chip northbridge/intel/sandybridge register "gfx" = "GMA_STATIC_DISPLAYS(1)" # Enable DisplayPort Hotplug with 6ms pulse register "gpu_dp_d_hotplug" = "0x06" # Enable Panel as LVDS and configure power delays register "gpu_panel_port_select" = "PANEL_PORT_LVDS" register "gpu_panel_power_cycle_delay" = "6" # T7: 500ms register "gpu_panel_power_up_delay" = "100" # T1+T2: 10ms register "gpu_panel_power_down_delay" = "100" # T5+T6: 10ms register "gpu_panel_power_backlight_on_delay" = "2100" # T3: 210ms register "gpu_panel_power_backlight_off_delay" = "2100" # T4: 210ms register "gpu_cpu_backlight" = "0x1155" register "gpu_pch_backlight" = "0x11551155" device cpu_cluster 0x0 on chip cpu/intel/model_206ax # FIXME: check all registers register "c1_acpower" = "1" register "c2_acpower" = "3" register "c3_acpower" = "5" device lapic 0x0 on end device lapic 0xacac off end end end device domain 0x0 on subsystemid 0x17aa 0x21f3 inherit chip southbridge/intel/bd82x6x # Intel Series 6 Cougar Point PCH register "c2_latency" = "0x0065" register "docking_supported" = "1" register "gen1_dec" = "0x000c15e1" register "gen2_dec" = "0x007c1601" register "gen3_dec" = "0x000c06a1" register "gpi13_routing" = "2" register "gpi1_routing" = "2" register "pcie_hotplug_map" = "{ 0, 0, 1, 0, 0, 0, 0, 0 }" register "pcie_port_coalesce" = "1" register "sata_interface_speed_support" = "0x3" register "sata_port_map" = "0x17" register "superspeed_capable_ports" = "0x0000000f" register "xhci_overcurrent_mapping" = "0x04000201" register "xhci_switchable_ports" = "0x0000000f" # device specific SPI configuration register "spi_uvscc" = "0x2005" register "spi_lvscc" = "0x2005" device pci 14.0 on end # USB 3.0 Controller device pci 16.0 on end # Management Engine Interface 1 device pci 16.1 off end # Management Engine Interface 2 device pci 16.2 off end # Management Engine IDE-R device pci 16.3 off end # Management Engine KT device pci 19.0 on end # Intel Gigabit Ethernet device pci 1a.0 on end # USB2 EHCI #2 device pci 1b.0 on end # High Definition Audio Audio controller device pci 1c.0 on # PCIe Port #1 chip drivers/ricoh/rce822 # Ricoh cardreader register "disable_mask" = "0x87" register "sdwppol" = "1" device pci 00.0 on end # Ricoh SD card reader end end device pci 1c.1 on end # PCIe Port #2 device pci 1c.2 on # PCIe Port #3 smbios_slot_desc "7" "3" "ExpressCard Slot" "8" end device pci 1c.3 off end # PCIe Port #4 device pci 1c.4 off end # PCIe Port #5 device pci 1c.5 off end # PCIe Port #6 device pci 1c.6 off end # PCIe Port #7 device pci 1c.7 off end # PCIe Port #8 device pci 1d.0 on end # USB2 EHCI #1 device pci 1e.0 off end # PCI bridge device pci 1f.0 on # LPC bridge PCI-LPC bridge chip ec/lenovo/pmh7 register "backlight_enable" = "0x01" register "dock_event_enable" = "0x01" device pnp ff.1 on end # dummy end chip ec/lenovo/h8 device pnp ff.2 on # dummy io 0x60 = 0x62 io 0x62 = 0x66 io 0x64 = 0x1600 io 0x66 = 0x1604 end register "config0" = "0xa7" register "config1" = "0x01" register "config2" = "0xa0" register "config3" = "0xe2" register "has_keyboard_backlight" = "0" register "beepmask0" = "0x02" register "beepmask1" = "0x86" register "has_power_management_beeps" = "1" register "event2_enable" = "0xff" register "event3_enable" = "0xff" register "event4_enable" = "0xf0" register "event5_enable" = "0x3c" register "event6_enable" = "0x00" register "event7_enable" = "0xa1" register "event8_enable" = "0x7b" register "event9_enable" = "0xff" register "eventa_enable" = "0x00" register "eventb_enable" = "0x00" register "eventc_enable" = "0xff" register "eventd_enable" = "0xff" register "evente_enable" = "0x0d" register "has_bdc_detection" = "1" register "bdc_gpio_num" = "54" register "bdc_gpio_lvl" = "0" register "has_wwan_detection" = "1" register "wwan_gpio_num" = "70" register "wwan_gpio_lvl" = "0" end chip drivers/lenovo/hybrid_graphics device pnp ff.f on end # dummy register "detect_gpio" = "21" register "has_panel_hybrid_gpio" = "1" register "panel_hybrid_gpio" = "52" register "panel_integrated_lvl" = "1" register "has_backlight_gpio" = "0" register "has_dgpu_power_gpio" = "0" register "has_thinker1" = "1" end chip drivers/pc80/tpm device pnp 0c31.0 on end end end device pci 1f.2 on end # SATA Controller 1 device pci 1f.3 on # SMBus chip drivers/i2c/at24rf08c # eeprom, 8 virtual devices, same chip device i2c 54 on end device i2c 55 on end device i2c 56 on end device i2c 57 on end device i2c 5c on end device i2c 5d on end device i2c 5e on end device i2c 5f on end end end device pci 1f.5 off end # SATA Controller 2 device pci 1f.6 off end # Thermal end device pci 00.0 on end # Host bridge Host bridge device pci 01.0 on end # PCIe Bridge for discrete graphics device pci 02.0 on end # Internal graphics VGA controller device pci 04.0 off end # Signal processing controller end end