/* SPDX-License-Identifier: GPL-2.0-only */ #include <device/mmio.h> #include <assert.h> #include <bootblock_common.h> #include <delay.h> #include <soc/clock.h> #include <soc/i2c.h> #include <soc/grf.h> #include <soc/pmu.h> #include <soc/rk808.h> #include <soc/spi.h> #include <vendorcode/google/chromeos/chromeos.h> #include "board.h" void bootblock_mainboard_early_init(void) { if (CONFIG(CONSOLE_SERIAL)) { assert(CONFIG_CONSOLE_SERIAL_UART_ADDRESS == UART2_BASE); write32(&rk3288_grf->iomux_uart2, IOMUX_UART2); } } void bootblock_mainboard_init(void) { if (rkclk_was_watchdog_reset()) reboot_from_watchdog(); /* Up VDD_CPU (BUCK1) to 1.4V to support max CPU frequency (1.8GHz). */ setbits32(&rk3288_pmu->iomux_i2c0scl, IOMUX_I2C0SCL); setbits32(&rk3288_pmu->iomux_i2c0sda, IOMUX_I2C0SDA); assert(CONFIG_PMIC_BUS == 0); /* must correspond with IOMUX */ i2c_init(CONFIG_PMIC_BUS, 400*KHz); /* Slowly raise to max CPU voltage to prevent overshoot */ rk808_configure_buck(1, 1200); udelay(175);/* Must wait for voltage to stabilize,2mV/us */ rk808_configure_buck(1, 1400); udelay(100);/* Must wait for voltage to stabilize,2mV/us */ rkclk_configure_cpu(APLL_1800_MHZ); /* i2c1 for tpm */ write32(&rk3288_grf->iomux_i2c1, IOMUX_I2C1); i2c_init(1, 400*KHz); /* spi2 for firmware ROM */ write32(&rk3288_grf->iomux_spi2csclk, IOMUX_SPI2_CSCLK); write32(&rk3288_grf->iomux_spi2txrx, IOMUX_SPI2_TXRX); rockchip_spi_init(CONFIG_BOOT_DEVICE_SPI_FLASH_BUS, 24750*KHz); /* spi0 for chrome ec */ write32(&rk3288_grf->iomux_spi0, IOMUX_SPI0); rockchip_spi_init(CONFIG_EC_GOOGLE_CHROMEEC_SPI_BUS, 8250*KHz); setup_chromeos_gpios(); }