/* SPDX-License-Identifier: GPL-2.0-only */ #include #include #include #include #include #include #include #include #include #include #include #include #include "chip.h" /* This table is for the initial conversion of all SCL pins to input with no pull. */ static const struct soc_i2c_scl_pin i2c_scl_pins[] = { { PAD_GPI(I2C2_SCL_PIN, PULL_NONE), GPIO_I2C2_SCL }, { PAD_GPI(I2C3_SCL_PIN, PULL_NONE), GPIO_I2C3_SCL }, /* I2C4 is a peripheral device only */ }; static void lpc_configure_decodes(void) { if (CONFIG(POST_IO) && (CONFIG_POST_IO_PORT == 0x80)) lpc_enable_port80(); } static void reset_i2c_peripherals(void) { const struct soc_amd_picasso_config *cfg = config_of_soc(); struct soc_i2c_peripheral_reset_info reset_info; reset_info.i2c_scl_reset_mask = cfg->i2c_scl_reset & GPIO_I2C_MASK; reset_info.i2c_scl = i2c_scl_pins; reset_info.num_pins = ARRAY_SIZE(i2c_scl_pins); sb_reset_i2c_peripherals(&reset_info); } /* Before console init */ void fch_pre_init(void) { lpc_early_init(); if (!CONFIG(SOC_AMD_COMMON_BLOCK_USE_ESPI)) lpc_configure_decodes(); fch_spi_early_init(); enable_acpimmio_decode_pm04(); fch_smbus_init(); fch_enable_cf9_io(); fch_enable_legacy_io(); enable_aoac_devices(); reset_i2c_peripherals(); /* * On reset Range_0 defaults to enabled. We want to start with a clean * slate to not have things unexpectedly enabled. */ clear_uart_legacy_config(); if (CONFIG(AMD_SOC_CONSOLE_UART)) set_uart_config(CONFIG_UART_FOR_CONSOLE); /* disable the keyboard reset function before mainboard GPIO setup */ if (CONFIG(DISABLE_KEYBOARD_RESET_PIN)) fch_disable_kb_rst(); } /* After console init */ void fch_early_init(void) { pm_set_power_failure_state(); fch_print_pmxc0_status(); i2c_soc_early_init(); show_spi_speeds_and_modes(); if (CONFIG(DISABLE_SPI_FLASH_ROM_SHARING)) lpc_disable_spi_rom_sharing(); if (CONFIG(SOC_AMD_COMMON_BLOCK_USE_ESPI)) espi_setup(); }