/* SPDX-License-Identifier: GPL-2.0-only */ #define __SIMPLE_DEVICE__ #include #include #include #include #include #include #include #include "q35.h" static uint32_t encode_pciexbar_length(void) { switch (CONFIG_ECAM_MMCONF_BUS_NUMBER) { case 256: return 0 << 1; case 128: return 1 << 1; case 64: return 2 << 1; default: return dead_code_t(uint32_t); } } uint32_t make_pciexbar(void) { return CONFIG_ECAM_MMCONF_BASE_ADDRESS | encode_pciexbar_length() | 1; } /* Check that MCFG is active. If it's not, QEMU was started for machine PC */ void mainboard_machine_check(void) { if (pci_read_config32(HOST_BRIDGE, D0F0_PCIEXBAR_LO) != make_pciexbar()) die("You must run qemu for machine Q35 (-M q35)"); } /* QEMU-specific register */ #define EXT_TSEG_MBYTES 0x50 #define SMRAMC 0x9d #define C_BASE_SEG ((0 << 2) | (1 << 1) | (0 << 0)) #define G_SMRAME (1 << 3) #define D_LCK (1 << 4) #define D_CLS (1 << 5) #define D_OPEN (1 << 6) #define ESMRAMC 0x9e #define T_EN (1 << 0) #define TSEG_SZ_MASK (3 << 1) #define H_SMRAME (1 << 7) /* Decodes TSEG region size to bytes. */ static size_t decode_tseg_size(u8 esmramc) { /* If we intent to enable TSEG, fake it always enabled. */ if (CONFIG(SMM_TSEG)) esmramc |= T_EN; if (!(esmramc & T_EN)) return 0; switch ((esmramc & TSEG_SZ_MASK) >> 1) { case 0: return 1 * MiB; case 1: return 2 * MiB; case 2: return 8 * MiB; default: return pci_read_config16(HOST_BRIDGE, EXT_TSEG_MBYTES) * MiB; } } void smm_region(uintptr_t *start, size_t *size) { uint8_t esmramc = pci_read_config8(HOST_BRIDGE, ESMRAMC); *size = decode_tseg_size(esmramc); *start = qemu_get_memory_size() * KiB - *size; printk(BIOS_SPEW, "SMM_BASE: 0x%08lx, SMM_SIZE: %zu MiB\n", *start, *size / MiB); } void smm_open(void) { /* Set D_OPEN */ if (CONFIG(SMM_ASEG)) pci_write_config8(HOST_BRIDGE, SMRAMC, D_OPEN | G_SMRAME | C_BASE_SEG); if (CONFIG(SMM_TSEG)) pci_and_config8(HOST_BRIDGE, ESMRAMC, ~T_EN); } void smm_close(void) { /* Clear D_OPEN */ if (CONFIG(SMM_ASEG)) pci_write_config8(HOST_BRIDGE, SMRAMC, G_SMRAME | C_BASE_SEG); if (CONFIG(SMM_TSEG)) pci_or_config8(HOST_BRIDGE, ESMRAMC, T_EN); } void smm_lock(void) { /* * LOCK the SMM memory window and enable normal SMM. * After running this function, only a full reset can * make the SMM registers writable again. */ printk(BIOS_DEBUG, "Locking SMM.\n"); pci_write_config8(HOST_BRIDGE, SMRAMC, D_LCK | G_SMRAME | C_BASE_SEG); }