/* * SMM utilities used in both SMM and normal mode * * Copyright (C) 2014 Alexandru Gagniuc * Subject to the GNU GPL v2, or (at your option) any later version. */ #include #include #include void configure_smi(uint8_t smi_num, uint8_t mode) { uint8_t reg32_offset, bit_offset; uint32_t reg32; if (smi_num >= NUMBER_SMITYPES) { printk(BIOS_WARNING, "BUG: Invalid SMI: %u\n", smi_num); return; } /* 16 sources per register, 2 bits per source; registers are 4 bytes */ reg32_offset = (smi_num / 16) * 4; bit_offset = (smi_num % 16) * 2; reg32 = smi_read32(SMI_REG_CONTROL0 + reg32_offset); reg32 &= ~(0x3 << (bit_offset)); reg32 |= (mode & 0x3) << bit_offset; smi_write32(SMI_REG_CONTROL0 + reg32_offset, reg32); } /** * Configure generation of interrupts for given GEVENT pin * * @param gevent The GEVENT pin number. Valid values are 0 thru 23 * @param mode The type of event this pin should generate. Note that only * SMI_MODE_SMI generates an SMI. SMI_MODE_DISABLE disables events. * @param level SMI_LVL_LOW or SMI_LVL_HIGH */ void configure_gevent_smi(uint8_t gevent, uint8_t mode, uint8_t level) { uint32_t reg32; /* GEVENT pins range from [0:23] */ if (gevent > 23) { printk(BIOS_WARNING, "BUG: Invalid GEVENT: %u\n", gevent); return; } /* SMI0 source is GEVENT0 and so on */ configure_smi(gevent, mode); /* And set set the trigger level */ reg32 = smi_read32(SMI_REG_SMITRIG0); reg32 &= ~(1 << gevent); reg32 |= (level & 0x1) << gevent; smi_write32(SMI_REG_SMITRIG0, reg32); } /** Disable events from given GEVENT pin */ void disable_gevent_smi(uint8_t gevent) { /* GEVENT pins range from [0:23] */ if (gevent > 23) { printk(BIOS_WARNING, "BUG: Invalid GEVENT: %u\n", gevent); return; } /* SMI0 source is GEVENT0 and so on */ configure_smi(gevent, SMI_MODE_DISABLE); } uint16_t pm_acpi_smi_cmd_port(void) { return pm_read16(PM_ACPI_SMI_CMD); }