deletions
diff --git a/src/mainboard/supermicro/x11-lga1151-series/variants/x11ssh-tf/gpio.c b/src/mainboard/supermicro/x11-lga1151-series/variants/x11ssh-tf/gpio.c index 06d3bd43c3..00faa2e3f6 100644 --- a/src/mainboard/supermicro/x11-lga1151-series/variants/x11ssh-tf/gpio.c +++ b/src/mainboard/supermicro/x11-lga1151-series/variants/x11ssh-tf/gpio.c @@ -50,7 +50,7 @@ static const struct pad_config gpio_table[] = { PAD_NC(GPP_B17, NONE), PAD_NC(GPP_B18, NONE), PAD_NC(GPP_B19, NONE), - PAD_CFG_GPO(GPP_B20, 1, PLTRST), + PAD_CFG_GPO(GPP_B20, 0, PLTRST), /* BMC POST_COMPLETE */ PAD_NC(GPP_B21, NONE), PAD_NC(GPP_B22, NONE), PAD_CFG_NF(GPP_B23, NONE, DEEP, NF2), diff --git a/src/mainboard/supermicro/x11-lga1151-series/variants/x11ssh-tf/gpio_early.c b/src/mainboard/supermicro/x11-lga1151-series/variants/x11ssh-tf/gpio_early.c index 3ea21e0321..e3c5c4d982 100644 --- a/src/mainboard/supermicro/x11-lga1151-series/variants/x11ssh-tf/gpio_early.c +++ b/src/mainboard/supermicro/x11-lga1151-series/variants/x11ssh-tf/gpio_early.c @@ -14,6 +14,7 @@ static const struct pad_config early_gpio_table[] = { PAD_CFG_NF(GPP_A8, NONE, DEEP, NF1), PAD_CFG_NF(GPP_A9, NONE, DEEP, NF1), PAD_CFG_NF(GPP_A10, NONE, DEEP, NF1), + PAD_CFG_GPO(GPP_B20, 0, PLTRST), /* BMC POST_COMPLETE */ }; void mainboard_configure_early_gpios(void) diff --git a/src/mainboard/supermicro/x11-lga1151-series/variants/x11ssh-tf/overridetree.cb b/src/mainboard/supermicro/x11-lga1151-series/variants/x11ssh-tf/overridetree.cb index 093786cbd5..d7f5df8c8b 100644 --- a/src/mainboard/supermicro/x11-lga1151-series/variants/x11ssh-tf/overridetree.cb +++ b/src/mainboard/supermicro/x11-lga1151-series/variants/x11ssh-tf/overridetree.cb @@ -76,6 +76,8 @@ chip soc/intel/skylake end device pci 1f.0 on # LPC Interface chip drivers/ipmi + use pch_gpio as gpio_dev + register "post_complete_gpio" = "GPP_B20" # On cold boot it takes a while for the BMC to start the IPMI service register "wait_for_bmc" = "1" register "bmc_boot_timeout" = "60" |