chip northbridge/intel/sandybridge # IGD Displays register "gfx.ndid" = "3" register "gfx.did" = "{ 0x80000100, 0x80000240, 0x80000410 }" # Enable DisplayPort Hotplug with 6ms pulse register "gpu_dp_d_hotplug" = "0x06" register "gpu_dp_b_hotplug" = "0" register "gpu_dp_c_hotplug" = "0" # Enable Panel as LVDS and configure power delays register "gpu_panel_port_select" = "0" # LVDS register "gpu_panel_power_cycle_delay" = "6" # T7: 500ms register "gpu_panel_power_up_delay" = "100" # T1+T2: 10ms register "gpu_panel_power_down_delay" = "100" # T5+T6: 10ms register "gpu_panel_power_backlight_off_delay" = "2000" # T4: 200ms register "gpu_panel_power_backlight_on_delay" = "2000" # T3: 200ms register "gfx.use_spread_spectrum_clock" = "1" register "gfx.link_frequency_270_mhz" = "1" register "gpu_cpu_backlight" = "0x1155" register "gpu_pch_backlight" = "0x11551155" device cpu_cluster 0x0 on chip cpu/intel/socket_rPGA989 device lapic 0x0 on end end chip cpu/intel/model_206ax # FIXME: check all registers register "c1_acpower" = "1" register "c1_battery" = "1" register "c2_acpower" = "3" register "c2_battery" = "3" register "c3_acpower" = "5" register "c3_battery" = "5" device lapic 0xacac off end end end register "pci_mmio_size" = "2048" device domain 0x0 on chip southbridge/intel/bd82x6x # Intel Series 6 Cougar Point PCH # GPI routing # 0 No effect (default) # 1 SMI# (if corresponding ALT_GPI_SMI_EN bit is also set) # 2 SCI (if corresponding GPIO_EN bit is also set) register "alt_gp_smi_en" = "0x0000" register "gpi1_routing" = "2" register "gpi13_routing" = "2" register "c2_latency" = "0x0065" register "docking_supported" = "1" register "gen1_dec" = "0x007c1601" register "gen2_dec" = "0x000c15e1" register "gen4_dec" = "0x000c06a1" register "p_cnt_throttling_supported" = "1" register "pcie_hotplug_map" = "{ 0, 0, 1, 0, 0, 0, 0, 0 }" register "pcie_port_coalesce" = "1" register "sata_interface_speed_support" = "0x3" register "sata_port_map" = "0x3f" register "spi_uvscc" = "0x2005" register "spi_lvscc" = "0x2005" register "superspeed_capable_ports" = "0x0000000f" register "xhci_overcurrent_mapping" = "0x04000201" register "xhci_switchable_ports" = "0x0000000f" device pci 14.0 on # USB 3.0 Controller subsystemid 0x17aa 0x21f6 end device pci 16.0 on # Management Engine Interface 1 subsystemid 0x17aa 0x21f6 end device pci 16.1 off # Management Engine Interface 2 end device pci 16.2 off # Management Engine IDE-R end device pci 16.3 on # Management Engine KT subsystemid 0x17aa 0x21f6 end device pci 19.0 on # Intel Gigabit Ethernet subsystemid 0x17aa 0x21f3 end device pci 1a.0 on # USB2 EHCI #2 subsystemid 0x17aa 0x21f6 end device pci 1b.0 on # High Definition Audio Audio controller subsystemid 0x17aa 0x21f6 end device pci 1c.0 on # PCIe Port #1 subsystemid 0x17aa 0x21f6 chip drivers/ricoh/rce822 # Ricoh cardreader register "disable_mask" = "0x83" register "sdwppol" = "1" device pci 00.0 on # Ricoh SD card reader subsystemid 0x17aa 0x21f6 end end end device pci 1c.1 on # PCIe Port #2 subsystemid 0x17aa 0x21f6 end device pci 1c.2 on # PCIe Port #3 subsystemid 0x17aa 0x21f6 end device pci 1c.3 off # PCIe Port #4 end device pci 1c.4 off # PCIe Port #5 end device pci 1c.5 off # PCIe Port #6 end device pci 1c.6 off # PCIe Port #7 end device pci 1c.7 off # PCIe Port #8 end device pci 1d.0 on # USB2 EHCI #1 subsystemid 0x17aa 0x21f6 end device pci 1e.0 off # PCI bridge end device pci 1f.0 on # LPC bridge PCI-LPC bridge subsystemid 0x17aa 0x21f6 chip ec/lenovo/pmh7 register "backlight_enable" = "0x01" register "dock_event_enable" = "0x01" device pnp ff.1 on # dummy end end chip drivers/pc80/tpm device pnp 0c31.0 on end end chip ec/lenovo/h8 register "beepmask0" = "0x00" register "beepmask1" = "0x86" register "config0" = "0xa7" register "config1" = "0x01" register "config2" = "0xa0" register "config3" = "0xe2" register "event2_enable" = "0xff" register "event3_enable" = "0xff" register "event4_enable" = "0xd0" register "event5_enable" = "0xfc" register "event6_enable" = "0x00" register "event7_enable" = "0x01" register "event8_enable" = "0x7b" register "event9_enable" = "0xff" register "eventa_enable" = "0x01" register "eventb_enable" = "0x00" register "eventc_enable" = "0xff" register "eventd_enable" = "0xff" register "evente_enable" = "0x0d" register "has_keyboard_backlight" = "1" register "has_power_management_beeps" = "0" register "has_bdc_detection" = "1" register "bdc_gpio_num" = "54" register "bdc_gpio_lvl" = "0" device pnp ff.2 on # dummy io 0x60 = 0x62 io 0x62 = 0x66 io 0x64 = 0x1600 io 0x66 = 0x1604 end end chip drivers/lenovo/hybrid_graphics device pnp ff.f on end # dummy register "detect_gpio" = "21" register "has_panel_hybrid_gpio" = "1" register "panel_hybrid_gpio" = "52" register "panel_integrated_lvl" = "1" register "has_backlight_gpio" = "0" register "has_dgpu_power_gpio" = "0" register "has_thinker1" = "0" end end device pci 1f.2 on # SATA Controller 1 subsystemid 0x17aa 0x21f6 end device pci 1f.3 on # SMBus subsystemid 0x17aa 0x21f6 chip drivers/i2c/at24rf08c # eeprom, 8 virtual devices, same chip device i2c 54 on end device i2c 55 on end device i2c 56 on end device i2c 57 on end device i2c 5c on end device i2c 5d on end device i2c 5e on end device i2c 5f on end end end device pci 1f.5 off # SATA Controller 2 end device pci 1f.6 off # Thermal end end device pci 00.0 on # Host bridge Host bridge subsystemid 0x17aa 0x21f6 end device pci 01.0 on # PCIe Bridge for discrete graphics subsystemid 0x17aa 0x21f6 end device pci 02.0 on # Internal graphics VGA controller subsystemid 0x17aa 0x21f5 end end end