Since some people disapprove of white space cleanups mixed in regular commits

while others dislike them being extra commits, let's clean them up once and
for all for the existing code. If it's ugly, let it only be ugly once :-)

Signed-off-by: Stefan Reinauer <stepan@coresystems.de>
Acked-by: Stefan Reinauer <stepan@coresystems.de>



git-svn-id: svn://svn.coreboot.org/coreboot/trunk@5507 2b7e53f0-3cfb-0310-b3e9-8179ed1497e1

4 files changed, 12 insertions, 12 deletions

diff --git a/src/mainboard/olpc/rev_a/devicetree.cb b/src/mainboard/olpc/rev_a/devicetree.cb
index e0da82836a..ca55ce1b7e 100644
--- a/src/mainboard/olpc/rev_a/devicetree.cb
+++ b/src/mainboard/olpc/rev_a/devicetree.cb
@@ -6,7 +6,7 @@ chip northbridge/amd/gx2
 			device apic 0 on end
 		end
 	end
-  	device pci_domain 0 on 
+  	device pci_domain 0 on
     		device pci 1.0 on end
 		device pci 1.1 on end
       		chip southbridge/amd/cs5536
@@ -18,7 +18,7 @@ chip northbridge/amd/gx2
 		# SIRQ Mode = continous , It would be better if the EC could operate in
 		# Active(Quiet) mode. Save power....
 		# SIRQ Enable = Enabled
-		# Invert mask = IRQ 12 and 1 are active high. Keyboard and Mouse IRQs. OK 
+		# Invert mask = IRQ 12 and 1 are active high. Keyboard and Mouse IRQs. OK
 			#register "lpc_irq" = "0x00001002"
 			#register "lpc_serirq_enable" = "0xEFFD0080"
 			#register "enable_gpio0_inta" = "1"
diff --git a/src/mainboard/olpc/rev_a/irq_tables.c b/src/mainboard/olpc/rev_a/irq_tables.c
index 598350b4b8..f751b481ca 100644
--- a/src/mainboard/olpc/rev_a/irq_tables.c
+++ b/src/mainboard/olpc/rev_a/irq_tables.c
@@ -1,4 +1,4 @@
-/* This file was generated by getpir.c, do not modify! 
+/* This file was generated by getpir.c, do not modify!
    (but if you do, please run checkpir on it to verify)
  * Contains the IRQ Routing Table dumped directly from your memory, which BIOS sets up
  *
diff --git a/src/mainboard/olpc/rev_a/mainboard.c b/src/mainboard/olpc/rev_a/mainboard.c
index a02e583558..adfb957ab7 100644
--- a/src/mainboard/olpc/rev_a/mainboard.c
+++ b/src/mainboard/olpc/rev_a/mainboard.c
@@ -83,7 +83,7 @@ static void init(struct device *dev) {
 	  * conditional we can make it a config variable later.
 	  */
 
-	printk(BIOS_DEBUG, "%s (%x,%x)SET USB PCI interrupt line to %d\n", 
+	printk(BIOS_DEBUG, "%s (%x,%x)SET USB PCI interrupt line to %d\n",
 		__func__, bus, devfn, usbirq);
 	usb = dev_find_slot(bus, devfn);
 	if (! usb){
diff --git a/src/mainboard/olpc/rev_a/romstage.c b/src/mainboard/olpc/rev_a/romstage.c
index 1503baa6ba..fc605d1a88 100644
--- a/src/mainboard/olpc/rev_a/romstage.c
+++ b/src/mainboard/olpc/rev_a/romstage.c
@@ -50,7 +50,7 @@ static inline unsigned int fls(unsigned int x)
 	Trrd=2 (act2act)
 	Tref=17.8ms
   */
-static void sdram_set_spd_registers(const struct mem_controller *ctrl) 
+static void sdram_set_spd_registers(const struct mem_controller *ctrl)
 {
 	/* Total size of DIMM = 2^row address (byte 3) * 2^col address (byte 4) *
 	 *                      component Banks (byte 17) * module banks, side (byte 5) *
@@ -100,11 +100,11 @@ static void sdram_set_spd_registers(const struct mem_controller *ctrl)
 	/* timing and mode ... */
 
 	msr = rdmsr(0x20000019);
-	
-	/* per standard bios settings */	
+
+	/* per standard bios settings */
 
 	msr.hi = 0x18000108;
-	msr.lo = 
+	msr.lo =
 			(6<<28) |		// cas_lat
 			(10<<24)|		// ref2act
 			(7<<20)|		// act2pre
@@ -114,8 +114,8 @@ static void sdram_set_spd_registers(const struct mem_controller *ctrl)
 			(2<<6)|			// dplwr
 			(2<<4)|			// dplrd
 			(3);			// dal
-	/* the msr value reported by quanta is very, very different. 
-	 * we will go with that value for now. 
+	/* the msr value reported by quanta is very, very different.
+	 * we will go with that value for now.
 	 */
 	msr.lo = 0x286332a3;
 
@@ -180,9 +180,9 @@ static void main(unsigned long bist)
 
 	cpuRegInit();
 	print_err("done cpuRegInit\n");
-	
+
 	sdram_initialize(1, memctrl);
-	
+
 	/* Check all of memory */
 	//ram_check(0x00000000, 640*1024);
 }