/* SPDX-License-Identifier: GPL-2.0-only */ #include #include #include #include #include #include #include #include "chip.h" #include "i82801gx.h" void i82801gx_lpc_setup(void) { const pci_devfn_t d31f0 = PCI_DEV(0, 0x1f, 0); const struct device *dev = pcidev_on_root(0x1f, 0); const struct southbridge_intel_i82801gx_config *config; /* Configure serial IRQs.*/ pci_write_config8(d31f0, SERIRQ_CNTL, 0xd0); /* * Enable some common LPC IO ranges: * - 0x2e/0x2f, 0x4e/0x4f often SuperIO * - 0x60/0x64, 0x62/0x66 often KBC/EC * - 0x3f0-0x3f5/0x3f7 FDD * - 0x378-0x37f and 0x778-0x77f LPT * - 0x2f8-0x2ff COMB * - 0x3f8-0x3ff COMA * - 0x208-0x20f GAMEH * - 0x200-0x207 GAMEL */ pci_write_config16(d31f0, LPC_IO_DEC, 0x0010); pci_write_config16(d31f0, LPC_EN, CNF2_LPC_EN | CNF1_LPC_EN | MC_LPC_EN | KBC_LPC_EN | GAMEH_LPC_EN | GAMEL_LPC_EN | FDD_LPC_EN | LPT_LPC_EN | COMB_LPC_EN | COMA_LPC_EN); /* Set up generic decode ranges */ if (!dev || !dev->chip_info) return; config = dev->chip_info; pci_write_config32(d31f0, GEN1_DEC, config->gen1_dec); pci_write_config32(d31f0, GEN2_DEC, config->gen2_dec); pci_write_config32(d31f0, GEN3_DEC, config->gen3_dec); pci_write_config32(d31f0, GEN4_DEC, config->gen4_dec); } void i82801gx_setup_bars(void) { const pci_devfn_t d31f0 = PCI_DEV(0, 0x1f, 0); pci_write_config32(d31f0, RCBA, CONFIG_FIXED_RCBA_MMIO_BASE | 1); pci_write_config32(d31f0, PMBASE, DEFAULT_PMBASE | 1); pci_write_config8(d31f0, ACPI_CNTL, ACPI_EN); pci_write_config32(d31f0, GPIOBASE, DEFAULT_GPIOBASE | 1); pci_write_config8(d31f0, GPIO_CNTL, GPIO_EN); } #if ENV_RAMINIT void i82801gx_early_init(void) { enable_smbus(); printk(BIOS_DEBUG, "Setting up static southbridge registers..."); i82801gx_setup_bars(); setup_pch_gpios(&mainboard_gpio_map); printk(BIOS_DEBUG, " done.\n"); printk(BIOS_DEBUG, "Disabling Watchdog reboot..."); RCBA32(GCS) = RCBA32(GCS) | (1 << 5); /* No reset */ write_pmbase16(PMBASE_TCO_OFFSET + TCO1_CNT, TCO_TMR_HLT); write_pmbase16(PMBASE_TCO_OFFSET + TCO1_STS, TCO1_TIMEOUT); write_pmbase16(PMBASE_TCO_OFFSET + TCO2_STS, SECOND_TO_STS); printk(BIOS_DEBUG, " done.\n"); /* program secondary mlt XXX byte? */ pci_write_config8(PCI_DEV(0, 0x1e, 0), SMLT, 0x20); /* reset rtc power status */ pci_and_config8(PCI_DEV(0, 0x1f, 0), GEN_PMCON_3, ~RTC_BATTERY_DEAD); /* USB transient disconnect */ pci_or_config8(PCI_DEV(0, 0x1f, 0), 0xad, 3 << 0); pci_or_config32(PCI_DEV(0, 0x1d, 7), 0xfc, (1 << 29) | (1 << 17)); pci_or_config32(PCI_DEV(0, 0x1d, 7), 0xdc, (1 << 31) | (1 << 27)); /* Enable IOAPIC */ RCBA8(OIC) = 0x03; RCBA8(OIC); /* A lot of CIR bits relate DMI setup which is likely not correctly done for x4x. The issue is also present on ICH10. */ if (!CONFIG(NORTHBRIDGE_INTEL_X4X)) ich7_setup_cir(); } #endif