From b142a5154280c00a3e4bc9d162b31bfe4b665f60 Mon Sep 17 00:00:00 2001 From: Gerd Hoffmann Date: Tue, 17 Sep 2013 09:49:02 +0200 Subject: qemu: q35: avoid address conflict Qemu has the fw_cfg interface at 0x510, which conflicts with power management base address in coreboot. Move the pmbase to a non-conflicting address. No need to worry about speedstep, it is not supported by qemu and isn't enabled in the qemu config. Change-Id: I3e87d8301988028ca0ea7d96c08b4e26ac15a7c2 Signed-off-by: Gerd Hoffmann Reviewed-on: http://review.coreboot.org/3938 Tested-by: build bot (Jenkins) Reviewed-by: Ronald G. Minnich --- src/southbridge/intel/i82801ix/i82801ix.h | 11 ++++++++++- 1 file changed, 10 insertions(+), 1 deletion(-) (limited to 'src/southbridge') diff --git a/src/southbridge/intel/i82801ix/i82801ix.h b/src/southbridge/intel/i82801ix/i82801ix.h index ca28107313..d84af3abe7 100644 --- a/src/southbridge/intel/i82801ix/i82801ix.h +++ b/src/southbridge/intel/i82801ix/i82801ix.h @@ -29,7 +29,16 @@ #define DEFAULT_TBAR 0xfed1b000 #define DEFAULT_RCBA 0xfed1c000 -#define DEFAULT_PMBASE 0x00000500 /* Speedstep code has this hardcoded, too. */ +#ifdef CONFIG_BOARD_EMULATION_QEMU_X86_Q35 +/* + * Qemu has the fw_cfg interface at 0x510. Move the pmbase to a + * non-conflicting address. No need to worry about speedstep, it + * is not supported by qemu and isn't enabled in the qemu config. + */ +# define DEFAULT_PMBASE 0x00000600 +#else +# define DEFAULT_PMBASE 0x00000500 /* Speedstep code has this hardcoded, too. */ +#endif #define DEFAULT_TCOBASE (DEFAULT_PMBASE + 0x60) #define DEFAULT_GPIOBASE 0x00000580 -- cgit v1.2.3