config SOC_INTEL_COMMON_BLOCK_PMC depends on SOC_INTEL_COMMON_BLOCK_GPIO depends on ACPI_INTEL_HARDWARE_SLEEP_VALUES bool select HAVE_POWER_STATE_AFTER_FAILURE select HAVE_POWER_STATE_PREVIOUS_AFTER_FAILURE help Intel Processor common code for Power Management controller(PMC) subsystem if SOC_INTEL_COMMON_BLOCK_PMC config POWER_STATE_DEFAULT_ON_AFTER_FAILURE default y config SOC_INTEL_COMMON_BLOCK_PMC_DISCOVERABLE bool help Select this on platforms where the PMC device is discoverable when scanning busses. config SOC_INTEL_COMMON_BLOCK_PMC_EPOC bool help Enable this for PMC devices to perform EPOC (CPU Early Power-on Configuration) related functions. endif # SOC_INTEL_COMMON_BLOCK_PMC config PMC_INVALID_READ_AFTER_WRITE bool default n help Enable this for PMC devices where a read back of ACPI BAR and IO access bit does not return the previously written value. config PMC_IPC_ACPI_INTERFACE bool default n depends on HAVE_ACPI_TABLES help Enable this to have the PMC IPC mailbox ACPI interface added to the SSDT for use by other drivers. config PMC_GLOBAL_RESET_ENABLE_LOCK bool help Enable this for PMC devices where the reset configuration and lock register is located under PMC BASE at offset ETR. Note that the reset register is still at 0xCF9 this only controls the enable and lock feature. config PMC_LOW_POWER_MODE_PROGRAM bool help Enable this for PMC devices to perform registers programming to ensure low power in active idle scenario. config PM_ACPI_TIMER_OPTIONAL bool default n help This needs to be selected by SoCs, where the hardware PM Timer can be disabled, to show the ACPI PM Timer Kconfig in menuconfig. if PM_ACPI_TIMER_OPTIONAL config USE_PM_ACPI_TIMER bool "Enable ACPI PM timer" default y help This should be disabled for devices running on battery since it can draw much power. Further, it must be disabled, if S0ix is enabled. Disabling this option also stops the hardware TCO timer and makes the TCO watchdog unavailable. endif # PM_ACPI_TIMER_OPTIONAL