## SPDX-License-Identifier: GPL-2.0-only

config SOUTHBRIDGE_INTEL_LYNXPOINT
	bool

if SOUTHBRIDGE_INTEL_LYNXPOINT

config SOUTH_BRIDGE_OPTIONS
	def_bool y
	select ACPI_INTEL_HARDWARE_SLEEP_VALUES
	select ACPI_SOC_NVS
	select AZALIA_PLUGIN_SUPPORT
	select SOUTHBRIDGE_INTEL_COMMON_SMBUS
	select SOUTHBRIDGE_INTEL_COMMON_EARLY_SMBUS
	select SOUTHBRIDGE_INTEL_COMMON_SPI_ICH9
	select SOUTHBRIDGE_INTEL_COMMON_ACPI_MADT
	select SOUTHBRIDGE_INTEL_COMMON_FINALIZE
	select SOUTHBRIDGE_INTEL_COMMON_PMCLIB
	select SOUTHBRIDGE_INTEL_COMMON_PMBASE
	select SOUTHBRIDGE_INTEL_COMMON_RTC
	select SOUTHBRIDGE_INTEL_COMMON_RESET
	select HAVE_SMI_HANDLER
	select HAVE_USBDEBUG_OPTIONS
	select USE_WATCHDOG_ON_BOOT
	select PCIEXP_ASPM
	select PCIEXP_COMMON_CLOCK
	select INTEL_DESCRIPTOR_MODE_CAPABLE
	select HAVE_EM100PRO_SPI_CONSOLE_SUPPORT
	select RTC
	select SOUTHBRIDGE_INTEL_COMMON_GPIO if !INTEL_LYNXPOINT_LP
	select SOUTHBRIDGE_INTEL_COMMON_RCBA_PIRQ
	select HAVE_INTEL_CHIPSET_LOCKDOWN
	select HAVE_POWER_STATE_AFTER_FAILURE
	select HAVE_POWER_STATE_PREVIOUS_AFTER_FAILURE
	select SOUTHBRIDGE_INTEL_COMMON_WATCHDOG
	select SOUTHBRIDGE_INTEL_COMMON_USB_DEBUG

config INTEL_LYNXPOINT_LP
	bool
	default n
	help
	  Set this option to y for LynxPoint LP (Haswell ULT).

config EHCI_BAR
	hex
	default 0xe8000000

config SERIRQ_CONTINUOUS_MODE
	bool
	default n
	help
	  If you set this option to y, the serial IRQ machine will be
	  operated in continuous mode.

config HPET_MIN_TICKS
	hex
	default 0x80

config FINALIZE_USB_ROUTE_XHCI
	bool "Route all ports to XHCI controller in finalize step"
	default y
	help
	  If you set this option to y, the USB ports will be routed
	  to the XHCI controller during the finalize SMM callback.

config PCIEXP_AER
	bool
	default y

config PCIEXP_CLK_PM
	default y

config PCIEXP_L1_SUB_STATE
	default y

config SERIALIO_UART_CONSOLE
	bool "Use SerialIO UART for console"
	depends on INTEL_LYNXPOINT_LP
	select DRIVERS_UART_8250MEM_32
	help
	  Selected by mainboards where SerialIO UARTs can be used to retrieve
	  coreboot logs. Boards also need to set UART_FOR_CONSOLE accordingly.

config CONSOLE_UART_BASE_ADDRESS
	default 0xd6000000 if SERIALIO_UART_CONSOLE

endif